Hotpoint VLSR1090GWW Support Question
Hotpoint VLSR1090GWW Support Question
Find answers below for this question about Hotpoint VLSR1090GWW - 3.2 cu. Ft. Washer.Need a Hotpoint VLSR1090GWW manual? We have 2 online manuals for this item!
Question posted by derekophillips on October 7th, 2011
Water Won't Completely Drain
The wash machine is not draining all the way. If we run "drain" again it will drain, so it isn't the most pressing issue. Any ideas why? Thanks.
Current Answers
Answer #1: Posted by majorapplirepair on October 9th, 2011 5:38 AM
majorapplirepair
Member since:
October 7th, 2011 Points: 139,880
Member since:
October 7th, 2011 Points: 139,880
Check for drain line kink or obstructions. May have obstruction in the pump or the pump maybe ready to go bad and need to replace it. May have a plug from a small object between the inner and outer tube at the tube outlet. Also check the inlet water valve to make sure it turns the in flow water off completely once it fills and during the rinse cycle. The valve can leak water into the tube during the final spin and it seems like the water did not get all pumped out. Good luck.
Related Hotpoint VLSR1090GWW Manual Pages
Owners Manual - Page 1
... Instructions
Care and Cleaning of the Washer 7 Control Panel 4 Control Settings 4, 5 Features 6 Loading and Using the Washer 7
Troubleshooting Tips . . . . . .8-10
Consumer Support
Consumer Support 12 Warranty 11
Owner's Manual
Write the model and serial number here:
Model
Serial
You can find them under the lid of the washer.
175D1807P625 39-90358 08-08...
Owners Manual - Page 2
... under these circumstances. If the hot water has not been used by or near children. Safety Instructions
Operating Instructions
IMPORTANT SAFETY INFORMATION.
PROPER INSTALLATION
This washer must be properly installed and located in Installation Instructions.
Follow details in accordance with all hot water faucets and allowing them to run for two weeks or more .
Owners Manual - Page 3
... the machine has completely stopped before attempting any part of electric shock, unplug this appliance from the power supply or disconnect the washer at the building's distribution panel by removing the fuse or switching off
vapors that you understand and have the skills to the wash water.
Do not add
these substances around your washer or...
Owners Manual - Page 4
The water level should just cover the clothes.
The washer will pause for the wash and rinse cycles. Step 1
Step 2
Step 3
Step 4
• Add detergent
• Add diluted fabric softener (on models with a fabric softener dispenser)
• Add clothes
• Select load size and other wash options
• Select wash cycle
Quick Start Guide
• Close...
Owners Manual - Page 5
... regular wash cycle.
The Slow spin speed is for a cleaner wash; Use for normal items. Use it to remove more water from heavily...press items.
DELICATES For lingerie and special-care fabrics with light to normal soil. With Gentle wash speed, the agitator moves slower. KNITS Specially designed for normally soiled knits. Your washer may not have all these cycles. Wash Speeds: With Normal wash...
Owners Manual - Page 6
... measured amount of the dispenser.
5 Rinse and reassemble dispenser.
Safety Instructions
Operating Instructions
About washer features. Liquid Bleach Funnel (on some models)
The water fill dilutes liquid chlorine bleach as the washer fills for the wash cycle.
1 Check clothing care labels for cleaning
Cleaning the Fabric Softener Dispenser (on some models)
1 Remove the dispenser...
Owners Manual - Page 7
...and using the washer. Proper Use of laundry problems.
You can work effectively. Wash Basket: Leave the lid open after washer has started, ...washer basket. If you set the load/water level high enough to allow moisture to move freely. Exterior: Immediately wipe off at faucets. For more information, visit www.Hotpoint.com or call 800.GE.CARES (800.432.2737).
Drain all water from drain...
Owners Manual - Page 8
... than 8 ft (2.5 m) above floor.
• This is normal
What To Do
• Measure your clothes cleaner with cooler water temperatures without affecting wash performance.
• Turn both hot and cold faucets fully on and make sure washer is not sitting on it.
• Top of drain outlet should be replaced every 5 years.
• New laundry detergents...
Owners Manual - Page 9
... is
when shut off
disengaging the motor
• When the machine is delivering water at 120°F-140°F (48°C-60°C).
• Select load size to be indicated.
• If you are washing. Be sure to the beginning if necessary.
Washer should have separate outlet. Time not shown on display
Unit filling...
Owners Manual - Page 10
... of agitate and disengage when agitate is not caused by the washer, you can slow the pilling process by washing garments inside out.
SOUNDS "Metallic clicking"
Possible Causes
Shifter mechanism is complete.
• When the pump starts drawing in cold and hot water. The washer should then begin spinning and the sound will make a humming...
Owners Manual - Page 11
...are limited to one -year warranty, we will also provide, free of the washer which fails due to the original purchaser and any succeeding owner for products purchased for...Service Centers, or an authorized Customer Care® technician. Safety Instructions
Operating Instructions
Hotpoint Washer Warranty.
Staple your state's Attorney General. Proof of the product if it is extended...
Owners Manual - Page 12
... take advantage of all the details including your phone number, or write to design for a wide range of GE's Universal Design applications, including kitchen design ideas for enhanced communication and prompt service under the terms of the year! Order on -line and schedule your service at your convenience.
You may cause...
Installation Instructions - Page 1
... it in poor wash perfomance
Avoid a Repair! Level front legs left to right
Tilt washer forward 4 to install the washers. rear legs will result in
Install washers. (Washers should be brand new. Ensure washer is properly grounded. Install drain hose to your washer
2. The plug must be plugged into an appropriate
outlet that washer is successful and complete. Replace them...
Similar Questions
How Much Water Does It Use At Different Levels?
How much water does it use at large, medium and small loads?
How much water does it use at large, medium and small loads?
(Posted by w1hgl 2 years ago)
Where Does It Say That The Water Temperature Will Not Get Hot?
I was told that manufactors recommend washing in only warm water. Why does it have a hot setting.My ...
I was told that manufactors recommend washing in only warm water. Why does it have a hot setting.My ...
(Posted by chp9107 7 years ago)
Water Levels
Upon first use of this machine the water levels seem extremely low. The super (largest) did not come...
Upon first use of this machine the water levels seem extremely low. The super (largest) did not come...
(Posted by Anonymous-135553 10 years ago)