Home » Husqvarna » Lawn Mowers » Husqvarna RZ4623

Husqvarna RZ4623 Support Question

Find answers below for this question about Husqvarna RZ4623.
Need a Husqvarna RZ4623 manual? We have 3 online manuals for this item!

Husqvarna Overview Questions Manuals Reviews Videos Research

Question posted by patcassie61 on October 23rd, 2014

Mower Going Slow

checking hydrolic fluid and bypass valve on pump model RZ4623 mower going slow belt tight

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on October 23rd, 2014 10:18 AM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,813

1,100
points

Read "Trouble o Slope" below

http://www.doityourself.com/stry/troubleshooting-common-selfpropelled-lawn-mower-problems#b

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Husqvarna RZ4623 Manual Pages

Owners Manual - Page 5

...potentially dangerous if used improperly. Lawn mowers and all who are subject to your dealer for the accessories are used for mowing grass on lawns and even ground without obstacles... Operating This machine is built for purchasing a Husqvarna ride-on Public Roads Check applicable road traffic regulations before using or servicing the machine. INTRODUCTION Congratulations Thank...

Owners Manual - Page 13

... must not be started when the driver's floor plate or any protective plate for the mower deck's drive belt is extremely flammable and the vapors are explosive. • Extinguish all times until problem has been resolved. • Check the fuel level before refueling. 13 Never fill the fuel tank indoors 8011-516 WARNING...

Owners Manual - Page 14

... your skin, rinse immediately with manufacturer's recommended parts, when necessary. • Mower blades are considered to cause cancer, birth defects, and other protective devices. •...tight to be sure the equipment is in good condition. 8011-515 Never drive the machine in an enclosed space WARNING! Wrap the blade or wear gloves, and use extra caution when servicing them. • Check...

Owners Manual - Page 16

... order by the operator. This mower is not sufficient to lock the machine in storage. • Regularly clean deck and underside of suitable strength using a slow speed. Transport • The machine... jackknife or overturn causing damage to the mower and possibly serious injury to the operator. • Load the unit onto truck or trailer by escaping fluid, see a doctor at once. The ...

Owners Manual - Page 23

Hour meter Tracking Knob If the mower is pulled up, after the interval. Tracking must be moved backward or forward. Rotate .../ 1 bar) for all tires. The hour meter cannot be adjusted lengthways. CONTROLS Seat Adjustment Lever The seat can be checked on a flat and level concrete or blacktop surface. Lengthways adjustment Hour Meter The hour meter displays the total operating time. ...

Owners Manual - Page 24

... other people or vehicles/obstacles nearby. Pull back slightly on control levers to the furthest forward or reverse positions during initial operation, or until the mower stops or slows dramatically. To turn in that this section be in the seat, start moving control levers to the neutral position and...

Owners Manual - Page 25

...parking brake by pushing the release button on the top of the lifting lever. Mower deck lifting lever 8058-019 Pull parking brake upwards to the desired position. operation...mower blades by pressing the blade switch downwards. 8058-020 Blade switch 8058-134 25 The following conditions must be fulfilled before starting (see Maintenance Schedule in the Maintenance section). • Check...

Owners Manual - Page 31

... be used without negatively affecting the mowing result. • The finest lawns are obtained by the blades. When cleaning, the mower deck shall be raised into the soft lawn, clumps build, and the grass clippings fasten under the cowling. • Hose the mower deck underside with a high engine speed (the blades rotate rapidly) and...

Owners Manual - Page 34

.../clean the engine's cooling air intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt pulleys Check the tire pressures Before After Check battery connections Sharpen3)/ Replace mower blades Clean the engine's cooling...

Owners Manual - Page 35

... throttle cable Check the condition of belts, belt pulleys Change the engine oil 1) Replace the engine oil filter Clean/replace the spark plugs Replace the fuel filter Replace air filter 2) (paper filter) Check the caster wheels (every 200 hours) Replace the air cleaner's pre-filter 2) (foam) Check/adjust the mower deck Check the engine valve clearance 3) Perform the...

Owners Manual - Page 36

...8226; Keep battery and terminals clean. • Keep battery bolts tight. • See chart for the terminal screws. Replace terminal ...BLACK battery cable then RED battery cable. 3. Adding or checking level of the battery with terminals in Step 4. 8.... bracelets, wristwatch bands, rings, etc. MAINTENANCE Battery Your mower is not necessary. WARNING! Always wear eye protection when around...

Owners Manual - Page 37

...of these conditions is free from dirt. Fuel Pump Air Filter Regularly check that the safety system works by attempting to drive, the... driver must sit in the outer, locked neutral position. 3. Fuel pump air filter 8009-147 37 The mower deck is not met. Change the conditions and try again. Remove the screws and open the pump...

Owners Manual - Page 41

...189;" higher in frontto-rear manner. NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be properly adjusted. If the front blade tip does not measure 1/8" to...mower is on the discharge side of the mower deck. If adjustment is the same. See "Technical Data" under or over inflated, the deck cannot be installed prior to raise. Move to the opposite side, check...

Owners Manual - Page 43

... use the spinning action to wash away debris. Restart the mower and engage the blades to the tires. Make sure the hose is cooled), before washing. IMPORTANT INFORMATION Use protective glasses when cleaning and washing. MAINTENANCE Caster Wheels Check every 200 hours. For models fitted with normal water pressure. Clean regularly 8058-084...

Owners Manual - Page 47

...; Parking brake on • Bypass valve on pump open • Drive belt for the transmission slack or has come off • Air trapped in hydraulic system • Drive belt for the mower deck has come loose •... the left and right sides. • Bent blades • Suspending for the mower deck is uneven • Blades are dull • Driving speed too high • Grass is too ...

Owners Manual - Page 48

...Empty the fuel tanks or add a fuel stabilizer. Service When ordering spare parts, please specify the purchase year, model, type, and serial number. It is a good way to the fuel in the tank or in a ...stabilizer has reached the carburetor. 5. An annual check-up damage to the paint and spray a thin layer of oil on the underside of the mower deck to the sticky residues that can cause ...

Owners Manual - Page 5

... improperly. Operating instructions for the accessories are documented. All other hazards. Lawn mowers and all who are incorrect. This machine is a valuable document. The...grass on public roadways. General In this machine on lawns and even ground without notice. Driving and Transport on Public Roads Check applicable road traffic regulations before using or servicing the machine...

Owners Manual - Page 16

... into a truck or trailer using a slow speed. Never allow extra distance to penetrate...tow this machine on public roadways. • Check and abide by escaping fluid, see a doctor at once. Follow the... manufacturer's recommendation for weight limits for the muffler is not intended to be maintained in effective working order by the operator. This mower...

Owners Manual - Page 42

... or environmental conditions, additional adjustments may be installed prior to the bottom of leveling procedure, mower deck drive belt must be required to -side measurements are equal. MAINTENANCE Adjusting the Mower Deck Leveling deck Adjust the deck while the mower is the same. Set blades to the highest (transport) position. Measure from the floor...

Owners Manual - Page 47

...brake on • Bypass valve on pump open • Drive belt for the transmission slack or has come off • Air trapped in hydraulic system Mower deck not engaging • Drive belt for the mower deck has come loose ...the left and right sides. • Bent blades • Suspending for the mower deck is uneven • Blades are dull • Driving speed too high • Grass is ...