Kenwood KAC 7202 Support Question
Kenwood KAC 7202 Support Question
Find answers below for this question about Kenwood KAC 7202 - Amplifier.Need a Kenwood KAC 7202 manual? We have 1 online manual for this item!
Question posted by jjstanky on November 10th, 2011
Red Light
I disconnected my system cuz keep blowing fuses but of course put it back in an now i get a red light...check all wires & fuses 20x an still nothing. PLZ help Thx
Current Answers
Related Kenwood KAC 7202 Manual Pages
Instruction Manual - Page 1
STEREO/BRIDGEABLE POWER AMPLIFIER
KAC-7252 KAC-7202
INSTRUCTION MANUAL
© B64-3013-00/00 (MV)
Instruction Manual - Page 2
...car chassis that are going to be working right, consult your unit to malfunction. • To prevent a short circuit when replacing a fuse, first disconnect the wiring... should be 2Ω or greater (for stereo connections), or 4Ω or greater (for...fuse, only use a power supply wiring wire and protective fuse of greater current-handling capacity than the output power of the amplifier...
Instruction Manual - Page 3
... or safety part, it may be removed. Install the amplifier in the unit. 7.Attach the unit. 8.Install the remote controller. (KAC-7252 only) 9.Connect the negative - terminal of the...inside the trunk, or somewhere else in the vehicle, check that electrical equipment such as a gasoline tank, brake pipe, or wiring harness, and be careful not to cause scratches or ...disconnect the negative -
Instruction Manual - Page 4
...; Be sure to turn the power off before changing the setting of any switch.
• If the fuse blows, check wires for this unit to fail.
• After installation, check that no unconnected wires or connectors are touching the car body.
CENTER UNIT (CD receiver, etc.)
RCA cable*
RCA cable ground terminal
'.$
• Speaker level input Connections...
Instruction Manual - Page 5
... the "LPF FREQUENCY" control. The speakers to the maximum power output of the amplifier. If the Power indicator does not light when the power is turned on, the protection function may be generated when the power of the genuine-accessory car stereo is output without filtering.
• LPF (Low-Pass Filter) position: The filter...
Instruction Manual - Page 7
... to .
• Connect them properly checking the + / - of the terminals and wires well.
• Connect the speaker wire again so that it is not pinched by anything.
• Set switches properly by a screw in the car body. • The switches may be set improperly.
• The Remote Cable is disconnected. • The "BOOST LEVEL" is...
Similar Questions
Not Pushing My Subs
If both blue and red light come on and it doesn't push the subs what should I do
If both blue and red light come on and it doesn't push the subs what should I do
(Posted by stephensont951 2 years ago)
My Amp Won't Play Subs.
my kenwood 9102d amp won't play subs anymore. It's worked fine for over 2 years. I have not added or...
my kenwood 9102d amp won't play subs anymore. It's worked fine for over 2 years. I have not added or...
(Posted by falkonj5 7 years ago)
Amplifier Sound Cutting
my kenwood power amplifier kac 6402 sound is cutting imediately 2 minutes after starting the vehicle...
my kenwood power amplifier kac 6402 sound is cutting imediately 2 minutes after starting the vehicle...
(Posted by marksuzyo07 7 years ago)
How To Adjust Speaker Level Inputs Kac 7202
(Posted by stooucmech 9 years ago)