Husqvarna YT42XLS Support Question
Husqvarna YT42XLS Support Question
Find answers below for this question about Husqvarna YT42XLS.Need a Husqvarna YT42XLS manual? We have 1 online manual for this item!
Question posted by colinlloyd on April 5th, 2014
What Is The Grass Catcher Designed For The Fabricated Mower Deck On Yt42xls
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Husqvarna YT42XLS Manual Pages
Owners Manual - Page 2
...occur. Too heavy of riding mower-related injuries. Stop the blades when crossing gravel surfaces. • Do not operate machine without the entire grass catcher, discharge chute, or other safety...GENERAL OPERATION
• Read, understand, and follow all times.
• Only allow the mower deck to cool before operating.
Material may lose traction. Allow machine to plow leaves or other...
Owners Manual - Page 3
...or add fuel with the engine running .
• Check grass catcher components and the discharge chute frequently and replace with a machine..., the weight of Pediatrics recommends that has a hitch designed for small children.
Choose a low ground speed so ...angle of grass, leaves, or other objects that children will not have to cool before operating a pedestrian controlled lawn mower and ...
Owners Manual - Page 4
...55 FT. Should you experience any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark ...
0-5,2/8,4 0-2,9/4,7
Charging System: Battery:
15 Amps @ 3600 Rpm
Amp/Hr: Min. It has been designed, engineered and manufactured to give you cannot easily remedy, please contact your nearest authorized service center/department...
Owners Manual - Page 6
... level.
✓ Fuel tank is properly leveled side-to-side/ front-to PSI shown on your tractor were overinflated at the factory).
✓ Be sure mower deck is filled with fresh, clean, regular unleaded gasoline.
✓ Become familiar with all belt keepers.
✓ Check wiring. Correct tire pressure is important for best...
Owners Manual - Page 9
... reduces
the engine's operating efficiency. • Full speed (fast) offers the best mower performance.
When engine is running , hot engine exhaust gases may cause engine to "...to idle before leaving the operator's position.
CAUTION: Always stop engine when stopping tractor on grass areas. IMPORTANT: FORWARD AND REVERSE DRIVE PEDALS RETURN TO NEUTRAL POSITION WHEN NOT DEPRESSED.
N...
Owners Manual - Page 10
...vary depending upon soil conditions, height of grass and types of grass being mowed. • The average lawn should be cut position, gauge wheels should... control feature can be mowed twice.
Make the first cut (see "TO ADJUST MOWER
CUTTING HEIGHT") • Start mower blades by the forward and reverse drive pedals. • Start tractor and release parking...deck in operating position.
Owners Manual - Page 11
... up or down into the slot and
release so it is dangerous. OPERATION
TO STOP MOWER BLADES
• Disengage attachment clutch control.
NOTE: To protect hood from damage when transporting...System (ROS). Use common sense when towing. CAUTION: Do not operate the mower without either the entire grass catcher, on a slope, is necessary to reposition the machine with the attachment clutch...
Owners Manual - Page 14
... until finished (See Fig. 15). Fig. 15 • If grass is extremely tall, it is attached to tractor.
• Mower should be properly leveled for trimming. • Drive so that clippings... load and possible fire hazard from shrubs, fences, driveways, etc. Wet grass will suit the terrain and give the mower cutting performance as well as the quality of clippings and more uniform cutting...
Owners Manual - Page 16
...the disengaged position.
Clean terminals and battery cable ends with stamped "THIS
SIDE UP" facing deck and mandrel assembly.
MAINTENANCE
TRACTOR
Always observe safety rules when performing any attempt by the operator... first setting the parking brake should shut off the engine.
BLADE CARE
For best results mower blades must be checked and adjusted. (See "TO CHECK BRAKE" in the Service and...
Owners Manual - Page 18
... engine will not run properly using a garden hose or pressure washer to clean your tractor. ENGINE COOLING SYSTEM
To ensure proper cooling, make sure the grass screen, cooling fins, and other external surfaces..., causing belt slip and loss of all foreign matter.
• Clean debris from tractor and mower.
18 CAUTION: Avoid all pinch points and movable parts (See Fig. 22)
CLUTCH/BRAKE PEDAL...
Owners Manual - Page 19
... water on your lawn, near enough to a water spigot for your garden hose to a ...level, clear spot on . 6. Move the tractor's attachment clutch control to the "DISENGAGED" position. Turn the water off .
WARNING: A broken or missing washout fitting could expose you or others to using mower again. • Plug any holes in mower with bolts and locknuts.
19 MAINTENANCE
DECK...
Owners Manual - Page 20
... suspension arms (A) are disconnected, the attachment lift lever will be spring loaded. INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED)
ANTI-SWAY BAR (S)
TOWARDS TRANSAXLE
TOWARDS MOWER DECK
90° END
INTEGRATED WASHER END
Fig. 25
A
M
F
OP
Q
C E
H
D S B D
Fig. 24
20
Have a tight grip on lift lever, lower it is centered under right side ...
Owners Manual - Page 21
.../location.
• Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on opposite side of this manual. Insert integrated washer end of bar into hole in...and loosely install nut (P) and jam nut (Q).
• Insert flared ends of link (E) into rear mower bracket (D).
• Secure with washer and retainer spring.
• Repeat on right side of tractor....
Owners Manual - Page 22
...mower height about 3/16".
• Test your lawn and lead you are properly inflated to its highest position. CAUTION: Blades are equal.
FRONT-TO-BACK ADJUSTMENT (See Figs. 34 & 35) IMPORTANT: Deck... of mower, position blade at front and rear tip of adjustment nut will change mower height about...mower is cutting lower. If tires are sharp.
To obtain the best cutting results, the mower...
Owners Manual - Page 23
... position. • Remove mandrel covers. • Remove any twist.
You may have any dirt or grass clippings which may also check brake by: • Park tractor on the belt. • Carefully roll the... slip the belt onto the center spindle pulley. MOWER DRIVE BELT INSTALLATION (See Fig. 37 & 38) NOTE: For ease in installing the deck belt, refer to stop at highest speed in the...
Owners Manual - Page 28
...7. Dirty fuel filter. 5. Check/replace solenoid or starter. 9. Corroded battery terminals. 3. Dirty/clogged muffler.
12. Tighten blade bolt. 2. Engine flooded. 4. Carburetor out of grass, leaves, trash under mower. 3. Engine not "CHOKED" properly. 3. Clean/replace air filter. 6. See "To Adjust Carburetor" in fuel.
8. Check/replace solenoid or starter. Build-up of adjustment...
Owners Manual - Page 29
...See Operation section.
29 If not corrected, contact an authorized service center/ department. Mower deck not level. 3. Clean underside of mower housing.
8. Worn, bent or loose blade.
6. Mower drive belt worn.
8. of grass, leaves, trash under mower. 4.
Faulty regulator (if so equipped). 4. Replace battery. 2. Check/clean all connections. 3. Freewheel control...
Owners Manual - Page 32
..., rods, height adjusters, caster/anti scalp
wheels
are NOT covered:
(a) Abrasion to mower decks, including sand wear;
(b) Damage to cutting equipment by anyone other materials due to ...or failure occurs.
9. Reinforced Stamped (Armor Protected) 10 Year Limited & Fabricated Limited Lifetime, Deck Warranties. These Limited Warranties are for warranty service under this Limited Warranty, ...
Owners Manual - Page 33
...Expendable Components Residential Zero Turn Mowers ( MZ & EZ )
Engine* Transmission **
MZ5424S & MZ5425S (967003901 & 25021) stamped deck shell. stamped deck shell. Limited Lifetime Warranty... Warranty No Warranty No Warranty
* **
No Warranty
Fabricated Deck shell. Armor
Protected Limited Warranty
10 Years
No Warranty
Fabricated Deck shell. Armor Protected Limited Warranty
10 Years ***
1...
Owners Manual - Page 34
...
MZ -
Armor Protected Stamped Deck Shell Example Below
Fabricated Deck Shell Example Below
Armor Protected Stamped Deck Shell
Reinforced area
Stamped Deck Shell below, NOT reinforced No ...usage)
1 Year
Robotic Mowers
Robotic Mower
2 Years
90 days
90 days
Battery
1 Year
1 Year
1 Year
Parts & Accessories (if purchased) Accessories (e.g., grass catcher, bumper guard accessories,...
Similar Questions
Tips Wanted For Replacement Of Mower Deck Lift Linkage
I will be trying to replace the lift linkage for the mower deck lift on my Husqvarna YTH23V48, which...
I will be trying to replace the lift linkage for the mower deck lift on my Husqvarna YTH23V48, which...
(Posted by stevesalonen 7 years ago)
Have A New Yt42 Xls Scalps Grass So Bad Why Is There No Anti Scalp Wheels.
Although there is in my opinon a useless nose roller that does nothing unless your cutting at the 1"...
Although there is in my opinon a useless nose roller that does nothing unless your cutting at the 1"...
(Posted by tlhemmme 8 years ago)
Safety Switch On Yt42xls
My new Husqvarna YT42XLS won't start, where is the safety switch on the mower.
My new Husqvarna YT42XLS won't start, where is the safety switch on the mower.
(Posted by sh065 10 years ago)
Wobble Feeling When Mower Deck Rotates
When the mower is engaged there seems to be a wobble feeling as if something is not aligned properly...
When the mower is engaged there seems to be a wobble feeling as if something is not aligned properly...
(Posted by leepropp 10 years ago)
Problem With Low Power In Reverse.
I have a brand new husqvarna 42XLS, bought today. The first cut has gone well, but it seems to have ...
I have a brand new husqvarna 42XLS, bought today. The first cut has gone well, but it seems to have ...
(Posted by Woolfgroup 11 years ago)