2011 Hyundai Elantra Support Question
2011 Hyundai Elantra Support Question
Find answers below for this question about 2011 Hyundai Elantra.Need a 2011 Hyundai Elantra manual? We have 1 online manual for this item!
Question posted by ayele12021 on June 21st, 2014
How Do I Change F To C On A 2013 Elantra
The person who posted this question about this Hyundai automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
However, Hyundai reserves the right to make changes at the time of optional as well as standard equipment. OWNER'S MANUAL
Operation Maintenance Specifications
All information in this Owner's Manual is current at any ...
Owner's Manual - Page 23
... the lever and make sure the seatback is locked in place. (The lever MUST return to its original position for driver's seat) (if equipped) To change the height of the seat to move the seat forward or rearward: 1. Release the lever and make sure the seat is locked in place. Lean...
Owner's Manual - Page 25
... pulling upward (2). Seat warmer (if equipped) The seat warmer is not needed, keep the switches in the ON position, push either of the seat is changed as follows :
OFF → HIGH( ) → LOW( )
LOW
• The seat warmer defaults to the OFF position whenever the ignition switch is turned on the...
Owner's Manual - Page 37
... "Using a child restraint system" in the locking buckle. To convert from the retractor to allow the installation of a child restraint system, the seat belt operation changes to allow the unbuckled seat belt to extend (Automatic Locking Retractor Type). When it is fully extended from the automatic locking feature to the emergency...
Owner's Manual - Page 46
....
3 28
Since all passenger seat belts move freely under normal conditions and only lock under extreme or emergency conditions (emergency locking mode), you must manually change these seat belts to the automatic locking mode to loosen and compromise the child restraint system. WARNING - E2MS103005
Placing a passenger seat belt into the automatic...
Owner's Manual - Page 72
... of the front bumper, body or B pillars or front door where side collision sensors are installed. This may arise if the sensor installation angles are changed due to impact the locations where air bags or sensors are installed.
Owner's Manual - Page 77
... is not wearing a seat belt during a crash or emergency stop can reduce the protection provided by changing your vehicle's frame, bumper system, front end or side sheet metal or ride height, this may ... interfere with your seat belt on the floor. • Passengers should not move out of or change seats while the vehicle is ON. Adding equipment to or placed on the floor. Safety features of...
Owner's Manual - Page 82
... immobilizer system, whenever you insert your ignition key into the key cylinder and turn it to moisture, static electricity and rough handling. CAUTION
Do not change, alter or adjust the immobilizer system because it could occur.
✽ NOTICE
When starting malfunction. Without a valid ignition key for your vehicle, do not use...
Owner's Manual - Page 83
... cause harmful interference, and 2. Features of your vehicle
This device complies with Part 15 of the FCC rules.
This device may cause undesired operation. WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to the following two conditions: 1.
Owner's Manual - Page 88
... vehicle
CAUTION
The transponder in your manufacturer's vehicle warranty. It is designed to changes or modifications not expressly approved by the party responsible for several years, but if...Immobilizer system malfunction could void the user's authority to moisture or static electricity.
Changes or modifications not expressly approved by your smart key is not working properly, try ...
Owner's Manual - Page 90
... following: two stage unlock mode ↔ central door unlock mode The unlock mode is changed alternately by one pressing the unlock button on the transmitter
Remote keyless entry system operations
Lock...the hazard warning lights will blink and the horn will blink once.
(if equipped) You can change the system to indicate that the driver's door is completed.
✽ NOTICE - Unlock mode ...
Owner's Manual - Page 91
...(CR2032).
If the keyless entry system is inoperative due to changes or modifications not expressly approved by the party responsible for compliance...of the transmitter. Replace the battery with the transmitter, contact an authorized HYUNDAI dealer. WARNING
Changes or modifications not expressly approved by your manufacturer's vehicle warranty. Features of your vehicle
Transmitter ...
Owner's Manual - Page 96
... into the ignition switch, turn the ignition switch to start the engine while the alarm is not disarmed with the mechanical key. CAUTION
Do not change, alter or adjust the theft-alarm system because it could cause the theft-alarm system to malfunction and should only be serviced by your vehicle...
Owner's Manual - Page 97
...the driver's door, turn the key toward the rear of your vehicle
DOOR LOCKS
• Doors can change the system to unlock all doors. (if equipped)
• In cold and wet climates, door locks ... perform the following: two stage unlock mode ↔ central door unlock mode The unlock mode is changed alternately by pressing the lock button and unlock button on the transmitter at the same time for 4...
Owner's Manual - Page 116
... time passes, the steering wheel return to an authorized HYUNDAI dealer and have the vehicle checked as soon as possible. • When you notice any change in low temperature, abnormal noise could occur. Take your vehicle to its normal condition. • A click noise may become difficult to assist you operate the...
Owner's Manual - Page 117
OMD040029 OMD040030
To change the steering wheel angle, pull down the lock release lever (1), adjust the steering wheel to the desired angle (2) and height (if equipped) (3), then pull up ...
Owner's Manual - Page 118
... with both lefthand and right-hand outside rearview mirror is seen.
Outside rearview mirror
Be sure to determine the actual distance of following vehicles when changing lanes. It could result in injury, during an automatic car wash or when passing in the rear seat or cargo area which would interfere with...
Owner's Manual - Page 126
... than 0.03 miles (50 m). or km) This mode indicates the estimated distance to empty based on the current fuel in motion, the average speed keeps changing while the engine is from the fuel consumption input.
If the vehicle speed exceeds 1.6 MPH (1km/h) after being refueled with more than 1.6 gallons (6 l), the average...
Owner's Manual - Page 128
... the engine, check to make sure that does not illuminate should go off . When releasing the parking brake, the brake system warning light should be changed by pressing the TRIP button. The light is displayed if you drive efficiently to improve fuel efficiency. • The ECO indicator (green) will turn the...
Owner's Manual - Page 142
...a bulb may be burned out and will return to use this flashing feature. Turn signals and lane change , move the lever up or down (A). To turn on the instrument panel indicate which turn is ...the turn signal lever slightly and hold it flashes abnormally, one of your vehicle
To signal a lane change signals
The ignition switch must be on and does not flash or if it in the circuit.
...
Similar Questions
How Do You Change From Celsius To Farenheit In A 2012 Hyundai Elantra
(Posted by juickdesr 9 years ago)
How To Change Alternator On Hyundai Elantra 1999
(Posted by toohbab 10 years ago)
2013 Elantra Leaking Oil
I've had my Elantra for just 2 months and discovered it was leaking oil yesterday. Curious to know h...
I've had my Elantra for just 2 months and discovered it was leaking oil yesterday. Curious to know h...
(Posted by daizejane 10 years ago)