Husqvarna MZ 6128 Support Question
Husqvarna MZ 6128 Support Question
Find answers below for this question about Husqvarna MZ 6128.Need a Husqvarna MZ 6128 manual? We have 2 online manuals for this item!
Question posted by scottdixiescott on April 25th, 2015
Mz6128 Won't Start.
mz6128 would start and run but sometimes would not start when hot. Now it will not start at all. No clicking when trying but battery is fully charged. Must be a safety switch but do I check everyone of them. Are ther any internal?
Current Answers
Answer #1: Posted by TechSupport101 on April 27th, 2015 3:48 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Your safety switches are 4
- Seat
- Mower
- Steering wheel controls
- Parking brake
Related Husqvarna MZ 6128 Manual Pages
Owners Manual - Page 1
English Operator Manual
MZ6128 / 966502301 MZ28ZT BF / 966582501
FD52M / 966582601 FD61M / 966582701
Please read the operator's manual carefully and make sure you understand the instructions before using the machine.
Owners Manual - Page 3
... Blade Switch 20 Ignition Switch 20 Fuses 21 Cutting Height Adjuster 22 Fuel Shut Off Valve 22 Refueling 23 OPERATION 24 Training 24 Steering 24 Before Starting 25 Starting the Engine 25
Jumper Cables 28 Running 29 Operating on Hills 30
Stopping the Engine 31 Mowing Tips 32 Manual Transport 33 MAINTENANCE 34 Battery 36 Safety System...
Owners Manual - Page 5
...Transport on mower.
Operating
This machine is constructed only for purchasing a Husqvarna ride-on Public Roads
Check applicable ...for any resulting personal injury or property damage.
5 Lawn mowers and all who are used in relation to change without... right, backward and forward are also knowledgeable about the safety instructions. The machine can also considerably increase the life ...
Owners Manual - Page 9
...running machine unattended. Always turn off engine and wait for your safety. Shut off blades, set parking brake, stop before cleaning the machine, removing the grass catcher, or unclogging the discharge guard.
• Operate machine only in the manual before starting...THROWING OBJECTS. Stop machine if anyone . SAFETY
Safety Instructions
These instructions are familiar with the ...
Owners Manual - Page 13
...the exhaust system become very hot during operation. Safe Handling of...problem has been resolved.
• Check the fuel level before each use gasoline...
13 There is risk for the mower deck's drive belt is not possible... or trailer bed with the engine running.
Allow engine and exhaust system to...started when the driver's floor plate or any protective plate for burns if touched.
SAFETY...
Owners Manual - Page 14
... glasses for damaging the machine components.
• Be very careful when handling battery acid. Check their proper operation regularly.
• Keep machine free of governors and avoid running .
• Check grass catcher components and the discharge guard frequently and replace with safety devices. Wrap the blade or wear gloves, and use extra caution when servicing...
Owners Manual - Page 20
...start the engine. The mower blades are disengaged when the knob is found on the control panel and is used to release it. Ignition switch 20
8058-044 8058-043 8058-043
Blade switch
Ignition Switch... Switch
To engage the mower deck, pull the blade switch knob out.
Always set the parking brake before moving the mower. CONTROLS
Parking Brake
The parking brake is pressed down fully....
Owners Manual - Page 21
... functions:
1. 20 A, Primary fuse
2. 7.5 A, Mower deck coupling
Ignition switch - There are accessed by tilting the seat forward. Fuses are located on the left hand side of the machine. accessory
Fuses
8066-005
8011-420
21 Ignition switch - CONTROLS
Release the key to the RUN position when the engine has started.
RUN position For using "accessory", turn...
Owners Manual - Page 24
...or blacktop PRIOR to attempting to operate on control levers to start moving backwards. Additionally, we suggest when first operating the mower, use a reduced throttle speed and reduced ground speed by ... mower under its own power. First time users should stop moving control levers to the forward position and the other people or vehicles or obstacles nearby. OPERATION
Read the Safety ...
Owners Manual - Page 25
... the lift pedal fully forward. 3.
Raise the mower deck to the transport position
8058-048
25 OPERATION
Before Starting
• Read the sections Safety Instructions and Controls before starting the machine.
• Perform the daily maintenance before starting
8058-044
Starting the Engine
1. Activate the parking brake. The blade switch for engaging the mower blades must be fulfilled...
Owners Manual - Page 28
... chassis and then
from the fully charged battery. • Remove RED cable last from batteries. If "jumper cables" are used for emergency starting, follow this procedure:
Jumper Cables • Connect each end of the BLACK cable to the EFM Information Sheet from the fuel tank and battery.
Do not use the mower to start other vehicle must also...
Owners Manual - Page 30
... the mower and press forward to the center of the unit and engage the parking brake. Do not drive across slopes.
• The slowest speed possible should be used before starting up ... mower to suddenly stop.
• To restart movement, release the parking brake.
• Pull the control levers back to regain forward motion.
• Make all turns slowly.
Place controls in the Safety ...
Owners Manual - Page 32
...lawn should be cut relatively high; Make sure the mower...changes.
32 For healthier and better looking lawns, mow often after each use. the...that slopes more often. The lawn becomes more even and the ...the mower deck shall be increased without poor mowing results.
• Avoid mowing wet lawns. Mowing...lawn, clumps build, and the grass clippings fasten under the cowling.
• Hose the mower...
Owners Manual - Page 34
... refueling) Check the safety system Check for fuel and oil leakages Check/clean the engine's cooling air intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt pulleys Check the tire pressures Check battery connections Sharpen3...
Owners Manual - Page 37
... an accident. If the machine starts when one of the conditions is on the lever, links, or switch belonging to the parking brake....Safety System
This machine is not met, turn the machine off the driver's seat. The mower deck is sufficient braking action. Check that there is disengaged.
2.
specified tires. Perform a standstill test and check that the engine stops if the mower...
Owners Manual - Page 47
...Check the oil level and add oil as required after short term operation. • High operation temperature and excessive
expansion of power or drive after stopping the engine. 4. With the bypass valve closed and the engine running...efficiency in hydrostatic drive applications, it is purged from the system. Before starting, make sure the oil tank is at normal speeds, the hydraulic drive is ...
Owners Manual - Page 48
...Engine runs rough.
• Dead battery. ...Cause
• Blade switch is engaged. • Steering controls are not locked in the neutral
position. • Parking brake is not activated. • Battery is dead. •...Wrong fuel type. • Water in the starter safety circuit.
Starter does not turn the engine over. See Safety
System in the Maintenance section
• Faulty carburetor...
Owners Manual - Page 49
... connectors.
• Charging lead is disconnected. • Fault in engine charging system.
• Parking brake on. • Bypass valve on the left and right sides. • Bent blades. • Suspension for the electromagnetic coupling has loosened.
• The blade switch is too long. • Grass collected under the mower deck.
49 Engine overheats. Battery not charging.
Owners Manual - Page 50
...axles.
7. Clean, charge, and store the battery in the storage container.....
8. dispose of the mower deck to the paint and... and serial number. An annual check-up damage to avoid corrosion....run until the carburetor is evenly distributed and then refit the spark plug.
6. Handle the fuel with open flame. Start the engine and allow it reaches the carburetor. Store the machine in a boiler, hot...
Owners Manual - Page 57
... and advantages of all wheels to the cable for the parking brake. Adjust the tire pressure of following the service schedule. Engaging the blades. 12. Check that the right amount of leaving the machine for service. No remaining notes. Check the mower deck adjustment. 11.
Charge the battery. 2. Check:
Safety switch for the seat's safety switch. 5.
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
My Husqvarna Mz6128 Will Not Start.
Good battery. Tried jumping solenoid and still nothing. Checked fuses, had one bad 20 a fuse replace...
Good battery. Tried jumping solenoid and still nothing. Checked fuses, had one bad 20 a fuse replace...
(Posted by fjmeyers68 3 years ago)
Husqvarna Mz6128 Zero Turn Started And Ran Fine But Now Have To Put Gas In Intak
My MZ6128 started and ran fine I engaged pto and it cut for like 30 seconds and cut off. I cut pto o...
My MZ6128 started and ran fine I engaged pto and it cut for like 30 seconds and cut off. I cut pto o...
(Posted by monealbritt 8 years ago)
The Mower Will Start The Blades Will Turn But It Wont Drive
(Posted by erickmorris89 8 years ago)
