Husqvarna HU775BBC Support Question
Husqvarna HU775BBC Support Question
Find answers below for this question about Husqvarna HU775BBC.Need a Husqvarna HU775BBC manual? We have 2 online manuals for this item!
Question posted by groundeffects4u on May 27th, 2015
My Blade Will Not Rotate When The Mower Is Started.
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TechSupport101 on May 29th, 2015 11:57 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Here are two possible reasons why the mower's blade would not engage.
Related Husqvarna HU775BBC Manual Pages
Owners Manual - Page 2
... alert and turn machine off and wait until the blade comes to the presence of California to operate the ...trim near or under rotating parts.
Look for this symbol to vibrate abnormally, stop before cleaning the mower or unclogging the chute....All slopes require extra caution. WARNING: This lawn mower is generally a warning of the machine before starting .
• Do not put hands or...
Owners Manual - Page 3
... BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
• If fuel is running . Allow machine to prevent accidental starting.
• Keep nuts and bolts, especially blade attachement bolts, tight and keep equipment in maintaining, caring for and using your lawn mower properly.
Owners Manual - Page 4
...vinyl bindings are too stiff, hold them in warm water for additional loose parts. Your new lawn mower has been assembled at .
3.
Remove protective padding, raise upper handle section into grass bag with... carton and lay end panel down flat the factory with mower.
2. Roll lawn mower out of your lawn mower, all packing materials except padding between upper and lower handle and ...
Owners Manual - Page 5
... PLUG
MEETS CPSC SAFETY REQUIREMENTS
Husqvarna rotary walk-behind power lawn mowers conform to stop the blade. Release to the safety standards of various controls and adjustments. used to discharge or
BLADE / BRAKE CONTROL - These symbols may appear on your lawn mower to engage power- used for starting & stopping the engine; OPERATOR PRESENCE CONTROL BAR -
OPERATOR PRESENCE...
Owners Manual - Page 6
... safety glasses or eye shields while operating your lawn mower or performing any adjustments or repairs. HOW TO USE YOUR LAWN MOWER
THROTTLE/ENGINE CONTROL (See Fig. 4)
The engine is engaged, the blade turns.
• To start the blade in severe eye damage.
BLADE/BRAKE CONTROL LEVER
FIG. 4
TO ENGAGE BLADE
OPERATOR PRESENCE CONTROL BAR
FIG. 5
6 We recommend standard...
Owners Manual - Page 7
Proceed as required.
4. Rotate turnbuckle on the drive cable. To raise mower, move the lever toward the handle a lever is worn and... The further toward the rear. Operate mower to disengage drive wheels. If condition fails to improve after releasing the drive control the mower will travel.
• To stop forward motion without stopping blade, release a drive control lever. NOTE...
Owners Manual - Page 8
... the rear door removed or propped open.
CAUTION: Do not run your lawn mower without rear door closed or approved grass catcher in place. OPERATION
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as shown.
• Mower is now ready for discharging operation.
• To convert to mulching or bagging operation, discharge...
Owners Manual - Page 9
... oil to change the oil more often under lawn mower handle.
3. See "TO CHANGE ENGINE OIL" in the Maintenance section of 87 octane. Do not mix oil with clippings from under dusty, dirty conditions. Do not store, spill or use . Empty the gas tank, start the engine and let it will smoke heavily...
Owners Manual - Page 10
... catchers will not be exposed to direct sunlight.
• For best results, adjust the lawn mower cutting height so that an area be necessary to raise the height of cut path and mow...the lawn. MAX 1/3
MOWING TIPS
FIG. 13
CAUTION: Do not use of the blades.
• Avoid cutting your lawn is equipped with water and let dry before starting an engine which has already run the lawn mower ...
Owners Manual - Page 11
... Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add Stabilizer
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled...
Owners Manual - Page 12
...starting in cold weather, these multi-viscosity oils will cause eventual damage to sharpen while on its side. TIRES
• Keep tires free of trash build-up .
3. Remove blade... blade will result in a horizontal position.
Turn lawn mower on the mower.
• To check blade balance, drive a nail into Blade Brake/Clutch.
4. Remove blade bolts by the manufacturer of blade ...
Owners Manual - Page 13
... the back plate. Disconnect spark plug wire from lawn mower or side of engine.
5. Rock lawn mower back and forth to retighten oil dipstick before starting engine.
9. Do not use . LIP
BACK PLATE... securely each time you reach the FULL mark on startup.
8.
Remove engine oil cap; Tip lawn mower on a clean surface.
3.
CAUTION: Petroleum solvents, such as shown and drain oil into a...
Owners Manual - Page 14
... of the lawn mower is equipped with plug. adjust to a Husqvarna or other debris will be replaced. Water in engine can result in shortened engine life.
Make sure the blade and all moving...do not recommend using a garden hose to clean lawn mower unless the electrical system, muffler, air filter and carburetor are present, start engine (as described in the Operation section of...
Owners Manual - Page 15
... the storage position, you believe that all rusted or chipped paint surfaces;
Clean entire lawn mower (See "CLEANING" in handle with bolt and knob. SERVICE AND ADJUSTMENTS
1. Remove ...CENTER, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. LAWN MOWER
When lawn mower is not adjustable. Lubricate as shown in a clean, dry area.
1. Inspect moving parts...
Owners Manual - Page 16
...refill tank with new spark plug. Replace spark plug.
7. Loose blade or broken blade adapter.
7. Depress control bar to reach the carburetor. Turn fuel valve ...• Use fresh fuel next season.
CAUTION: Never store the lawn mower with fresh,
clean gasoline.
4.
PROBLEM
CAUSE
CORRECTION
Does not start
1. Out of oil through spark plug hole into cylinder.
3. Fill...
Owners Manual - Page 17
....
1.
Wheel heights uneven. 3. Worn, bent or loose blade. 2. Starter rope hard to cleared area. Blade dragging in heavy grass.
2.
Lift on when control bar is on blade worn off of lawn mower housing or cutting
blade dragging in uncut grass.
1. Replace blade. 3. Replace blade/brake control. Engine dies when starting . Move mower to pull
1. Grass is too high or wheel...
Owners Manual - Page 19
... your product is approved; (h) Use of ether or any starting fluids; (i) Pressure cleaning or steam cleaning the product; (j)...required maintenance services as belts, pulleys, spindle housings, bearings, blades, rods, height adjusters, caster/anti scalp wheels etc... In ... arrange for the deck shell only - (a) Abrasion to mower decks; (b) Tires damaged by external punctures; (c) Natural ...
Owners Manual - Page 20
...Snow Throwers
Engine*
*
Other Non-Expendable Components
2 Years
Tiller Tines
***
Walk Behind Mowers, High Wheel Trimmer
Engine*
*
Battery
1 Year Pro-rated
Other Non-Expendable Components
...
*
Pump
2 Years
Other Non-Expendable Components
2 Years
All other than Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if made...
Parts List - Page 3
MODEL NUMBER HU775BBC (PRODUCT NUMBER 961 45 00-14)
KEY PART NO. inches. 1 inch = 25.4 ... Bracket, RH Screw, Dogpoint 3/8-16 x 1-1/8 Spring, Torsion Nut, Hex, Nylock Kit, Lawn Mower Housing Rod, Hinge Blade Brake/Clutch Assembly Blade, 22"
KEY PART NO. HUSQVARNA ROTARY LAWN MOWER - IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be...
Parts List - Page 5
...Coupling Support Bracket, Front Axle Pulley, Idler Screw
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm. HUSQVARNA ROTARY LAWN MOWER - NO.
1 581 95 05-01
9 581 95 21-01 10 532 43 27-90 11 817 41 13-12 12 873 94... Cover, Dust, Wheel Screw, Hex Head Pawl, Drive Wheel & Tire Assembly, Rear
KEY PART NO. MODEL NUMBER HU775BBC (PRODUCT NUMBER 961 45 00-14)
5
KEY PART NO.
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
Mower Blade Bogging Out
My Husqvarna mower model hubbc775 blade engages but bogs down to where it won't cut any gras
My Husqvarna mower model hubbc775 blade engages but bogs down to where it won't cut any gras
(Posted by Slarnold74 3 years ago)
Stop Wire
My husqvarna walk behind mower (HU775BBC) wont shut off. keeps running adn only stops when i pull sp...
My husqvarna walk behind mower (HU775BBC) wont shut off. keeps running adn only stops when i pull sp...
(Posted by zcdevico 9 years ago)
Blade Brake/clutch Control Cable Replacement
I would appreciate tips, maybe a video, how to replace blade brake/clutch control cable on HU775BBC ...
I would appreciate tips, maybe a video, how to replace blade brake/clutch control cable on HU775BBC ...
(Posted by jpilitowski 10 years ago)
Mower Starts But Won't Keep Running? Spark Plugs And Air Filter Replaced.
Mower starts but won't keep running. Spark plugs and air filter replaced.
Mower starts but won't keep running. Spark plugs and air filter replaced.
(Posted by kudos2u 10 years ago)