Husqvarna MZ 6128 Support Question
Husqvarna MZ 6128 Support Question
Find answers below for this question about Husqvarna MZ 6128.Need a Husqvarna MZ 6128 manual? We have 2 online manuals for this item!
Current Answers
Answer #1: Posted by TheWiz on May 18th, 2015 3:43 PM
TheWiz
Member since:
October 13th, 2011 Points: 25,383,424
Member since:
October 13th, 2011 Points: 25,383,424
Related Husqvarna MZ 6128 Manual Pages
Owners Manual - Page 3
...Deck Belt 38 Pump Belt 39 V-belts 39 Cutting Blades 40 Adjusting the Mower Deck 41
Leveling deck 41 Anti-scalp rollers 42 ...Caster Wheels 43 Hardware 43 Cleaning 43 LUBRICATION 44 Lubrication Schedule 44 Wheel and Deck Zerks 45
Front Wheel Mount 45 Front Wheel Bearings 45 Deck Spindles 45 Transaxle (Transmission) Fluid Change...
Owners Manual - Page 5
...General
In this machine is easily accessible to the machine's normal driving direction. Lawn mowers and all who are also knowledgeable about the safety instructions. Read the contents ...equipment. It can also be operated, maintained, and repaired by steering controls both contribute to change without fail. All other hazards. A control panel that service and repair work are subject ...
Owners Manual - Page 11
...disengage the blades and proceed slowly straight down , not side to roll over.
• Use extra care while operating machine with slopes greater than 10 degrees. Do not make sudden changes in ...glasses or a full visor when assembling or driving.
• Always wear gloves when handling the blades.
• Never wear loose clothing that can hide obstacles.
• Choose a low ground ...
Owners Manual - Page 13
... Never remove gas cap or add fuel with plastic liner. Always place containers on clothing, change clothing ...immediately.
• Never overfill fuel tank. Never fill the fuel tank indoors
8011-516
WARNING! Allow engine and exhaust system to expand and overflow. The engine must not be started until fueling is an open device.
• If fuel is risk for the mower...
Owners Manual - Page 14
... or fuel spillage and remove any adjustments or repairs with the engine running the engine with manufacturer's recommended parts, when necessary.
• Mower blades are sharp. Acid on...protective plates, protective cowlings, safety switches, or other protective devices.
• Do not change the settings of grass, leaves, or other reproductive system damage. The battery contains lead...
Owners Manual - Page 19
... Tracking adjustments are made using the tracking knob. The CHG OIL icon will flash CHG OIL (Change Oil) at 50 hour intervals. Recommended air pressure for the motion control levers when in the ...bar).
1. CONTROLS
Hour Meter
The hour meter displays the total operating time. Tracking
If the mower is one hour before and one hour after the interval. For preliminary tracking adjustment, move unit ...
Owners Manual - Page 20
... backward to activate the brake and push forward to release it. IMPORTANT INFORMATION The machine must stand absolutely still when applying the parking brake.
The mower blades are disengaged when the knob is placed on the left of the machine. Ignition switch 20
8058-044 8058-043 8058-043
Owners Manual - Page 24
...the neutral position and mower should push mower (see Before Starting in the Operation section), adjust engine speed to idle, disengage parking brake, do not engage blades at this will slow...OPERATION
Read the Safety Instructions section and the following pages if you are unfamiliar with mower controls and zero turning capability, they return to neutral when released. Training
Zero turn...
Owners Manual - Page 26
Press the control for disengaging the mower deck
8058-043
6.
Disengage the mower blades by depressing the blade switch.
5. Move the steering controls outward to the middle position. Place controls in neutral position
80661-012
Set the throttle
80658-050
26 Move the throttle to the locked (outer) neutral position. OPERATION
4.
Owners Manual - Page 29
... two steering controls. When the engine is running, any attempt by the rotating blades.
8058-044
WARNING! Parking brake
3.
The machine's speed and direction are in a straight line forward or backward respectively.
8065-017
8065-016
Engage the mower deck and move the throttle to FULL
29 By moving the lever downward...
Owners Manual - Page 31
... temperature before stopping. Disengage the mower deck by pressing the foot pedal forward to minimum
2. To prevent unauthorized use, always remove key when leaving the mower. To prevent fouling the spark ...Engine
Move the throttle to stop position.
5. Raise the mower deck by depressing the blade switch.
8058-046
Disengage the mower deck and move throttle to the transport position.
3. When...
Owners Manual - Page 32
... by the blades. Make the first cut to the desired height.
• The mowing result will be best with a high cutting height and reduce it is important that the mowing interval is attained. Clear the lawn of the deck. Mowing pattern
8011-603b
WARNING! Avoid sudden directional changes.
32 The average lawn should be...
Owners Manual - Page 34
... engine Clean around belts, belt pulleys Check the tire pressures Check battery connections Sharpen3)/ Replace mower blades Clean the engine's cooling air intake 2) Clean the air cleaner's pre-filter 2) (foam...manual ♦ = Not described in hours
50
250
500
●●●
1) First change after 8-10 hours. When operating with a heavy load or at high ambient temperatures, replace...
Owners Manual - Page 35
... 2) (foam) Check the hydraulic oil in the oil tank Change the hydraulic oil (every 500 hours) Replace the hydraulic oil filter ... and inspect starter 3) (every 500 hours) Check/adjust the mower deck Check the engine valve clearance 3) Perform the 500-hour ...manual ■ = Refer to "OFF" position and remove the key. • Make sure the blades and all moving parts have completely stopped. • ...
Owners Manual - Page 37
... to the drive tires. WARNING! maintenance
Safety System
This machine is disengaged.
2.
The mower deck is equipped with a safety system that the safety system works by foam filled tires... or driving under the following conditions. Change the conditions and try again. Perform a standstill test and check that the engine stops if the mower blades are in the outer, locked neutral ...
Owners Manual - Page 41
... should be level to -side manner. Additional adjustment may be level in a side-to 1/8" lower than sideto-side measurement. Blades are inflated to achieve desired cut for the type of leveling procedure, mower deck drive belt must be level to 1/8" higher than the side-to -side measurement. Front lift arm 2. The deck...
Owners Manual - Page 46
...This will take approximately 23 additional ounces).
13. Filter guard 2. LUBRICATION
Transaxle (Transmission) Fluid Change
This transaxle is reached (this will allow the transaxles to vent during oil fill. 9. Apply...laws in the mower and the mower on level ground. Install the new filter by hand. Remove the top port plug (see illustration) from the transaxle.
10. Remove the oil filter ...
Owners Manual - Page 49
...; Parking brake on. • Bypass valve on the left and right sides. • Bent blades. • Suspension for the mower deck is uneven. • Blades are incorrectly balanced. • Engine is too long. • Grass collected under the mower deck.
49
Engine overheats. Machine moves slowly, unevenly, or not at all.
• Poor contact...
Owners Manual - Page 61
Change air filter 9. Check blade pitch 14. Inspect idler arm bearings 18. Inspect hydraulic drive belt 22.... throttle cable 5. Inspect hardware 6. Inspect spindle bearings 16. Inspect deck idler pulleys 19. Inspect hydraulic filter 21. Grease blade spindles 15. Check neutral position 24. Inspect battery connections 25. SERVICE JOURNAL
Action
100-Hour Service
1. Inspect frame 4....
Owners Manual - Page 62
... 16. Check neutral position 23. Check safety system 25. SERVICE JOURNAL
Action
300-Hour Service
1. Inspect throttle cable 5. Change air filter 9. Inspect deck belt and blades 17. Inspect the clutch 24. Inspect hardware 6. Check blade pitch 14. Replace hydraulic drive belt 21. Inspect battery connections 24. Inspect safety guards and shields 28. Check...
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
The Mower Will Start The Blades Will Turn But It Wont Drive
(Posted by erickmorris89 8 years ago)
Husqvarna Mz 6128 20 Amp Fuse Keeps Blowing
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
(Posted by JonathanWilliams2961 9 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)
Mower Won't Start
Was mowing.....got off the mower & won't restart.
Was mowing.....got off the mower & won't restart.
(Posted by bobbirkimer 10 years ago)