Jabra GN1000 Support Question
Jabra GN1000 Support Question
Find answers below for this question about Jabra GN1000 - Wireless Deskphone Headset.Need a Jabra GN1000 manual? We have 1 online manual for this item!
Question posted by wendy40038 on December 7th, 2011
How Do I Get Lifter Arm To Lower?
I have tried to reset to the green icon by holding down the + and - and made sure it was set to the green icon.
Current Answers
Answer #1: Posted by JabraSupport on December 7th, 2011 2:53 PM
JabraSupport
Member since:
October 13th, 2011 Points: 1,597,040
Member since:
October 13th, 2011 Points: 1,597,040
There could be a physical issue with your lifter - you should contact Jabra's Product Support Group to be sure and/or for warranty information. They can be reached by calling 866-697-8757 or by email at [email protected].
Related Jabra GN1000 Manual Pages
Setup Guide - Page 5
.... | English
| Français
| Español
[4.1] Put on your wireless headset and initiale a call by pressing the multifunction button.
[4.2] If the product is set up correctly, lifter arm will hear the dial tone in the headset.
[4.3] If the handset is not lifted correctly, adjust lifter arm's height with lifter arm height control. Hacia "+" sube y hacia "-" baja.
[4.4] Si sigue sin...
Similar Questions
My Gn9350 Wireless Headset Will Ring Even When No Call Is Coming In, Why?
My wireless headset just rings even when no call comes in. What could this be?
My wireless headset just rings even when no call comes in. What could this be?
(Posted by lana0721 9 years ago)
The Remote Lifter To My Headset Wont Raise Up. Is The Programming Off? With The
(Posted by wroberts 11 years ago)
Red Light Flashing On Lifter..not Getting Signal On Headset..
this has just started..I tried readjusting the sensitivity but not working..
this has just started..I tried readjusting the sensitivity but not working..
(Posted by maryhopkins 13 years ago)
How Do You Get The Lifter Arm To Lift The Receiver?
We are setting up our wireless headsets and the lifter arm will not pick the receiver up. The on-lin...
We are setting up our wireless headsets and the lifter arm will not pick the receiver up. The on-lin...
(Posted by nicolestahlecker 13 years ago)