KitchenAid KRSC700HPS Support Question
KitchenAid KRSC700HPS Support Question
Find answers below for this question about KitchenAid KRSC700HPS.Need a KitchenAid KRSC700HPS manual? We have 3 online manuals for this item!
Question posted by sdemots on October 18th, 2021
Computer Reboot
How do you reboot the computer on this fridge outside of unplugging it?
Current Answers
Answer #1: Posted by SonuKumar on October 19th, 2021 9:42 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,641,160
Member since:
May 9th, 2021 Points: 16,641,160
How do I reset my KitchenAid refrigerator?
Reset a KitchenAid Refrigerator
According to KitchenAid, the filter status light can be reset by pressing the filter reset button on the display and holding it until the light turns off. This will reset the refrigerator's system. You can also press the water filter button for three seconds.
https://refrigeratorsreviewed.com/how-to-reset-kitchenaid-refrigerator-in-minutes/
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related KitchenAid KRSC700HPS Manual Pages
Installation Instructions - Page 1
...
7 Bottom Hinges
(Left and Right)
A A
A. Alignment Screw Failure to remove the refrigerator and freezer doors. Wiring
Plugs
2A Water Dispenser
Tubing Connection (Style 1)
A
A
A. IMPORTANT... whether you begin, turn the refrigerator control OFF or turn cooling off. Face of your home to see the instructions below. Unplug refrigerator or disconnect power. Save these instructions...
Installation Instructions - Page 2
...two or more people to release the tube, then pull the water tubing free.
Unplug refrigerator or disconnect power. 2. Remove the base grille by removing
the two screws, then ... behind the base grille on the outside corners. IMPORTANT: Do not remove either screw A.
9. See Graphic 5. This will help avoid damaging the door.
10. Lift the refrigerator door straight up off bottom hinge...
Installation Instructions - Page 3
...alignment.
1. This makes it snaps into the bottom of the routing plate.
To raise the refrigerator door, turn the screw. Check that the wiring runs behind the hinges.
Assistance may be...of the product, or turn the alignment screw until they close more easily, adjust the refrigerator's tilt using a single screw.
NOTE: Provide additional support for the weight of the product...
Owners Manual - Page 2
...known to the State of California to cause birth defects or other reproductive harm.
2
REFRIGERATOR SAFETY
Your safety and the safety of others .
We have provided many important safety messages...in this manual and on some models). ■ Do not hit the refrigerator glass doors (on your refrigerator, follow instructions. WARNING
You can happen if the instructions are very important....
Owners Manual - Page 3
... past.
These products can result in accordance with cardboard or hardboard to avoid floor damage. For more people to move and install refrigerator. Do not wiggle or "walk" the refrigerator when trying to move it . IMPORTANT: Child entrapment and suffocation are still dangerous, even if they are cold. Important information to cover...
Owners Manual - Page 4
... or adjustable wrench, internal star drive or ³⁄₈" hex-head socket wrench
WARNING
Electrical Shock Hazard
Disconnect power before starting installation. Alignment Screw
4 Unplug refrigerator or disconnect power. Leveler Bracket
C. Save these instructions for future reference. NOTE: Before moving your product into your home, measure the doorway of Fitting
2B...
Owners Manual - Page 5
... replace the top left hinge, then replace the freezer door on the freezer door side. Unplug refrigerator or disconnect power. 2. See Graphic 2B. Close both water tubes through the hinge. The...grommet and two white plugs at the end. IMPORTANT: Rest the door on its side on the outside corners. This bundle is still attached to feed the water tubing and wiring through the routing plate...
Owners Manual - Page 6
.... Tighten screws. 8.
See Graphic 1.
2. Locate the alignment screw on each side of the refrigerator door. See Graphic 9.
3. If necessary, continue to turn it to the right to the ...hole). Open both doors to the electrical housing, then push the housing back under the refrigerator. Close the clasp around the small wiring bundle (with food, follow these instructions can ...
Owners Manual - Page 7
...Replacement medallions are available for the upper setscrew. Using a ¹⁄₈" hex key, remove the medallion from the door.
4. A B
A
A. Shoulder screws B. Setscrews inside the refrigerator. A. Handle medallion
Location Requirements
WARNING
5. Using a clockwise motion, tighten the setscrew until it is engaged in the handle. 1. Repeat steps 4 and 5 to order.
1.
Open the...
Owners Manual - Page 8
... ¹⁄₂" open .
1/2" (1.27 cm)
2" (5.08 cm)
NOTES: ■ This refrigerator is recommended that cannot be provided. Install copper tubing only in the User Instructions, User Guide, or ...have questions about your water pressure, call a licensed, qualified plumber.
■ If your refrigerator has an ice maker, allow extra space at the top. IMPORTANT:
■ All installations...
Owners Manual - Page 9
.... Style 2 1. Use ¹⁄₄" (6.35 mm) O.D. (outside diameter) copper tubing. FE D
A. Use a quarter-turn ON the main water supply. Screw compression nut onto outlet end with adjustable wrench. Place the free end of the copper tubing are cut square.
Bulb B. Nut
D
C. Shutoff valve G.
Unplug refrigerator or disconnect power. 2. Copper tubing
5. Fasten the...
Owners Manual - Page 10
... connections at the valve) that is attached to completely fill ice container.
10 Do not use an adapter.
Check for leaks. Unplug refrigerator or disconnect power.
2. Attach the copper tube to the refrigerator as shown. Do not overtighten.
4. Check for leaks. If your nearest appliance dealer. Nut (provided) C. Turn shutoff valve ON.
5. Complete...
Owners Manual - Page 11
...Spinach
Sensitivity to use .
Lift open the vented air filter door. either inside the refrigerator. Place the indicator face-down on the back of many produce items to use . ... the air filter door, and check that produce moderate to maintain a cleaner environment inside the refrigerator, or elsewhere in the door.
As a result, certain produce items will easily remember -...
Owners Manual - Page 12
... the Produce Preserver (on skin, rinse with cleaning products containing ammonia, bleach or acids.
REFRIGERATOR USE
CAUTION
IRRITANT Read cautions on back. Place both pouches inside the housing, then snap ...the old pouches from its mounting tab along the wall. Using the Controls
The refrigerator and freezer controls are located on the dispenser panel to activate the display screen. ...
Owners Manual - Page 13
...Options mode (unless you have finished viewing (and adjusting if desired) the refrigerator set points, press MEASURED FILL to press both buttons at the factory. ...preset at exactly the same time. CONDITION:
TEMPERATURE ADJUSTMENT:
REFRIGERATOR too cold
REFRIGERATOR Setting 1° higher
REFRIGERATOR too warm
REFRIGERATOR Setting 1° lower
The Max Cool feature will disappear...
Owners Manual - Page 14
... smells in some models)
Some models come equipped with skins.
After 24 hours, the refrigerator returns to the previous temperature set points remain unchanged, but the Door Ajar icon will ... flow. 3.
Flushing the water dispensing system forces air from transferring to ice in the refrigerator from the system, water may be provided.
14 When the indicator is left open )...
Owners Manual - Page 15
...Fill
NOTE: If overfilling or spilling occurs, discard the water and press "Back" to the refrigerator is lower than 8 seconds to dispense 1 cup of water has been correctly dispensed into the ...to ensure that the container is dispensed in 8 seconds or less, the water pressure to the refrigerator meets the minimum requirement.
■ If it could be dispensed. Default, minimum, and maximum ...
Owners Manual - Page 19
...; Remove the base grille. IMPORTANT: Because air circulates between both sections, any odors formed in warm water.
4. To Clean Your Refrigerator: NOTE: Do not use paper towels, scouring pads, or other . Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Wash stainless steel and painted metal...
Owners Manual - Page 20
... or move the switch to the Installation Instructions for the move.
1. If your refrigerator has an automatic ice maker:
■ Turn off the water supply to the ...turned off .
Remove all food from the back of the refrigerator.
■ When the last load of the refrigerator so it for preparation instructions. Unplug refrigerator.
6. Remove all food from building up ) position or...
Owners Manual - Page 27
...of the product.
14. This limited warranty is effective from defects in the sealed refrigeration system (includes compressor, evaporator, condenser, dryer and connecting tubing) that existed when ...can be borne by a KitchenAid designated service company. http://kitchenaid.custhelp.com
If outside the 50 United States or Canada, contact your product requires repair. Damage from caustic...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water supply hookup - Built-in refrigerator
...Allow enough flow so that water becomes clear. Flush the water system. Copper line connection Unplug refrigerator or disconnect power. Turn off the ice maker. Locate a ½" to 1&#... the water line: Unplug refrigerator or disconnect power supply. Allow the storage tank on the water pipe. To connect to be located. Style 2 - Use ¼" (6.35mm) OD (outside diameter) copper tubing.&... -
Water supply hookup - Bottom freezer/French door refrigerators
... storage tank on the water supply. To connect a refrigerator to the refrigerator, and check for 24 hours. Use ¼" (6.35 mm) O.D. (outside diameter) copper tubing. Make sure both ends of...the water valve inlet port. Correct leaks if necessary. After connecting the refrigerator to water line: Unplug refrigerator or disconnect power. Attach the copper tube to the plastic water line, ... -
Water supply hookup - Bottom freezer/French door refrigerators
.... This will help keep water away from the system, water may spurt out of the dispenser. Add aprox. 7' (2.1 m) to water line: Unplug refrigerator or disconnect power. Use ¼" (6.35 mm) O.D. (outside diameter) copper tubing. Make sure both ends of water. Tighten the packing nut. Do not overtighten or you begin. Place the...
Similar Questions
Fridge Has High Pitched Chirp Or Squeal !!!
Fridge works well. But has been, of late, having a high pitched chirp and/or squeal. Very annoying t...
Fridge works well. But has been, of late, having a high pitched chirp and/or squeal. Very annoying t...
(Posted by jerryrampton 7 years ago)
Refrigerator Freezer Compartment Shuts Down And Water Dispenser Stops Working.
PREVIOUS POSTRefrigerator freezer compartment shuts down and as such, refrigerator looses cool air. ...
PREVIOUS POSTRefrigerator freezer compartment shuts down and as such, refrigerator looses cool air. ...
(Posted by Shane1mohammed 8 years ago)
Does This Refrigerator Come With An Outside Dispenser Also?
Is this refrigerator model made with an outside water dispemser also?
Is this refrigerator model made with an outside water dispemser also?
(Posted by vtroyan 11 years ago)
Refrigerator Section Is Too Cold. Freezes Items In Front Center Of Fridge.
Temperature indicator reads in mid-40s?
Temperature indicator reads in mid-40s?
(Posted by andymartin 12 years ago)