Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by cire503 on May 8th, 2013
My Washer Works But It Wont Go Into Spin Cycle It Drains The Water But Wont Spin
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Kenmore HE2t Manual Pages
User Guide - Page 8
... lbs. (8 kg)
N/A
36.0" 30.00"
27" 242 lbs.
17.64 lbs. (8 kg)
N/A
36.0" 30.00"
27" 242 lbs.
1-4 IEC) Temperature Control
Heater Sensors
Tumble Speed
Spin Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min - SPECIFICATIONS
Model Number Model Description
Color
Capacity (Cu.Ft.
User Guide - Page 15
... floors from the shipping clips.
Connect the inlet hoses to the corrugated drain hose. NOTE: Do not overtighten. Laundry tub drain or standpipe drain
Connect the drain hose form to the washer
H
C
H. Read and follow these instructions. Attach the cold water hose to the washer's hot (H) water inlet valve. Snap either end of hose failure. Check the temperature of...
User Guide - Page 16
...of the laundry tub. After the washer is level. 2. Confirm the levelness of the washer.
• To prevent siphoning, do not force excess drain hose into the standpipe. Place the drain hose in...as necessary. To keep drain water from going back into the washer:
• Do not straighten the drain hose, and do not seal the drain hose into standpipe. SECURE THE DRAIN HOSE
1. When you ...
User Guide - Page 19
The washer is available in which means fewer loads.
This washer allows a 7-minute period in all wash cycles except Rinse/Spin and Drain/Spin.
AUTO WATER LEVEL
Adjusting to the size of the load, this feature allows the washer to use the minimal amount of the cycle the Add A Garment status light will have less moisture than for small and large loads size...
User Guide - Page 22
... 1/2 the manufacturer's recommended amount for the selected cycle. When selecting a Wash Cycle, the preset Modifiers and Options, Water Temp, and Spin Speed for approximately 1 second).
• If you are washing items that more than one of choosing a cycle, the washer automatically shuts off.
3-4 Select the desired OPTIONS. Load evenly.
• Wash small items such as...
User Guide - Page 24
.... Fabric softener will beep.
3. PAUSING OR RESTARTING
1.
Select and hold START (for approximately 1 second) to restart the washer at any form of the cycle the washer is complete, the door unlocks.
Select DRAIN/SPIN.
3. To continue the cycle, select and hold START (for approximately 1 second). Items can add an additional item to add powdered chlorine or...
User Guide - Page 25
... feature except Rinse/Spin and Drain/Spin. When CONTROL LOCKED is locked and unlocked automatically, depending on the stage of the washer. The door is lit, all Cycles. Locking controls
The Control Lock avoids unintended use the control lock feature to the desired cycle. You can be extended if oversudsing occurs or the load is locked. The...
User Guide - Page 26
..., longer wash time, and high-speed spin to reduce wrinkling. This cycle combines low-speed tumbling and low-speed spin for the selected cycle.
Normal/Casual
Use this cycle to wash undergarments such as socks.
3-8 Cycle
Sanitary Whitest Whites Heavy Duty Normal/Casual Quick Wash (2-3 items) Delicate/ Hand Wash Clean Washer Rinse/Spin Drain/Spin Soak
Estimated
Time* (hr:min...
User Guide - Page 27
... Use this cycle to drain your washer or to help remove small spots of your washer fresh and clean. This cycle uses a higher water level in the display window.
3-9
OPTIONS AND MODIFIERS
You can reduce the spin speed by drain. You can reduce the spin speed by adding options to . Rinse & Spin is useful for equal distribution of the laundry, and...
User Guide - Page 28
...predispensing into the main wash cycle. The washer continues automatically from garments.
Cold rinses save energy. Prewash
Use this option for loads of Cycle Signal
This signal is illuminated. Spin Speed
Each cycle has a preset SPIN SPEED. Select a water temperature based on the cold water at the faucet.
Wash Temp
Each cycle has a preset water temperature setting. Select ON...
User Guide - Page 29
... silk, and special care items marked "Hand Washable"
Clean Washer No clothes
Rinse & Spin
All loads
Drain & Spin
All loads
Soak
All loads
Delay Wash
AVAILABLE OPTIONS
Extra Rinse
Pre
End of these washer cycles.
Listed to the right are the options available to the chart below for suggested load types and their corresponding cycles. LAUNDRY GUIDE
Refer to each of
Wash...
User Guide - Page 30
... cause damage to the unit and clothing added to start the cycle again.
3-12 A
A. a) Mix a dilute solution, using the procedure that uses higher water volumes in the washer, all areas under the seal/bellow and to the bleach compartment. Select the CLEAN WASHER cycle.
6. The cycle will proceed to cancel the failure code. b) If any detergent...
User Guide - Page 31
... HE High Efficiency detergent.
• Leave the door slightly open , slightly, to allow for easy cleaning.
1.
To winterize washer:
1. Shut off the water supply to a water pressure surge) while you are at home. Turn on a Drain/Spin cycle.
3.
Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
Run...
User Guide - Page 34
... softener dispenser. A small amount of water will unlock.
3-16 WASHER ODOR
• Have you using HE detergent? To freshen your washer and to remove any water remaining in the dispenser at the end of water per minute.
Select DRAIN/SPIN to avoid odors, see "Cleaning The Washer."
• Are you run the Clean Washer Cycle lately? Press PAUSE/CANCEL once...
User Guide - Page 35
... hoses, turn on the water.
• Is the water inlet hose kinked? The door must be loose yet fit securely. WASHER WON'T DRAIN OR SPIN, WATER REMAINS IN WASHER
• Is the drain hose clogged, or the end of last cycle? This will not affect cleaning performance.
3-17
This washer uses very little water to start a new cycle. WASHER STOPS
Electrical Shock Hazard...
User Guide - Page 36
... select will attempt to redistribute the load. This routine will start a Drain/Spin cycle. When using the Quick Wash or Delicate cycles, you washing many loads? RESIDUE, LINT, STAINS ON LOAD; Do not add detergent to remove soil and hold it in a gentle or Delicate cycle? Use enough HE detergent to the washer drum.
• Did you have you...
User Guide - Page 80
...spin the door unlocks after 6 minutes. Verify drain pump operation. - Verify there is not working properly. Unplug washer or disconnect power.
4. DISPLAY
EXPLANATION AND RECOMMENDED PROCEDURE
Reference Status LEDs chart, page 6-4
LONG DRAIN If the drain time exceeds 8 minutes the water valves turn off. Check the drain...during the water-heating step of the WASH cycle.
Possible Causes/Procedure...
User Guide - Page 82
..., Spin
F/30 Wash, Rinse, Spin, Cycle Complete
Soak/Prewash, Wash, Rinse, Spin
F/31 Add a Garment, Wash, Rinse, Spin, Cycle Complete
Add a Garment, Soak/Prewash, Wash, Rinse, Spin
F/33 Add a Garment
Add a Garment, Cycle Complete
rL Wash
Soak/Prewash, Cycle Complete
6-4 Verify CCU operation by the pressure switch during the drain or spin phases, the washer will fill 4 liters of water and...
User Guide - Page 87
... the procedure that follows:
a) Mix a dilute solution, using a damp cloth. A RINSE/SPIN cycle must then be interrupted by the dispenser drawer.
5. Washer Maintenance Procedure
This washer has a special cycle that was covered by pressing PAUSE/CANCEL. Remove left front screw that uses higher water volumes in combination with the notch in notch to thoroughly clean the...
User Guide - Page 89
... drain hose and drain
SELECTIONS
pump filter are clear of the
drive motor.
6-11 Verify the unit is plugged into a working outlet and for blown fuses.
2. Check dispenser motor. 5. Verify CCU operation by running a Diagnostic Test or any cycle. Verify hot and cold water faucets are unobstructed. this could indicate a failure
to CCU.
6. Plug in washer...
Similar Questions
F1 Code On Washer; What Does It Mean?
Not draining and posibally not spinning correctly.
Not draining and posibally not spinning correctly.
(Posted by mannbuilder65 9 years ago)
My Washer Don't. Spin
(Posted by alberthch68 9 years ago)
Kenmore He2t Washer Won't Spin
(Posted by babskhell 10 years ago)
My Washer Won't Spin. How Do I Make It Work Again
(Posted by luedog35 11 years ago)
Kenmore - Washer Does Not Spin-dry If Absorbent Clothes Included. Worn Belt?
Washer does not spin-dry if heavier clothes are in load--such as flannel pajamas, polo shirts, towel...
Washer does not spin-dry if heavier clothes are in load--such as flannel pajamas, polo shirts, towel...
(Posted by JimNelsonGlobal 12 years ago)