Kenmore 4810 Support Question
Kenmore 4810 Support Question
Find answers below for this question about Kenmore 4810 - 3.5 cu. Ft. I.E.C. High-Efficiency Washer.Need a Kenmore 4810 manual? We have 2 online manuals for this item!
Question posted by fedgar72 on October 13th, 2012
Kenmore 48102 Doesn't Pour Water
what can I do to fixed?
Current Answers
Related Kenmore 4810 Manual Pages
Operating Instructions - Page 1
... fabric softener.
,, Any water remaining in the dispenser at
the proper time in your laundry items, not every temperature, speed and option is interrupted during the entire wash cycle and the DOOR LOCK indicator will beep 3 times.
7. Closing the drawer too quickly could result in early dispensing of a high efficiency
detergent to the dispenser...
Operating Instructions - Page 2
...rinses are not available options.
To protect your laundry items, all three rinses are selected. Add ...water level. Adjustments tothe cycle will spin slowly for several additional minutes to soak heavily soiled and stained items before the final rinse when the liquid fabric softner is dispensed. For example, High Speed in the Normal cycle is much faster than High Speed in the washer...
Operating Instructions - Page 3
...Temperatures Cold/Cold
Warm/Cold Warm/Warm Hot/Cold Speed High Spin
Medium Spin Low Spin Hang Dry
No Spin ... Settings
,/ Available settings
** Estimated cycle duration is based on factory settings and does not
include water fill times, out-of-balance or oversudsing corrections.
WASHER SETTINGS CHART
The following chart shows the temperatures, spin speeds and options available for each cycle.
Installation Instructions - Page 1
Leave these instructions.
Contents
S UBJECT Pre-lnstallation Requirements Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts
PAGE
2 2 2 2 2 3 4 4-5 5-6 6
Installation and service must be performed by a Sears, Roebuck and Co., qualified installer, service ...
Installation Instructions - Page 2
... Installation: I . Check with a properly grounded three prong grounding type receptacle. Water pressure MUST be connected. cold, 10 psi.) Your water department can result in . (229 cm) high standpipe. The faucets MUST be located so the power supply cord is
accessible when the washer is not recommended.
PRE-INSTALLAT!ON
REQUIREMENTS
Tools Required for electrical...
Installation Instructions - Page 4
... (0 cm) Top = 0 in. (0 cm) When installed in closet: Front = I . LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: I in. (2.54 cm) Closet door ventilation required: 2 Iouvered openings each 60 in2(387 cm2), 3 in ... floor, lay the washer on it will come in contact with a maximum slope of 1/2 in . (7.6 cm) from top and bottom of cardboard to dripping water or outside weather conditions...
Installation Instructions - Page 5
... by hand,
then tighten another 2/3 turn with
pliers. Tighten by hand, then tighten another 2/3 turn with the washer in the holes vacated by properly leveling the washen
. Turn the water on top of the water
valve. For pedestal installations, See additional installation instructions included with pliers.
Remove the 4 plugs from the back panel...
Installation Instructions - Page 6
... in your
i Mlauanxidmeurimng btaesnkesf.its and enjoyment are achieved when all other literature included with
this washer are not meant to the standpipe, inlet hose, laundry tub, etc.
J Operating instructions are needed for ease of the water.
7. Plug the power cord into an outlet.
8.
Cable Tie
Destroy the carton and plastic bags after...
Similar Questions
No Cold Water
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
(Posted by jethalhuber 9 months ago)
How Long Should Rinse Cycle Last In Kenmore Washer ?
My washer took a really long time to wash clothes. When I opened the lid to check, it was just pouri...
My washer took a really long time to wash clothes. When I opened the lid to check, it was just pouri...
(Posted by sstaniforth79 9 years ago)
Can't Change 'options' Feature On Kenmore 48102 Washing Machine.
(Posted by daryldean 10 years ago)
What Does It Mean When A Kenmore Front Load Washer Model # 48102 Turns Off And O
what does it mean when a kenmore front load washer model # 48102 turns off and on during the washing...
what does it mean when a kenmore front load washer model # 48102 turns off and on during the washing...
(Posted by kemackey86 11 years ago)
Pump Change 48102 Washer
(Posted by generoscoe 11 years ago)