KitchenAid KUDC10IXBL Support Question
KitchenAid KUDC10IXBL Support Question
Find answers below for this question about KitchenAid KUDC10IXBL.Need a KitchenAid KUDC10IXBL manual? We have 5 online manuals for this item!
Question posted by Dylan84993 on September 2nd, 2014
My Kudc10ixbl Dishwasher Won't Start
This unit is fairly new, any ideas on why it won't start?
Current Answers
Answer #1: Posted by BusterDoogen on September 2nd, 2014 12:19 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Go here for the most likely reason for the failure.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related KitchenAid KUDC10IXBL Manual Pages
Dimension Guide - Page 1
... a 90° elbow with the air gap installation instructions. Use a UL Listed or CSA Approved conduit connector. If connecting dishwasher with your home and local codes and ordinances. Drain Requirements: A new drain hose is recommended.
Power supply cord must plug into a grounded three-prong outlet, located in accordance with ³⁄₄...
Dimension Guide - Page 2
... improve
Dimensions are for planning purposes only. D.
Because Whirlpool Corporation policy includes a continuous commitment to 33⁷⁄₈" (86 cm) by removing wheels from dishwasher, or 33³⁄₄" (85.7 cm) by removing wheels AND perforated section in the insulation blanket. Instructions packed with product.
Installation Guide - Page 2
... 6 Water Supply Requirements 6 Electrical Requirements 6
INSTALLATION INSTRUCTIONS 7 Prepare Cabinet Opening-Existing Utilities 7 Prepare Cabinet Opening-New Utilities 7 Prepare and Route Water Line 8 Install Drain Hose 9 Install Moisture Barrier (under a wood countertop 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12
Determine Cabinet Opening 14 Install Door Handle (on...
Installation Guide - Page 3
...Parts supplied:
Parts needed:
Parts needed :
Supplied in Kit: (4) Plastic studs (attached to 16-gauge wiring in dishwasher. Read and follow the instructions provided with any tools listed here. All Installations Tools needed :
Make sure all these... section. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the recommended tools and parts before starting installation. Check local codes.
Installation Guide - Page 4
..., electricity and drain.
■ convenient access for installing underneath the countertop. Helpful Tip: Be sure to level dishwasher. NOTE: To avoid shifting during dishwasher operation, shims must be subject to floor.
■ level floor. If dishwasher will be left unused for proper operation and appearance.
■ cabinet front perpendicular to freezing, have it...
Installation Guide - Page 6
.../IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher.
■ Make sure to connect drain hose to the waste tee or disposer inlet. Drain Requirements
■ A new drain hose is supplied with rubber washer (Part Number W10273460). ■ Do not solder within 6" (15...
Installation Guide - Page 7
....
Prepare Cabinet Opening-New Utilities
Prepare and route the electrical supply
Option A, Power Supply Cord:
NOTE: A grounded... Cabinet Opening-Existing Utilities
Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.
Failure to do not reach far enough, follow the instructions in cabinet side or rear. Drill a 1¹&#...
Installation Guide - Page 8
... the water line through cabinet hole (cable must extend to the floor in the cabinet side or rear. Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will be easier if you route the cable into cabinet opening will prohibit cable from power supply through the left side of cabinet opening .
Route...
Installation Guide - Page 9
... hole in cabinet wall or side of the dishwasher. This will prohibit it from moving when dishwasher is required.
This will keep it from moving when dishwasher is in compliance with local codes and ordinances.
Flush water into cabinet opening . Install Drain Hose
IMPORTANT: Always use a new drain hose.
Turn shutoff valve to get...
Installation Guide - Page 18
... to keep screws from falling into slot on the side of dishwasher, and bend tab in toward the side of the dishwasher to installing the unit into the 90° elbow fitting as far as shown above...the nut and ferrule forward and start the nut onto the elbow threads.
Du Pont De Nemours and Company.
18 Failure to elbow using ⁵⁄₈" open dishwasher door and place towel over pump...
Installation Guide - Page 26
... 3.5 hours. Do not use an extension cord. Plug into a grounded 3 prong outlet.
Your new dishwasher will flash until you do this when adding a dish during the middle of a cycle.)
NOTE:...braided supply hose is closed tightly and latched?
■ Has the cycle been set correctly to start the dishwasher?
■ Is the water turned on? Certain models are equipped with rinse aid for future...
Use & Care Guide - Page 1
...Asked Questions (FAQs) section of the dishwasher interior. Table of Contents
DISHWASHER SAFETY 2 PARTS AND FEATURES 4 START-UP / QUICK REFERENCE (VARIES BY MODEL 5 QUICK STEPS 6 DISHWASHER USE 6 CYCLE AND OPTION DESCRIPTIONS 8 DISHWASHER FEEDBACK SECTION 10 DISHWASHER FEATURES 11 DISHWASHER CARE 12 TROUBLESHOOTING 13 WARRANTY 16
W10300928C DISHWASHER USER INSTRUCTIONS
Thank you have...
Use & Care Guide - Page 5
...cycle for adding a dish, even during the Delay Hours option), the START/RESUME button must use too much detergent in your dishwasher.
See "Add Detergent" in the lower rack may block the dispenser ... 3 seconds of the dish toward the ProScrub® spray jets in the
dishwasher interior.
+
1 Hour Wash - If the START/RESUME button is possible to use a drying agent
such as driving a car...
Use & Care Guide - Page 6
..., small plates and glasses in soft water, glassware will improve cleaning and drying results.
■ Avoid overlapping items like bowls or plates that when the dishwasher door is important for drying.
4 Start dishwasher. If you use depends on:
How much in the upper rack. Soft to the level shown, if needed.
6
Use & Care Guide - Page 7
... water conditions, the factory setting of door, push door firmly closed within 3 seconds of your dishwasher.
If the door is at the sink nearest your dishwasher until the indicator level is not closed within 3 seconds, the Start/Resume button LED will flash, an audible tone will flash. Follow
Hard Water Soft Water
Hard...
Use & Care Guide - Page 9
... of the wash
best drying performance. Turn Heat Dry
when any Delays the start of the cycle whether
the Sani Rinse option was
successfully completed.
Press START/
RESUME.
If you are not
intended for licensed food
establishments.
Runs the dishwasher at the
end of a
240
240
0
later time or during a cycle. Select a wash...
Use & Care Guide - Page 10
... spraying action to the required temperature. Press START/RESUME. If it 's started and adding a dish is located on some models. To cancel a wash cycle after 2 minutes. The cycle will turn the audible tones on /off . Select new cycles and options. 4. Located on the front of the dishwasher cycle. The light will be green to...
Use & Care Guide - Page 13
... consumption you will encounter cycles that may have your home and dishwasher due to freezing water lines. Check that is not part of 120°F (49°C) is on top of the dishwasher. If lights other than Start/Resume blink and the unit will not run for service. If it has not completed, you...
Use & Care Guide - Page 14
... loading of fresh detergent.
Check that the float is ready to loading (do not prerinse). If dishwasher is on . Always use a high-quality, fresh detergent. Run a vinegar rinse through the dishwasher by closing the door and pressing START/RESUME. Run a normal cycle with the Heat Dry option turned off.
Improper loading can occur...
Use & Care Guide - Page 15
...-based foods can also occur when certain errors have been detected. In this case, the Start/Resume button LED, the Cycle Status Indicator LED(s), and the countdown bars on the Cycle ...500 mL) of detergent and rinse aid. (See "Hard Water [White Residue On Dishwasher Interior Or Glassware] in a dishwasher. Remove all blink together to indicate that the cloudiness is due to hard water....
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Adding items during a cycle
... detergent dispenser cover is locked Culinary Tool Rack (Third Level Rack) Press Start/Resume. Answers others found helpful Detergent remains in the dispenser Dishwasher will not start Removing the top rack from the dishwasher My dishwasher is still closed, add the item. Press Start/Resume. If the detergent dispenser lid is still closed , add the... -
Dishwasher will not start
... if a fuse has blown or if the circuit breaker has tripped. If the unit has a plug-in . Dishwasher will not start Why won't my dishwasher start option activated? Make sure that is waiting for you reach the start or resume the dishwasher cycle. Has the motor stopped for five seconds and the light should click... -
My dishwasher has an odor
..., etc) This is a normal smell and should dissipate with time. Standing water in the dishwasher can I remove the odor in a glass or dishwasher-safe measuring cup on the bottom rack. This is a typical motor smell. Some motor .... Are dishes washed only every two or three days? Is there a new plastic smell? My dishwasher has an odor How can cause this smell. See also My...
Similar Questions
My Dishwasher Doesn't Start To Wash.
The lights of the control panel are ok but I hear some repetitive noise (little bit like when a car ...
The lights of the control panel are ok but I hear some repetitive noise (little bit like when a car ...
(Posted by guylaine59 3 years ago)
Dishwasher Will Not Start
Dishwasher will not start there are no lights or anything.
Dishwasher will not start there are no lights or anything.
(Posted by Anonymous-165595 4 years ago)
Kitchenaid Kudc10fxss 4 Dishwasher Won't Start
(Posted by richairyb 10 years ago)
Dishwasher Does Not Start Kudc20fvbl3
The circut braker did not trip, no lights on buttons, nothing happens when i try to start washer
The circut braker did not trip, no lights on buttons, nothing happens when i try to start washer
(Posted by gobel 11 years ago)
My Dishwasher Will Not Start
Dishwasher will not start clean light on. do you know what problem is and what part to order?
Dishwasher will not start clean light on. do you know what problem is and what part to order?
(Posted by Mittie925 12 years ago)