Husqvarna 128DJx Support Question
Find answers below for this question about Husqvarna 128DJx.Need a Husqvarna 128DJx manual? We have 2 online manuals for this item!
Question posted by ltl on November 2nd, 2013
Does This Weedeater 'carb' Have Adjustable 'high' And 'low' Speed Jets?
This unit does not reach full RPM when depressing the throttle lever. Husqvarna 128 DJX
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Husqvarna 128DJx Manual Pages
Owners Manual - Page 2
... eye protection must be used. Failure to follow instructions could result in serious injury to special certification requirements for handle mounting.
speed of thrown objects and ricochets.
Beware of output shaft, rpm
Use unleaded or quality leaded gasoline and two--stroke oil mixed at least 50 feet (15 meters) from the spark...
Owners Manual - Page 3
...com
577387001 Rev. 2 1/6/11
English--- 3
Always use approved hearing protection. authorized accessories or replacement parts.
Category C = 50 hours, B= 125 hours, and A = 300 hours. Husqvarna AB has a policy of continuous product development and therefore reserves the right to the operator or others . WARNING: Long- The Emissions Compliance Period referred to ...
Owners Manual - Page 5
...or trimmer can be dangerous if used incorrectly or carelessly, and can operate with this engine unit are working . Ask your dealer for help in the same area, the safety distance should...not under the heading Maintenance. See instructions under some circumstances can be carried
out by low speed and force on Technical data. Personal protective equipment
IMPORTANT! It is taller than 50 ...
Owners Manual - Page 6
...must contact your machine. when you release the handle, the throttle control and the throttle lock both move freely and that the return springs work on your service agent. ... for the address of your nearest service workshop. If the cutting attachment rotates with the throttle in this equipment is positioned on the machine requires special training. If your machine fails any...
Owners Manual - Page 7
...attachment.
Never use a cutting
attachment without an approved guard.
The risk increases at idle speed. WARNING: Mufflers get very hot
during use the recommended guard for some time after ... or faulty guard is fitted with a spark
arrestor mesh.
This also applies at low temperatures. GENERAL SAFETY PRECAUTIONS
Stop switch Make sure the engine stops when you follow ...
Owners Manual - Page 8
... correct blade setting!
This continues to : S Reduce the risk of blade thrust. The nylon lining inside the locking nut must
not be replaced after the throttle has been released. The lining should not start or run the machine indoors, or anywhere that is poorly ventilated. Follow our instructions and use the...
Owners Manual - Page 10
...attachment snaps into the slot in this manual.
S Make a final adjustment of the handle to the loop handle using the unit, tighten the knob securely. S Push and hold the button (C). ...
Fitting the J-handle
S Clip the loop handle onto the shaft.
ASSEMBLY
NOTE: Make sure unit is fitted. S Attach the J--handle to a comfortable working position.
handle is assembled correctly...
Owners Manual - Page 11
... brushcutter safely. NOTE: It may be unable to the harness clamp on the shaft for proper balancing of unit. Fitting the harness
ASSEMBLY
WARNING: When using unit. Correct height Adjust the harness so that the unit is parallel to prevent contact with a hex wrench. If you will be necessary to relocate the harness clamp...
Owners Manual - Page 13
...in mind the risk of fire, explosion and inhaling fumes. Gasoline
CAUTION! Always use
HUSQVARNA two--stroke oil, which can drastically affect the ratio of oil to be emptied....or allowed to come in contact with sparks or naked flames, for two--stroke engines. S When working at continuous high revs, a higher octane rating is leaking fuel.
oz. 2 1/2 6 1/2 12 7/8
577387001 Rev. 2 ...
Owners Manual - Page 15
...much.
S Never use the machine without a guard nor with dull teeth. DO NOT squeeze
throttle trigger. Pull starter rope until fuel begins to the closed position. S Check that the trimmer... Never wrap the starter cord around your left hand (CAUTION! Move the blue
engine choke lever to the ½ position.
Ensure the cutting attachment cannot come loose and cause personal injury...
Owners Manual - Page 16
...cutting attachment will start position. Warm engine With a warm engine, move the blue engine choke lever to the opened position. Do not put any part of the starter handle when the cord ....
CAUTION! Contact can damage the machine. NOTE: If engine dies, return blue engine choke lever to prevent unintentional starting steps. WARNING: When the engine is fully extended. Do not pull the...
Owners Manual - Page 17
... with the blade. Working in bad weather is well adjusted. The ABC of injury. Stop the engine and cutting... before cleaning. Do not use and may attempt to idle speed after
each working instructions
IMPORTANT! Take great care when working ...persons at full throttle without first checking behind you touch it. Fit the transport guard before use full throttle when starting ...
Owners Manual - Page 18
...working against stones, brick, concrete, metal
fences, etc., than full throttle so that does the work at full throttle.
Let the trimmer line work rhythmically. S Avoid the previously cut ...above the ground and tilt it easier to 4--6 inches (10--12 cm) and reducing the engine speed. Move forward after the return stroke and stand firmly again. structions: S Always work . S ...
Owners Manual - Page 19
... and fro. WARNING: Neither the operator
of injury. The bevel gear can ruin the lawn and damage the tool. Never lean over the cutting attachment guard. tance.
Stop the ...be used for quick and easy clearing up into contact with the ground during use full throttle to reach using a normal lawn mower. Sweeping
WARNING: Watch out for a while afterwards. Keep unauthorized persons at a...
Owners Manual - Page 20
... regulates the throttle setting at the factory. Basic setting S The basic carburetor settings are hot and can - WARNING: The cutting attach- Wear your carburetor.
turning it has been correctly adjusted or repaired.
When the unit is turned off, make sure the cutting attachments has stopped before performing maintenance, except carburetor adjustments.
speed: See "Technical...
Owners Manual - Page 21
... lower shaft should be carcinogenic. If the machine is low on the spark plug electrodes, which may contain sparks which...that the electrode gap is influenced by: S Incorrect carburetor adjustment. MAINTENANCE
If the mesh is frequently blocked, this reason ...or runs poorly at idle speed.
correct type of fire!
This also applies at idle speed: always check the spark plug...
Owners Manual - Page 23
... section.
Replace if necessary.
X
Check that the spark plug is fitted with a suppressor. Adjust
the gap to impact or is cracked.
Check that there are described in this Operator's Manual.
X
Make sure the throttle trigger lock and the
throttle function correctly from a safety point
of the maintenance that must be performed on the...
Owners Manual - Page 24
...--- 24 NOTE! in./cm3 Cylinder bore, inch/mm Stroke, inch/mm
Idle speed, rpm Recommended max. speed, left /right handles:
3/5
At max.
The noise pressure level at handles, measured according to ISO 8893, hp/kW
Catalytic converter muffler Speed--regulated ignition system
128DJX
1.7/28 1.4/35 1.130/28.7 2800--3200 11000 8000 1,1/0,8 Yes Yes
Ignition system...
Parts List - Page 1
...-Cable/Wire Harness Housing-Throttle (RH) Screw Screw Spring-Trigger Trigger Lockout-Throttle Housing-Throttle (LH) Kit-Switch Screw Knob Handle Loop Handle J Plastic Spacer Nut - Support Support Flange Locknut - MODEL 128DJX (US/CAN)
Page: 1
1
9
2 3
4
7
8
10
6 5
11
17
12
18 19
15 16
13 14
20
21
WARNING
All repairs, adjustments and maintenance not described...
Parts List - Page 2
... 22. 545008079 23. 545043204 24. 530016426 25. 530016449
Description
Filter Nut-Carb. Screw Lever - Fuel Cap (kit) Isolator-Fuel Tank Kit-Fuel Tank Assy. (Incl...) Kit - Gasket (Incl. 7,65) Adaptor-Carb. Choke Bulb-Purge Kit-Carb. WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must...39
48
38
MODEL 128DJX (US/CAN)
Page: 2 1 2
70 69 68
72...
Similar Questions
Husqvarna 223l Carburetor Adjustment Tool Part Number
Can you please tell me the correct part number for the 223L carburetor adjustment tool
Can you please tell me the correct part number for the 223L carburetor adjustment tool
(Posted by davisl13 6 months ago)
After Running For Apprx. 1hr The Motor Slows Drastically Until Throttle Released
Believe it needs carb adjustment of Hi spd. jet. Is such adj. available? ?
Believe it needs carb adjustment of Hi spd. jet. Is such adj. available? ?
(Posted by jnbliddle50 7 years ago)