Kenwood WD250 Support Question
Kenwood WD250 Support Question
Find answers below for this question about Kenwood WD250 - KSC Car Subwoofer.Need a Kenwood WD250 manual? We have 1 online manual for this item!
Question posted by brents952 on September 14th, 2016
Ksc Wd250 Wiring.
Why does it have 2 power and 2 ground wires? do I need to connect them all?
Current Answers
Related Kenwood WD250 Manual Pages
Instruction Manual - Page 2
...the car stereo until the temperature inside the car has...KSC-WD250 Serial number
• Safety Precautions In a situation where the car has been left in direct sunlight with the stipulated size (amperage) fuse as displayed on the fuse box.
(Using fuses other than the stipulated size can cause shorts or fires.) When extending the ignition, battery, or ground wires... switch the power OFF. Otherwise...
Instruction Manual - Page 3
... the following examples. • Do not connect this unit can be connected to it could damage amplifiers.
■ Examples ofapplications • General connection
CENTER UNIT
Front speaker
• Connection to other amplifiers. Connection
To enhance the bass sound of your car stereo system, this speaker to center unit with non-fader (subwoofer control)
Front speaker CENTER UNIT
Rear...
Instruction Manual - Page 4
...Connect the black lead wire ground terminal directly with non-fader (subwoofer control)
f - Be careful. Examples ofConnections
Caution: Under any circumstances, never apply inputs to the terminals ® and C) simultaneously.
0 HEE
KENW
■ Generalconnection 1 • If there is no power control ▪ terminal in the center unit, connect the blue/white wire to damage of the stereo...
Instruction Manual - Page 5
...
Speaker output terminal Power Supply/Control Input/Terminal (for Speaker Cords) LINE IN terminal (RCA pin jack) REMOTE terminal
PHASE FREQUENCY
LEVEL
rnlll
■ Fuse exchange Exchange with your liking. PHASE
• Crossover frequency: The frequency at which the high range is 5A.
® Remote control unit
KENW
When connecting the cord...
Instruction Manual - Page 6
... (-) cable of the car battery is
not light).
Sound quality is bad (sound is distorted).
• Connection terminals are connected improperly. • The...connection example (on page 4).
• Attach the grounding terminal to the connection example (on not connected.
(the POWER indicator does • The power control pin (blue) of the center unit is not connected.
• Connect...
Similar Questions
My Kenwood Just Stopped Working
T there is power going to the wires but when I plug it in I have no light on my remote and it just d...
T there is power going to the wires but when I plug it in I have no light on my remote and it just d...
(Posted by morashlenny 2 years ago)
How Would I Connect My Kenwood Ksc-sw1 To My House Sound Bar What Are The Harnes
Hardness coloring wiring
Hardness coloring wiring
(Posted by pjshort32 3 years ago)
Whats Tha Best Way To Wire Up 2 Kfc-w3012 12inch Subs To A Monoblock Amp
(Posted by Mntnz512 4 years ago)
Looking For Wiring Digram For The Remote
Hi there, I'm looking for the wiring areas (where to put) the wires for the remote. What happened is...
Hi there, I'm looking for the wiring areas (where to put) the wires for the remote. What happened is...
(Posted by davemarriott2832 8 years ago)
