Husqvarna K 970 Support Question
Husqvarna K 970 Support Question
Find answers below for this question about Husqvarna K 970.Need a Husqvarna K 970 manual? We have 2 online manuals for this item!
Question posted by Only1greg on November 20th, 2019
Correct Fuel Oil For Husqvana K970 1:50 Or 1:33
I have seen husqvana site saying that under 75cc is 1:50 and over 75cc is 1:33 which is it
Current Answers
Answer #1: Posted by hzplj9 on November 21st, 2019 3:33 AM
hzplj9
Member since:
June 25th, 2012 Points: 4,875,690
Member since:
June 25th, 2012 Points: 4,875,690
According to the Husqvana document link attached.
The fuel mix is 1:50 unless a different oil is used. You should check the oil and refer to the document to see which oil you have.
1:33 (3%) with oils class JASO FB or ISO EGB
Hope that helps.
Related Husqvarna K 970 Manual Pages
Owners Manual - Page 3
...authorised dealer for adjustment of cutting height 10 Seat,Rider 850 HST 10 Seat, Rider 970 HST 11 Fuelling 11 Driving 12 Before starting 12 Starting the engine 12 Driving the...the blades 26 Checking the tyre pressure 6 Changing the oil 27 Lubrication 27 Checking and adjustment of throttle wire ......... 28 Replacement of fuel filter 28 Trouble shooting schedule 29 Storage 30 Winter ...
Owners Manual - Page 4
...
Engine off the ignition cable before driving
Speed limiter pedal forwards Neutral Speed limiter pedal reverse
Switch off the engine and take off
Battery
Choke
Fuel
Oil pressure Cutting height
Backwards
Forwards
Ignition
Use eye and hearing protection
Clutch in
Clutch out
Parking brake
Hydrostatic free wheel
!
English
Rotating blades. Brake
Warning...
Owners Manual - Page 7
... not try to children in the vicinity of mowing.
SAFETY INSTRUCTIONS
• Do not cut wet grass. c.
They can emit sparks.
• Check the fuel level each time before filling up with fuel. RIDER 970
Never fill up with fuel indoors.
5 English - Never fill up with fuel indoors. Be extra careful when handling petrol/gasoline.
Owners Manual - Page 8
...with defective or unmounted safety devices.
• Do not alter the setting of the brakes regularly. RIDER 970
Clean the machine regularly from grass, leaves and other waste.
6 - Allow the machine to cool ...Wrap over an object.
Never drive the machine in the vicinity of the battery or the fuel. If acid gets into the eyes this can explode and cause severe injuries.
• ...
Owners Manual - Page 9
... parking brake 9. Lock button for driving forwards
10
11
7. PRESENTATION
Presentation
These instructions describe two machine models, Rider 850 and Rider 970.
Throttle/Choke lever 3. Lifting lever, cutting unit 5. Brake pedal 8. Fuel tank cap 11. Ignition lock 2. Both models are fitted with the foot pedals. respectively.
Speed limiter for reversing. Lever for...
Owners Manual - Page 10
... the
button pressed. The lock on the steering column. 3. PRESENTATION
Throttle and Choke lever
The engine speed is used the engine receives a richer mixture of fuel and air, which simplifies cold start.
English Press in the lock button on the parking brake automatically disconnects when the brake pedal is steplessly regulated...
Owners Manual - Page 13
.../gasoline (not oil mixed).
!
Release the knobs under the seat and adjust it forwards or backwards to the required position. Fuelling
The engine should be run on the front edge and can also be tipped forward. The seat can be adjusted lengthways.
WARNING! English - 11 Lock the setting with fuel outdoors (see...
Owners Manual - Page 16
DRIVING
Driving the machine
1. To reverse: press down one of the pedals until the correct speed is reached. English
Carefully press down pedal (2).
2
1
RIDER 850
14 - To drive forwards: press down the brake pedal.
2. Release the parking brake by pressing down pedal (1).
Owners Manual - Page 19
... plug.
r = Not described in hours
25
50
100
Check the engine's oil level Check the engine's cooling air inlet Check the fuel pump's air filter Check the steering wires Check ...the brakes Check the battery Check the safety system Check screws and nuts Check for fuel and oil leakage
19
q
19
q
19
q
20
q
20
q
21
q
21
q
- English - 17 r
-...
Owners Manual - Page 21
... damage the engine. If the level approaches the ADD mark, top up with oil to the FULL mark. The oil is free from leaves, grass and dirt. Check the oil level. Dismantle the engine hood as described on dip stick.
Check that the fuel pump's air filter is filled in the engine is horizontal.
Owners Manual - Page 22
... be tensioned by releasing the screws (two on each side of the steering rim. MAINTENANCE
Checking and adjustment of the steering wires
The steering is correctly adjusted by placing the machine on a slight downward slope and applying the brake.
Owners Manual - Page 23
...doctor as soon as possible. Batteries emit explosive gas. Check the transmission's oil level by removing the transmission cover. Top up the cells with only distilled ... of the battery acid
Check that the oil level lies between the markings.
Check daily the safety system functions. MAINTENANCE
Check the transmission's oil level
1. Unscrew the oil cap and check that the level of water...
Owners Manual - Page 24
...therefore important to replace the air filter at regular intervals (see maintenance schedule on page 17 for correct service interval). MAINTENANCE
Replacing the air filter
If the engine seems to lack power or goes irregularly...
22 - Drench it dry in an absorbent cloth and squeeze out excess oil.
Fit the air filter as follows: Push the pre-filter over the paper filter. Fit the paper ...
Owners Manual - Page 31
..., resulting from
damage or inferior balancing after sharpening. Engine seems to have no oil in carburettor or fuel pipe. • Carburettor incorrectly set . • Air filter clogged. • Fuel tank vent blocked. • Ignition setting defective. • Dirt in carburettor or fuel pipe.
TROUBLE SHOOTING SCHEDULE
Problem
Engine will not start.
Starter does not...
Owners Manual - Page 32
... is an acceptable alternative to distribute the oil and screw the plug back on.
6. Empty the fuel tank.
Fuel which can come into contact with the engine. Fuel stabiliser is a good way of getting the... loose screws and nuts.
3. Pull round the engine to avoid tacky deposits during storage. RIDER 970
RIDER 850
RIDER 850
30 - STORAGE
Winter storage
At the end of the season the machine ...
Owners Manual - Page 33
... Displacement Fuel
Tank volume Oil
Oil volume Start
Electrical system Type Battery Spark plug
Transmission Manufacture Oil
Cutting unit... Type Cutting width (Bioclip) Cutting height Blade diameter (Bioclip)
NOISE LEVEL
Rider 850
2000 mm 960 mm
1060 mm 225 kg 820 mm 625 mm 16 x 6.50 x 8 60 kPa (0.6 kp/cm2)
15°
Rider 970
2145 mm 1050 mm (970-15.5), 1260 mm (970-15.5S) 1120 (970...
Parts Manual - Page 2
... 506 33 08-01 506 33 49-02 506 33 49-03 506 33 51-01 506 33 52-01 506 33 53-01 506 33 53-02 506 33 54-01 506 33 56-15
506 33 56-50 506 33 65-01 506 33 96-...BLADE GUARD GROMMET
COMPRESSION SPRING TANK CAP ASSY COMPRESSION SPRING STARTER PULLEY RECOIL SPRING WHEEL SPACING SLEEVE FUEL FILTER FUEL FILTER ASSY HOSE CLAMP
WEAR PROTECTION PULLEY BELT TENSIONER ASSY BELT GUARD GASKET NIPPLE FILTER SPACING ...
Parts Manual - Page 3
...CARBURETTOR HANDLE DECAL DECAL DECAL START INSTRUCTION SEALING DRIVING PULLEY ASSY DECAL BALL BEARING
FUEL HOSE COVER CABLE LEVER SPRING ANTIVIBRATION ELEMENT ANTIVIBRATION ELEMENT ANTIVIBRATION ELEMENT TANK VENT ... 506 37 47-01 506 37 48-01 506 37 49-01 506 37 50-02 506 37 63-01 506 37 64-01 506 37 81-01 506...506 38 22-02 506 38 26-01 506 38 29-01 506 38 33-01 506 38 49-02 506 38 59-04 506 38 60-12
...
Parts Manual - Page 23
... 4 505 42 45-02 ANTIVIBRATION ELEMENT 5 574 50 58-04 FUEL TANK ASSY 6 525 57 20-01 DECAL START INSTRUCTION...50-02 FUEL HOSE 14 506 26 41-11 FUEL FILTER ASSY 15 506 27 11-01 HOSE CLAMP 16 506 26 41-01 FUEL FILTER 17 537 04 24-04 FUEL... 27 544 32 49-30 FUEL HOSE 28 503 73 58-...31 503 57 89-01 HOLDER ASSY 32 544 06 12-01 SCREW 33 537 21 03-09 ANTIVIBRATION ELEMENT 34 537 21 03-10 ANTIVIBRATION ELEMENT ...
Parts Manual - Page 29
Page N
K970 Ring
Pos. Part No. Description
1 738 88 10-01 LUBRICATION NIPPLE 2 503 22 00-...22 O-RING 17 506 35 15-02 DRIVE SHAFT 18 503 25 21-01 BALL BEARING 19 506 37 50-02 SPACER 20 544 07 76-01 SLEEVE 21 506 34 39-01 WIPER 22 740 48 25-02...506 31 22-02 DRIVER 31 506 13 96-01 COLLAR SCREW 32 506 13 95-11 WASHER 33 721 42 52-50 SPRING PIN 34 740 42 24-00 O-RING 35 506 37 48-01 SEALING HOLDER 36 503...
Similar Questions
What Is The Fuel Mix For This Machine 50-1 Or 40-1
(Posted by Superman6680 2 years ago)
Fuel Mix
Hi, I am a little confused about the fuel mix ratio. I am using 95-98 octane fuel for my Husqvarna K...
Hi, I am a little confused about the fuel mix ratio. I am using 95-98 octane fuel for my Husqvarna K...
(Posted by chasenhire 5 years ago)
Ignition Coil Gap K970 Rescue Saw
ignition coil gap on a k970 rescue saw
ignition coil gap on a k970 rescue saw
(Posted by broachri 7 years ago)
Muffler Bolts,k970
Having trouble with muffler bolts coming loose on Husqvarna K970 concrete saws. Do you know the torq...
Having trouble with muffler bolts coming loose on Husqvarna K970 concrete saws. Do you know the torq...
(Posted by denniswalters 7 years ago)