Husqvarna HU675AWD Support Question
Husqvarna HU675AWD Support Question
Find answers below for this question about Husqvarna HU675AWD.Need a Husqvarna HU675AWD manual? We have 2 online manuals for this item!
Question posted by jengardner77 on July 16th, 2015
How To Change The Drive Cable?
The drive cable has broke at the top near the handle, it's like the metal is frayed. How do we replace it?
Current Answers
Answer #1: Posted by TechSupport101 on July 16th, 2015 6:59 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
See the manual page here http://www.manualslib.com/manual/713558/Husqvarna-Hu675awd.html?page=15
Related Husqvarna HU675AWD Manual Pages
Owners Manual - Page 2
...the self-propelled mechanism or drive clutch on the handle and walk;
CHILDREN
Tragic accidents can hide obstacles. To avoid severe burns on wet grass. WARNING: This lawn mower is equipped with an ...extreme caution when changing direction on a slope, do not mow it cannot contact spark plug in order to prevent accidental starting .
• Do not put hands or feet near or under the...
Owners Manual - Page 3
... use extra caution when servicing it on clothing, change the engine governor setting or overspeed the engine.
• Maintain or replace safety and instruction labels, as a water heater... attachement bolts, tight and keep equipment in handling gasoline. The instructions will enable you cannot easily remedy, please contact your lawn mower.
• Follow the instructions under "Maintenance...
Owners Manual - Page 4
....
4. OPERATOR PRESENCE CONTROL BAR
LIFT UP
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE (See Figs. 1 and 2)
IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.
1. secure with mower.
2. Your new lawn mower has been assembled at .
3. TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with lower ("standard") knobs.
3. Remove protective padding...
Owners Manual - Page 5
... grass catcher frame into loop of the bag top.
2. FRAME HANDLE
VINYL BINDINGS
FIG. 3
FRAME OPENING
CONTROL BAR
UPPER HANDLE
ROPE GUIDE
T-KNOB
ENGINE STARTER ROPE
FIG. 4
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to bagging or discharging, see "TO CONVERT MOWER" in warm water for a few minutes. If bag gets wet, let...
Owners Manual - Page 6
... the engine is shipped WITHOUT OIL OR GASOLINE in literature supplied with your lawn mower or in the engine. OPERATOR PRESENCE CONTROL BAR
DRIVE CONTROL BAR
STARTER HANDLE
GRASS CATCHER
WHEEL HEIGHT ADJUSTER (ON EACH WHEEL)
HANDLE KNOBS
GASOLINE FILLER CAP AIR FILTER DRIVE COVER
ENGINE OIL CAP WITH DIPSTICK
HOUSING
SPARK PLUG
MUFFLER
IMPORTANT: This...
Owners Manual - Page 7
... IS RELEASED.
4. NOTE: Adjuster is an adjustment turnbuckle on the drive control cable to increase tension on this lawn mower in the same setting.
To stop when either the operator presence control bar or drive control bar are in order to the handle and pulling the drive control bar up or down against turnbuckle.
There is properly...
Owners Manual - Page 8
...handle. 2. Empty clippings from under dusty, dirty conditions.
You recieve a container of operation or each use gasoline near an open flame.
8 Add oil if needed.
OPERATION
TO CONVERT MOWER
Your lawn mower...and tighten dipstick. See "TO CHANGE ENGINE OIL" in quantities that can be used within 30 days to change the oil more often under lawn
mower handle. 3. Do not over &#...
Owners Manual - Page 9
... starter handle quickly. TO STOP ENGINE
• To stop engine, release operator presence control bar. TO START ENGINE
NOTE: Due to protective coatings on the right side of cut path.
• Change your...;rst cut grass may also be noticed. Reduce ground speed (pushing speed) and/or run the lawn mower over the area a second time.
• For extremely heavy cutting, reduce the width of cut...
Owners Manual - Page 10
...Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add...
Owners Manual - Page 11
... observe safety rules when performing any trash or grass cuttings from inside the dust cover, pinion and/or drive wheel gear teeth.
4. are
aligned; Turn lawn mower on the mower.
4.
Replace adapter if damaged. Install the blade bolt with a file or on the engine crankshaft. IMPORTANT: BLADE BOLT IS HEAT TREATED. The key must...
Owners Manual - Page 12
...filter. If very dirty,
replace cartridge.
Install cartridge, then replace cover.
12 Change the oil after each time you reach the FULL mark on the gear case. Tip lawn mower on a flat FULL.
... engine until the blade is not used to your drive system working properly, the gear cases and area around the drive should remain in one year.
CONTAINER
FIG. 14 ...
Owners Manual - Page 13
... FEATURE (See Fig. 17)
Your lawn mower is running. Start engine (as it cannot come in fuel line with arrow pointing towards carburetor.
3. With engine cool, remove filter and plug fuel line sections.
2. SPARK PLUG
Replace spark plug at the fit- WARNING: Do not engage the drive system during the washout process. 2. ting...
Owners Manual - Page 14
TO REMOVE DRIVE BELT (See Figs. 18 & 19)
1. LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in contact with air filter and carburetor up.
2. Disconnect cable from rear baffle / rear gearcase belt keeper.
6. Disconnect spark plug wire from spark plug and place where it should be thrown out of the...
Owners Manual - Page 15
... drive control cable adjustment to input shaft (beneath pulley) and loosening pulley with a 9/16" box wrench.
13. Remove rear gearcase pulley by clamping locking pliars to original factory setting (no "gap"). Reattach return spring to assure proper fit and long life.
1. Remove belt from mower and discard. Reinstall rear baffle.
13. TO REPLACE DRIVE...
Owners Manual - Page 16
... PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. Inspect moving parts for repair and/or adjustment. Replace if necessary.
4. SERVICE AND ADJUSTMENTS
TO ADJUST HANDLE (See Fig. 20)
The handle on your lawn mower handle for storage.
1. Store in handle bracket and reassemble bolt and knob and tighten securely.
3. Do not attempt to increase engine speed...
Owners Manual - Page 17
...BAR
KNOB
STORAGE
FOLD FORWARD
FOR STORAGE
MOWING POSITION
UPPER HANDLE
UPPER HANDLE
"STAR" KNOB
LOWER HANDLE
LOWER HANDLE "STANDARD" KNOB
FIG. 21
BOLT
HANDLE BRACKET
FIG. 22
ENGINE
FUEL SYSTEM
IMPORTANT: IT ...CYLINDER
1. Pour one season to another.
• Replace your gasoline can if your unit with new spark plug. CAUTION: Never store the lawn mower with clean engine oil. (See "ENGINE" in...
Owners Manual - Page 18
... height too low. "Loose" drive control system.
1. Clean/replace air filter. 4. uneven
1. Drive cable worn or broken. 4. Check/reinstall drive belt. 3. Set all wheels at slower walking speed. Worn, bent or loose blade. 2. Loss of drive (or slowing of lawn mower housing or cutting
blade dragging in heavy grass.
2. Fill fuel tank.
3.
Adjust handle height to plug...
Owners Manual - Page 19
...Transmission / Transaxle (including Drive Systems) are NOT ... Husqvarna replacement parts, subject to handle warranty ...adjustments or repairs on Exhibit A. Depending on engines manufactured by their respective manufacturer's warranties if one is not authorized to the limitations and exclusions described below. and
c. Preventative maintenance as throttle cable...
Parts List - Page 3
... at 1-800-544-2444) Screw, Hex Washer Head Fastener, Push Mounting Bracket, Rear Skirt Clip, Cable Front Shroud Assembly Screw Operator's Manual, English / Spanish
3
NOTE: All component dimensions given in U.S. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HU675AWD (96143010801) PRODUCT NO. 961 43 01-08
KEY PART NO. HUSQVARNA ROTARY LAWN MOWER -
Parts List - Page 5
HUSQVARNA ROTARY LAWN MOWER - IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HU675AWD (96143010801) PRODUCT NO. 961 43 ...06 77-25
DESCRIPTION
Drive Control Assembly (Includes Cable) Mounting Bracket, Idler Pulleys Gearcase Assembly, Front, Complete Bar, Drive Control Pinion Belt, Drive Gearcase Assembly, Rear, Complete Pulley, Drive Wheel Adjuster Assembly, ...
Similar Questions
Drive Cable Replacement
can you tell me how to replace drive cable on hu675 awf
can you tell me how to replace drive cable on hu675 awf
(Posted by vbandpb 11 months ago)
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)