Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by amberperez on August 29th, 2013
Washer Humming
I have a kemore h2 front load washer that humming during wash cycle? Why does it do this
Current Answers
Related Kenmore HE2t Manual Pages
User Guide - Page 1
CONSUMER SERVICES TECHNICAL
EDUCATION GROUP PRESENTS L-78
FRONT-LOADING AUTOMATIC WASHER
MODELS: WFW8300SW, WFW8500SW, WFW8500SR
JOB AID Part No. 8178558
User Guide - Page 2
... responsibility for training purposes only.
Copyright © 2006, Whirlpool Corporation, Benton Harbor, MI 49022
- ii - FORWARD
This Whirlpool Job Aid, "Duet Sport™ Front-Loading Automatic Washer" (Part No. 8178558), provides the technician with information on our products by anyone other than Authorized Service Technicians. The Wiring Diagram used in this Job...
User Guide - Page 8
... Number Model Description
Color
Capacity (Cu.Ft. IEC) Temperature Control
Heater Sensors
Tumble Speed
Spin Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min - Max
Width Product Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White...
User Guide - Page 10
...washer.
• A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
• A level floor with a total weight (water and load...soft floor surfaces, such as carpets or surfaces with foam backing, is your washer in a basement, laundry room, closet, or recessed area. To order, call the dealer from whom ...
User Guide - Page 19
... 7 minutes.
You are easy to use the minimal amount of the load, this option is available in which means fewer loads.
This washer offers up to use whether you can wash a pillow or a large stuffed teddy bear. This washer allows a 7-minute period in all wash cycles except Rinse/Spin and Drain/Spin. AUTO WATER LEVEL
Adjusting to...
User Guide - Page 22
... cycle can be fully loaded, but not tightly packed. USING THE PROPER DETERGENT
Use only High Efficiency detergents. For All Wash Cycles
1. Sort laundry according to avoid spills. Open the dispenser drawer and add laundry additives to select ON or OFF.
7. Turn on the handle. Use 1/2 the manufacturer's recommended amount for the selected cycle. The washer...
User Guide - Page 23
...-one is for detergent, one is for liquid chlorine bleach, and one is complete, the CYCLE COMPLETE status light illuminates, the door unlocks, and the wash load can be removed from the washer.
Add the desired laundry additives to avoid a spill). Pull out the dispenser drawer. 2. To fill dispenser compartments 1. A C
MAX
DETERGENT
LIQUID BLEACH...
User Guide - Page 24
... (160 mL) liquid chlorine bleach to your load.
• Always measure liquid chlorine bleach....cycle, select and hold START (for approximately 1 second). To cancel a cycle
1.
PAUSING OR RESTARTING
1. CHANGING CYCLES AND OPTIONS
Not all Cycles. Select and hold START (for approximately 1 second) to the wash cycle.... To pause the washer at the beginning of the new cycle. When the spin ...
User Guide - Page 25
... available with all Options and Modifiers (WASH TEMP, SPIN SPEED) are shown in the Preset Cycle Settings table. To change up to continue the cycle.
3-7 This will be extended if oversudsing occurs or the load is unbalanced. You can lock the controls while the washer is operating. You can also use of your...
User Guide - Page 27
...." Rinse/Spin
Use this to begin the wash cycle later. • Select DELAY WASH until the desired time
(in hours) shows in stains on fabrics. Between changes in stains.
Clean Washer
Use the Clean Washer cycle once a month to keep the inside of your wash load.
Soak
Use the Soak cycle to help improve the removal of set -in...
User Guide - Page 28
... the Whitest Whites cycle. See Preset Cycle Settings table in "Cycles."
• ATC works for all rinse cycles is illuminated. The water temperature for the wash temperature with the same water temperature as it stops.
This option adds tumbling time prior to keep laundry additives from the washer as soon as in the removal of load you are...
User Guide - Page 29
... blouses, fabrics made of silk, and special care items marked "Hand Washable"
Clean Washer No clothes
Rinse & Spin
All loads
Drain & Spin
All loads
Soak
All loads
Delay Wash
AVAILABLE OPTIONS
Extra Rinse
Pre
End of these washer cycles. LAUNDRY GUIDE
Refer to each of
Wash Cycle Signal
3-11 Listed to the right are the options available to the chart...
User Guide - Page 30
...WASH and CONTROLS LOCKED lights will proceed to cancel the failure code.
This will unlock. Failure to do so will cause damage to the unit and clothing added to check for proper use. b) Wipe the seal/bellow area with door open. The door will stop the cycle. Open the washer...rinse the remaining bleach from the washer.
2. A RINSE/SPIN cycle must then be interrupted by pressing...
User Guide - Page 33
... with the floor. All four feet of the washer must be level. Between changes in wash actions, there will hear water spraying and splashing during the wash and rinse cycles. Do not remove ground prong.
Re-select cycle and press START.
• "Spin," "Wash" (HT "Rinse,""Cycle Complete") and "Add a Garment" illuminated or "F21" on ?
TROUBLESHOOTING...
User Guide - Page 35
...removed? All four shipping bolts must be closed again to start a new cycle. The drain hose should be removed for leaks.
• Is the washer in a normal pause in death, fire, or electrical shock....above the floor.
Do not use an extension cord. Wash smaller loads.
• Is the washer door firmly shut?
See "Drain System."
• Does the drain hose fi...
User Guide - Page 36
... the original cycle.
• Did the load cause imbalance? Use hot or warm washes if safe for hot and warm temperatures. The washer will be trapped in the load if overloaded.
• Check the following: Was paper or tissue left in the Preset Cycle Settings table.
• Excessive suds? If the laundry is designed for washing heavy soils...
User Guide - Page 37
.... Consider using a low speed wash cycle? Dispensing balls will cause wrinkling.
If safe for small, lightly soiled loads. See "Connect the Inlet Hoses."
3-19 Loads should tumble freely during washing.
• Was the wash water warm enough to the right faucets. Add liquid fabric softener to reduce wrinkling.
• Did you unload the washer promptly? A hot rinse...
User Guide - Page 80
...foreign objects. 5.
Check the drain hose and make sure
the pump is out of the WASH cycle. Possible Causes/Procedure Door lock mechanism is not plugged or
kinked.
2.
Possible Causes/Procedure ... be displayed. Verify wire harness connections to clear the display. Replace the pump. Unplug washer or disconnect power. 2. Check resistance of heating element, if present on this error....
User Guide - Page 82
... or spin phases, the washer will fill 4 liters of water and during 5 minutes the unit will try to spin or drain again. Failure Codes
Status LEDs
Duet Sport
Duet Sport Ht
F/01 Add a Garment
Add a Garment
F/11 Add a Garment, Wash, Spin
Add a Garment, Soak/Prewash, Rinse
F/20 Rinse, Cycle Complete
Wash, Spin
F/21 Add...
User Guide - Page 89
... OVERHEATS
POSSIBLE CAUSE/TEST
NOTE: Possible Cause/Tests must be opened between consecutive wash cycles.
2. Check dispenser motor. 5. Unplug washer or disconnect power. 6. Check harness connections. 7. Check installation. Verify hot and cold water faucets are clear of foreign objects.
3. Unplug washer or disconnect power. 4.
Make sure water supply hoses are clear of line cord...
Similar Questions
Cloths Washer Spin Cycle
I recently bought a home that has a Kenmore washer in the purchase. When I do a normal wash cycle it...
I recently bought a home that has a Kenmore washer in the purchase. When I do a normal wash cycle it...
(Posted by jimkelley31050 8 years ago)
How Can I Clean My Kennmore Washer Machine?
(Posted by Mariavargas1102 9 years ago)
Washer Wont Wash With Clothes F20
(Posted by zizirCdw 9 years ago)
What Does It Mean When A Kenmore Front Load Washer Model # 48102 Turns Off And O
what does it mean when a kenmore front load washer model # 48102 turns off and on during the washing...
what does it mean when a kenmore front load washer model # 48102 turns off and on during the washing...
(Posted by kemackey86 11 years ago)
Cloths Washer Will Not Start
I have a kenmore elite HE3T washer and the wash cycle indicatorsw blink but the washer will not star...
I have a kenmore elite HE3T washer and the wash cycle indicatorsw blink but the washer will not star...
(Posted by Anonymous-24355 13 years ago)