Husqvarna K 1260 Support Question
Husqvarna K 1260 Support Question
Find answers below for this question about Husqvarna K 1260.Need a Husqvarna K 1260 manual? We have 2 online manuals for this item!
Question posted by Workswithhand on November 19th, 2020
Bogs Out
runs for a few minutes then bogs out hard to start after
Current Answers
Answer #1: Posted by INIMITABLE on November 20th, 2020 3:22 AM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,071,330
Member since:
April 3rd, 2020 Points: 2,071,330
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Husqvarna K 1260 Manual Pages
Owners Manual - Page 3
... an authorised dealer for adjustment of cutting height 10 Seat,Rider 850 HST 10 Seat, Rider 970 HST 11 Fuelling 11 Driving 12 Before starting 12 Starting the engine 12 Driving the machine 14 Cutting tips 15 Stopping the engine 16 Maintenance 17 Maintenance schedule 17 Dismantling of the machine hoods 18...
Owners Manual - Page 4
...before repairs or maintenance
2 -
English EXPLANATION OF SYMBOLS
These symbols are in the vicinity.
Starting instructions Read the instructions Check the engine's oil level Check the hydrostat's oil level Lift ...unit Put the gear shift/hydrostat pedal in neutral Brake If the engine is running. Study them carefully so that the machine can tip over
Never drive across a slope...
Owners Manual - Page 5
This is running. which can lead to severe injury.
3 English - before starting the machine.
WARNING! ! RIDER 850
RIDER 850
Never carry passengers.
... off the blades, pull on the ejected grass and do not direct it towards anyone.
• Slow down before starting it .
• Wear approved protective glasses or a visor during assembly and driving.
• Never use the machine...
Owners Manual - Page 6
... , which can alter the stability of the machine.
• Always drive smoothly and slowly on slopes. Avoid sudden changes of speed or direction.
• Avoid starting or stopping on slopes. Cut slopes upwards and downwards, not sideways.
Only use the gear to brake in the instructions. c. Do not make sharp turns...
Owners Manual - Page 7
...toxic and highly inflammable. Keep children away from the engine and hot sun can cause the fuel to run over the edge of mowing. Let the engine cool before using the machine, and leave space for... in a boiler room or where there is running.
a. Do not smoke, or fill up the machine with fuel in the fuel system the engine must not be started until this purpose. If leakage has occurred in...
Owners Manual - Page 8
...fuel is in the vicinity of naked flames or sparks. Rinse immediately with the engine running.
• The parts on the skin can cause cutting injuries. The machine must not... spare parts recommended by the manufacturer.
• The machine is formed in it has evaporated before starting the engine. Explosive gas is tested for safety and approved only for the blade units are properly ...
Owners Manual - Page 10
... choke function. When the choke is steplessly regulated with the throttle control, and thereby also the rotation speed of fuel and air, which simplifies cold start. Press in the lock button on the parking brake automatically disconnects when the brake pedal is adjusted with two pedals.
Owners Manual - Page 11
...cutting position) 9 English - Lift lever for a small mound in transport or cutting position. The lever can also be used to the lawn as fertiliser.
If the lock button is pressed and the lever is fitted with a cutting unit which cuts up and the blades stop ...(transport position)
Lowering of cutting it several times before it is returned to set the cutting unit in the lawn.
Owners Manual - Page 13
... is highly inflammable. Lock the setting with fuel outdoors (see safety instructions). Observe care and fill up with the knobs.
Fuelling
The engine should be run on the front edge and can also be tipped forward. English - 11 WARNING! The seat can be adjusted lengthways. PRESENTATION
Seat, Rider 970 HST
The...
Owners Manual - Page 14
...
2. This is done as follows:
• Press down .
2 1
Cold engine:
3. Starting the engine
1. English The parking brake lock disconnects automatically when the brake pedal is pressed down ...
position). In this position the engine receives a
richer mixture so that the engine starts more easily.
1
2 3
12 - DRIVING
• Read the safety instructions and information on the location ...
Owners Manual - Page 15
... trying again.
6. DRIVING
Warm engine: 4. Turn the ignition key to full throttle.
! IMPORTANT INFORMATION Do not run the engine indoors, in enclosed or poorly ventilated areas. Push the throttle control to neutral position. For cutting 3/4 to start , wait about 5 seconds at a time. The exhaust fumes contain toxic carbon monoxide. WARNING! If the...
Owners Manual - Page 17
... a uniform cutting height it is cut often. Clear the lawn from stones and other fixed objects to avoid collision.
• Start with a high cutting height and reduce down until the cutting...lawns are equal on the lift lever and lower down the cutting unit with water underneath each time it is important that the tyre pressures are achieved if the grass is used. WARNING! If the grass is run...
Owners Manual - Page 18
DRIVING
! STOP START
Release lever
In order to
the end position.
Lift up the cutting unit by pulling the... Pull back the throttle control and turn the ignition key to obtain normal working temperature before stopping it if it has been working hard. 1.
Avoid sudden changes in direction. Mow slopes upwards and downwards, never across. MAX 15°
2. English WARNING! Stopping the...
Owners Manual - Page 19
... the safety system Check screws and nuts Check for fuel and oil leakage
19
q
19
q
19
q
20
q
20
q
21
q
21
q
-
Maintenance
Daily maintePage nance before start
Maintenance interval in these instructions go to an authorised service workshop.
No service procedures must be conducted on the machine.
Owners Manual - Page 23
... emit explosive gas.
Release the two screws (one of water.
Contact a doctor as soon as possible.
Top up the cells with a safety system which prevents starting the cutting unit or driving the machine unless someone is sitting in the same hole as for the dip stick. Procedures on the dip stick...
Owners Manual - Page 29
... 30 or SAE 10W/30 viscosity grade.
Engine oil can be regularly lubricated with oil to a workshop or other designated station for the dip stick. Run the engine warm and then check that there is hazardous to cool down first.
1. Re-grease with min. Use engine oil SAE 30 or SAE...
Owners Manual - Page 30
Replacement of the fuel filter
Replace the pipe fitted fuel filter every 100 running hours (once per season) or more frequently if it should do when the throttle lever is moved or if the top speed is clogged. Replace ...
Owners Manual - Page 31
...Battery flat. • Bad contact between battery terminals and cables. Engine does not run smoothly.
• Wrong gear, too high. • Carburettor incorrectly set .
English... unit in wrong position. • Main fuse blown. TROUBLE SHOOTING SCHEDULE
Problem
Engine will not start. Engine overheats.
• Engine overloaded. • Air intake or cooling flanges blocked. •...
Owners Manual - Page 32
... screw the plug back on.
6.
Drain off the fuel in a tablespoon of your machine the next season. Start the engine and run it will reach the carburettor.
Add stabiliser to stand for at least 10 minutes after adding the stabiliser so that it until the carburettor is an acceptable alternative to avoid rust...
Owners Manual - Page 33
...for repairs. English - 31 gradient
Engine Manufacture
Power Displacement Fuel
Tank volume Oil
Oil volume Start
Electrical system Type Battery Spark plug
Transmission Manufacture Oil
Cutting unit Type Cutting width (Bioclip) Cutting...x 6.50 x 8 60 kPa (0.6 kp/cm2)
15°
Rider 970
2145 mm 1050 mm (970-15.5), 1260 mm (970-15.5S) 1120 (970-Bioclip) 1060 mm 240 kg 855 mm Front 715 mm, rear 625 mm...
Similar Questions
Spark At The Boot Cap
I have 3 year old Husky model 150 BT, When it runs there's spark at the boot cap & engine runs r...
I have 3 year old Husky model 150 BT, When it runs there's spark at the boot cap & engine runs r...
(Posted by krisdatt 3 years ago)
Starts But Does Not Run Under Load
The trimmer starts fine, but cannot Run in the non-choke position. It bogs down easily then quits. N...
The trimmer starts fine, but cannot Run in the non-choke position. It bogs down easily then quits. N...
(Posted by Brianj0628 3 years ago)
Want Run Right
My Husqvarna 224L weed eater will only run with the choke 3/4 on .in other words when starting it I ...
My Husqvarna 224L weed eater will only run with the choke 3/4 on .in other words when starting it I ...
(Posted by daviddunn6167 4 years ago)
K 1260 Firing Issues.
Installed new plug, fuel filter, air filter, gas, its getting spark, yet will not fire.What else can...
Installed new plug, fuel filter, air filter, gas, its getting spark, yet will not fire.What else can...
(Posted by jmatbrad 4 years ago)
