Home » Hoover » Vacuums » Hoover UH70102

Hoover UH70102 Support Question

Find answers below for this question about Hoover UH70102.
Need a Hoover UH70102 manual? We have 1 online manual for this item!

Hoover Overview Questions Manuals Reviews Videos Research

Question posted by kstorzum on February 20th, 2017

My Vacuum Was Running Then It Jus Stopped. I Checked The Cords, The Outlet Even

I was vacuuming, almost done, and the vacuum just shut off. I checked the cord, the outlet, the fuse box. Everything was fine. I even plugged the vacuum in at a different outlet. Nothing. The canister was even near full because emptied it prior. Help!Model base #UH70102 Bagless/Upright

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on February 20th, 2017 10:22 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,100
points

See http://bit.ly/2lE1FxZ [first-listed problem].

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Hoover UH70102 Manual Pages

Owners Manual - Page 2

...cord, use with any object into water, take it to this owner's manual. Amways disconnect cord from electrical outlet before unplugging. Do not unplug by or near... when any time. Do not allow vacuum cleaner to run appliance over cord. Do not operate cleaner in the...grasp handle plug or appliance with damaged cord or plug. The use with wet hands. the plug, not the cord. Never ...

Owners Manual - Page 3

.... Cleaner body C. Push bolts into holes on the "Service" button to find the service outlet nearest you need any assistance: Visit our website at www.hoover.com. Continued -_ 3 A....with a representative in OFF position. Slide handle onto cleaner body. Click on back of service outlet locations (U.S. Hose, cleaning tools and wands (*some models Attach handle uu urJ ! Switch (A)...

Owners Manual - Page 4

... bottom of dusting brush (A), crevice tool (B) and furniture nozzle (C) into clips as shown. Repeat with a Phillips screw driver. Pivot cup and snap in place. \ Position cord on front of handle. The crevice wand is packed inside a wand for Align end of hose with projections (A) over hose hook (D) and into hose tube...

Owners Manual - Page 5

...* 15. Hose hook 3. Carrying handle 6. Stair cleaning handle: located on bottom of cleaner body 5. Headlight 9. Nozzle control knob: slide knob to correct setting for easy cord release. 13. Wands 12. This plug will fit in a polarized outlet only one blade is intended for storage. Do not change the...

Owners Manual - Page 7

..., lower nozzle, and use hose, lift hose end as shown and will continue to edge of nozzle parallel to rotate. The cleaner is in carpet near baseboards and furniture. Lower cover (B) onto hose tube. When using cleaning tools, cleaner handle should be used in tight spaces, corners and along edges in...

Owners Manual - Page 8

...dirt cup assembly consists of hose. This larger debris will stop larger debris from the pleated filter. When to lock it ...hose (G) by pushing it into hose. Remove regular hose from electrical outlet. G Attach wand and tools Attach tool or wand to the wand ... the steps below for this type of your cleaner will collect fine particles that the dirt cup be seen collecting in the same ...

Owners Manual - Page 9

... of cup. Replace dirt cup lid. The screen (C) can be cleaned with a soft brush or rinsed with water. Press on filter gasket (F) until dust particles stop falling from pre-filter assembly. Pivot pre-filter assembly toward center of the pre-filter. Pull up on top of filter until 4 tabs (G) (2 on the...

Owners Manual - Page 10

... 3-22 to replace this filter when it on the side of socket. Disconnect cleaner from electrical outlet. 2. Using a screwdriver, remove the two screws as follows: 1. Push new bulb straight into...Fig. 3-2). Pull old bulb straight out of cleaner. Remove screw and pull retainer out. Check for debris accumulation under the agitator shield each time you want to 3-24). Remove any...

Owners Manual - Page 11

.... Replace belt if it is in good condition. What to replace Disconnect cleaner from electrical outlet. How to buy To assure effective operation, use only genuine HOOVER belts with a Phillips screwdriver...agitator brush roll Insert agitator through belt and place belt in box on agitator. Pull other side of the cleaner and should be checked from time to time to rotate and is stretched, cut...

Owners Manual - Page 12

...into your cleaner by : • checking the Yellow Pages under "Vacuum Cleaners - When the thermal protector ...checking the list of authorized service outlet locations (U.S. Other performance factors include Hose Power (ASTM Test F558), Surface Litter Cleaning, Hard Floor Cleaning, Edge Cleaning, Cleaning Width, and Air Filtration. 12 HOOVER part No. 48414115. If this will stop running...

Owners Manual - Page 13

Clear blockage from electrical outlet. Plug cleaner in wall plug • Check fuse or breaker • Blown fuse or tripped breaker • Replace fuse or reset breaker • Thermal protector activated • Allow cleaner to cool for "Attach hose" (Fig. 1-8 and 1-9). 2) Clear out hose. 3) Look into opening (E) for suction ...

Owners Manual - Page 14

...14 Appliances purchased elsewhere are questions concerning this warranty or the availability of warranty service outlets, write or phone the Consumer Response Center, The Hoover Company, 10I East Maple ...2. Hoover Authorized Warranty Service Dealers (Depots) For an automated referral of authorized service outlets in the U.S.A., phone 1o800o944o9200 OR visit The Hoover Company onqine at no cost to...