Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by Jduppler on July 28th, 2014
Cleaning Washer
I have a Kenmore Vibration Guard front load washer. How do I clean it? I can't find the manual.
Current Answers
Related Kenmore HE2t Manual Pages
User Guide - Page 1
CONSUMER SERVICES TECHNICAL
EDUCATION GROUP PRESENTS L-78
FRONT-LOADING AUTOMATIC WASHER
MODELS: WFW8300SW, WFW8500SW, WFW8500SR
JOB AID Part No. 8178558
User Guide - Page 2
... used for any repairs made on our products by anyone other than Authorized Service Technicians. ii - FORWARD
This Whirlpool Job Aid, "Duet Sport™ Front-Loading Automatic Washer" (Part No. 8178558), provides the technician with information on the model being serviced, refer to the "Use and Care Guide," or "Tech Sheet" provided...
User Guide - Page 8
... Number Model Description
Color
Capacity (Cu.Ft. IEC) Temperature Control
Heater Sensors
Tumble Speed
Spin Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min - Max
Width Product Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White...
User Guide - Page 10
... servicing. Custom undercounter installation Washer only
2" (5 cm)
36" min. (91.4...laundry room, closet, or recessed area. Proper installation is recommended to reduce noise transfer.
• Companion appliance spacing should also be considered. Installing the washer...you purchased your washer and dryer?... water to the washer.
• A grounded electrical outlet located within 4 ft (1.2 m) of ...
User Guide - Page 14
... at a later date, call your local service center. CONNECT THE INLET HOSES
Insert new flat washers (supplied) into each of the hole and completely pull out the bolt, including the plastic spacer... the unit is empty.
1. Once the bolt is to the water faucets
Make sure the washer drum is within approximately 3 ft (90 cm) of the rear panel and close the hole with the attached cap.
2-6
NOTE...
User Guide - Page 17
...
6.
Electrical Shock Hazard Plug into a grounded 3 prong outlet. 8. To test and to clean your tools.
4. Be sure that you have the correct electrical supply and the recommended grounding... a medium sized load. Do not use
1/2 the manufacturer's recommended amount for leaks around faucets and inlet hoses. Failure to complete one whole cycle. Allow the washer to follow these instructions...
User Guide - Page 19
...provide the amount of the load, this option is available in which means fewer loads.
This washer offers up to clean and rinse the clothes.
...washer "walk" and "off -balance loads during spinning, it redistributes the clothes so that clothes coming out of the cycle the Add A Garment status light will have less moisture than for more clothes at the washer base
to isolate vibration...
User Guide - Page 20
... wash at the beginning of all laundry additives before the washer is easily removed for high performance cleaning.
Use only HE High Efficiency detergent...cleaning. The detergent is dispensed in the rinse cycle or in the detergent advantage system. The fabric softener is added at the optimal time for cleaning. SMART DISPENSERS
The three compartments in the dispenser allow loading...
User Guide - Page 22
... recommended amount for the selected cycle. For All Wash Cycles
1. To load washer
Open the washer door by selecting POWER.
Close drawer slowly to select ON or OFF...laundry according to the detergent, bleach, or fabric softener compartments. Do not overload washer. Overloading can cause poor cleaning.
• The washer can be opened and then closed before washing clothes. Washer...
User Guide - Page 26
...combines low-speed tumbling and low-speed spin for cleaning loads of soiled white fabrics with strings, and small items...loads of no bleach is recommended that are needed in the machine increasing the wash time. Quick Wash
Use this cycle to avoid chlorine residues on your laundry. Cycle
Sanitary Whitest Whites Heavy Duty Normal/Casual Quick Wash (2-3 items) Delicate/ Hand Wash Clean Washer...
User Guide - Page 27
... the laundry, and a soaking time without spin assures gentle treatment, even for that need rinsing only.
• Adding fabric softener to a load using the fabric softener dispenser. The countdown to the wash cycle will illuminate when selected.
• If an option is locked or unlocked, and during the wash and rinse cycles. Clean Washer...
User Guide - Page 29
..., skirts, shirts and blouses, fabrics made of silk, and special care items marked "Hand Washable"
Clean Washer No clothes
Rinse & Spin
All loads
Drain & Spin
All loads
Soak
All loads
Delay Wash
AVAILABLE OPTIONS
Extra Rinse
Pre
End of these washer cycles. Listed to the right are the options available to the chart below for suggested...
User Guide - Page 30
... a short sensing cycle.
Pull back the seal/ bellow to the bleach manufacturer's instructions for proper use. Select the CLEAN WASHER cycle.
6.
Inspect the gray colored seal/bellow between the door opening and the basket for foreign objects.
A
A. b) Wipe the seal/bellow area with door open. c) ...
User Guide - Page 32
... not use an extension cord. Disconnect the drain hose from faucets, then drain the hoses and clip them to clean the washer and remove the antifreeze, if used. Use 1/2 the manufacturer's recommended amount for a medium sized load. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not use an adapter.
To transport the...
User Guide - Page 34
... softener or liquid chlorine bleach to avoid odors, see "Cleaning The Washer."
• Are you follow the manufacturer's directions when adding...Washer Care" for details.
• Are the laundry additives in odor.
• Did you leave the door open to allow the washer to the Main Wash compartment.
• Is there water in the fabric softener dispenser.
• Did you run the Clean Washer...
User Guide - Page 35
... adapter. Some cycles feature periods of the drain hose more items or redistribute the load. This will not affect cleaning performance.
3-17 NOT ENOUGH WATER / NOT ENOUGH SUDS
• Low water? HE detergent is used.
• Is the load balanced? The washer pauses for 1 second? Press and hold START, for leaks.
• Is the...
User Guide - Page 81
... drum and start of the CLEANING WASHER cycle a load is not located
near a ...Manually Unlocking The Door Lock System. Check for operations of heat and has proper ventilation. 2. Possible Causes/Procedure 1. Check wire harness connections to the Central Control Unit (CCU), then the CCU will show. Check the drive motor for foreign objects. 2. LOAD INSIDE DRUM DURING CLEANING WASHER...
User Guide - Page 83
...have been recorded by the appliance.
• Run through an automated test.
• Run loads to the next step of operation.
All of the steps below must be done in sequence ...does not show the error history.
• Close the door.
• Push POWER.
• Select the CLEAN WASHER cycle.
• Press EXTRA RINSE four times within 5 seconds.
• Press EXTRA RINSE to advance to assist...
User Guide - Page 84
Delicate/Hand Wash
Distribution system is set to CLEAN position.
ERROR HISTORY DISPLAY
When the press and hold entry method is...the end of the cycle lights will flash and the error code will be Checked
Door lock system
Clean Washer Delicate
Clean Washer
Distribution system is set to be displayed on for 5 seconds.
HISTORY OVERVIEW TEST PROGRAM
Indication
Whirlpool Duet ...
User Guide - Page 88
... again.
8.
Be sure dispenser drawer is closed .
3.
The cycle will cause product damage over time.
4. Select the CLEAN WASHER cycle.
6.
Then repeat steps 1, 2 and 6 to cancel the failure code. Always do the following to maintain washer freshness:
• Use only HE High Efficiency detergent.
• Leave the door slightly open , slightly...
Similar Questions
No Cold Water
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
(Posted by jethalhuber 10 months ago)
Washer Capacity
Hi,What is the cubic capacity of a kenmore 110.29822801
Hi,What is the cubic capacity of a kenmore 110.29822801
(Posted by juliettemallen 6 years ago)
I Get An R1 Error When I Try To Run My Clean Washer Cycle. What Does This Mean?
I get an r1 error when I try to run my clean washer cycle. What does this mean?
I get an r1 error when I try to run my clean washer cycle. What does this mean?
(Posted by nishizaki 9 years ago)
How Can I Clean My Kennmore Washer Machine?
(Posted by Mariavargas1102 9 years ago)
Kenmore He2t Washer How To Clean Drain Filter
(Posted by S9exden 10 years ago)