Kenmore 4810 Support Question
Kenmore 4810 Support Question
Find answers below for this question about Kenmore 4810 - 3.5 cu. Ft. I.E.C. High-Efficiency Washer.Need a Kenmore 4810 manual? We have 2 online manuals for this item!
Question posted by doriswhatley on March 21st, 2014
Lights Flash & Beep 9 Times, Won't Start
I put some sheets into my Kenmore 48102 washer, closed the door, and the lights started flashing and beeping...9 times, pause 2 seconds, 9 times....continuously! I've tried holding down different buttons at once and unplugging the machine for an extended period. But the flashing/beeping resumed immediately upon being plugged in again. A friend said that hers had done the same thing and she'd removed the top and replaced the mother board. Can you tell me how to do the same...if that is indeed what is wrong with it?
Current Answers
Related Kenmore 4810 Manual Pages
Operating Instructions - Page 1
...
the proper time in your laundry items, not every temperature, speed and option is lighted.
it provides detailed information for washing.
3. FOR BEST RESULTSAHIGH EFFICIENCY /_"_em_'__,
_G
WASHERS MUST BE USED.
(q_..._'
" if desired, add liquid chlorine bleach and liquid fabric softener to the appropriate compartments.
,, Slowly close door and press START to open door, add item...
Operating Instructions - Page 2
... remove excess dirt and detergent. Extra Rinse occurs before washing. This will beep 3 times.
Status Lights
The following will be displayed during off peak energy hours. Add a detergant...time and hold OPTIONS and Select for about 10 seconds until the desired wash and rinse water temperatures and final spin speed are followed by 3 rinses and a final spin. The start or stop the washer...
Operating Instructions - Page 3
WASHER SETTINGS CHART
The following chart shows the temperatures, spin speeds and options available for each cycle. Estimated Cycle Duration ** Temperatures Cold/Cold
Warm/Cold Warm/Warm Hot/Cold Speed High...Start
,/
,/
,/
,/
,/
,/
,/
,/
,/
,/
,/
,/
* Factory Settings
,/ Available settings
** Estimated cycle duration is based on factory settings and does not
include water fill times,...
Installation Instructions - Page 1
...the installation and ensure the washer is installed correctly and safely.
WHAT TO DO IF YOU SMELL GAS • Do not try to the washer must be followed to ...®
Full Size Tumble Action Washers
Before beginning installation, carefully read these instructions near the washer after installation for future reference.
NOTE: The electrical service to light any appliance. • Do ...
Installation Instructions - Page 2
.... (229 cm) high standpipe. In situations where a two-slot receptacle is present, it with the National Electrical Codes, ANSI/NFPA 70 (latest edition).
For higher standpipe, use of this washer with power created by...15 amp. branch circuit fused with ground, 120 volt, single phase, 60 Hz, Alternating Current. time delay fuse or circuit breaker.
If in .
(61 cm) Min. DO NOTcut off or alter...
Installation Instructions - Page 4
... and save the styrofoam base and shipping plug. Floor MUST be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. To ensure vibration or movement does not occur, reinforcement of door. Cut the shipping carton along the dotted line along the bottom. IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove...
Installation Instructions - Page 5
... them in each end of the water valve. hose clips
Zewe/ing the Washer
Excessive noise and vibration can be prevented by hand, then tighten another 2/3 turn with pliers.
Adjust the ...the HOT and COLD water faucets tightly by properly leveling the washen
. Carefully return the washer to the outside "H" outlet of the inlet hoses.
these
4. Run some water from the plastic bag located in ...
Installation Instructions - Page 6
...washer tub) to the standpipe, inlet hose, laundry tub, etc.
Attach drain hose hanger (shipped in personal injury, property damage or damage to cover every possible condition and situation that will save you time...wiring diagram and technical data sheet are needed for your
i Mlauanxidmeurimng btaesnkesf.its and enjoyment are not meant to the washer.
Placeall materials
in a garbage...
Similar Questions
Washer Will Not Start
There is power to the washer and items light up. Washer was running, opened door and added an additi...
There is power to the washer and items light up. Washer was running, opened door and added an additi...
(Posted by Timmcclarnon 6 years ago)
Beeping
Front loading washing machine seems to be working correctly but there is a constant beeping.
Front loading washing machine seems to be working correctly but there is a constant beeping.
(Posted by bobhill 10 years ago)
My Washer Doesn't Start A Cycle Properly.
My washer acts like its going to start a cycle the stops and wont continue.
My washer acts like its going to start a cycle the stops and wont continue.
(Posted by evaheimann 13 years ago)