Hoover UH70100RM Support Question
Hoover UH70100RM Support Question
Find answers below for this question about Hoover UH70100RM.Need a Hoover UH70100RM manual? We have 1 online manual for this item!
Question posted by krankybiker80 on October 24th, 2016
On The Wind Tunnel Mod Uh70100 Is There A Filter/gasket/seal On The Bottom Of Th
Looking at the schematic for this machine, I can't tell if there is a seal/gasket/filter on the bottom of the dust collector tube. I just got one and when i cleaned it there was a lot of crud packed up there. But the pictures almost look like there might be one there? The hinged cover seems to fit well.
Current Answers
Related Hoover UH70100RM Manual Pages
Product Manual - Page 2
...Attach Handle 5 Attach Dirt Cup 5 Position Tools 5 How To Use ...6 Vacuum Description 6 On-Off Switch 6 Carry Handle 6 Cord Storage 6 Carpet Height Adjustment 7 Tools ...7 Select Proper Tool 7 Removing Hose 7 Attach Wand And Tools 7 Stair Cleaning 8 How To Clean Tools 8 Maintenance ...8 Dirt Cup...8 Filters ...9 Brushroll ...10 Hose...11 Powered Hand Tool 11 Belt...12 Troubleshooting...
Product Manual - Page 3
...
• Fully assemble before operating. • Operate vacuum only at bottom of dust, lint, hair, and anything that may reduce air flow...and moving parts. Do not use without Dirt Cup and/or Filters in place. • WARNING: This product contains chemicals known.... • Unplug before unplugging. • Use extra care when cleaning on stairs. If appliance is necessary when used as a toy....
Product Manual - Page 4
... in upright
position. Do not change the plug in the outlet, reverse the plug. Do not expose machine to freezing temperatures. • Brushroll continues to turn while product is turned on furniture, fringed area rugs..., or carpeted stairs during tool use. • Do not use sharp objects to clean out hose as they can cause damage.
If the plug does not fit fully in any way...
Product Manual - Page 5
....
1.4
Position Tools
1.5
1.5 Secure Powered Hand Tool Clip (A) over ridges on side of packing materials. Dirt Cup
1.1 B
A
C
E
G
H
D I . Attach handle
Note: Remove the screw located in the vacuum base and set aside until secure.
1.6 Place Crevice Tool into Wand and slide into vacuum. Dusting/Upholstery Tool** G. Make sure all parts from carton and identify each item...
Product Manual - Page 6
...Vacuum Description
1. Stair Cleaning Handle 7. Hose Tube 18. CARRY HANDLE
2.3
A
The cleaner can be released. Attach the plug end to the cord.
2.5
Twist upper cord hook (B) to allow cord to be moved by using the carry handle. Hose 16.
B
6 2. Filter made with HEPA media
and Carbon Filter...6.
Handle Release Pedal 17. To turn vacuum ON, push ON/OFF switch once. ...
Product Manual - Page 7
... hose.
Powered Hand Tool may be used to give extra length to clean areas.
WARNING
Unplug vacuum before connecting Powered Hand Tool. Use it on and handle is turned... to turn knob to clean upholstered furniture, draperies, mattresses, clothing, and carpeted stairs. (Tool varies per model)
3.1
A
B
C
D
A. To lock back into place, push Hose into Hose Tube until you hear a ...
Product Manual - Page 8
... should be done by Stair Cleaning Handle and position on stairs or furniture, as face powder or cornstarch, may seal the filter and cause a reduction in the...cleaning may be used for stair cleaning.
3.4
3.5
! CAUTION ! Do not use and
care of dust, empty the cup and clean the filters often.
8 A
Very fine materials, such as it from moving parts, unplug vacuum before using the vacuum...
Product Manual - Page 9
... from moving parts, unplug vacuum before servicing. Hold filter under normal use. Squeeze filter twice while underwater. Dry filter on edge so air circulates on vacuum.
! Close lid securely by pushing at front (C). CAUTION ! To reduce the risk of dirt cup into place.
4.5
Filters: When to Clean
To maintain optimal performance, filters should be cleaned every two months under...
Product Manual - Page 10
... tabs along front edge of injury from the filter assembly with the Dusting/ Upholstery Tool.
4.11 Place the filter assembly on the dirt cup, aligning (3) tabs (A) on filter with HEPA media. Carbon Filter : How to Clean
! Cyclonic Filter Assembly: How to Clean
(Available on dirt cup (B) and twist it clockwise to Clean
! Replace dirt cup as described in place...
Product Manual - Page 11
... either side of injury from moving parts, unplug vacuum before servicing.
4.15 To remove Hose for tool use sharp objects to clean out hose as they can cause damage. Rotate latches back into Hose Tube until you hear a click.
4.15
A
Powered Hand Tool: How to Clean
! To reduce the risk of tool.
4.17 Remove...
Product Manual - Page 12
...from brushroll (C) then from time to time to Fig. 4.22 - 4.24.
How To Replace
4.19 Turn vacuum over motor shaft (metal rod) (E), then slip around area of brushroll without bristles (F). Rotate red upper latch ...part No. 38528033.
4.21 4.23
4.23 With lettering on outside of nozzle guard with your vacuum. To check the Stretch belt, refer to be sure it is not twisted.
4.24 Reposition ...
Product Manual - Page 13
... - Review Filter Removal and Cleaning. 1. Continue using the checklist below. Low vacuum suction. 1. PROBLEM
Vacuum won't run
System Check Indicator has turned red or Vacuum won 't pick or Low suction."
1. Check fuse or breaker in firmly. Pg.11. Pg. 8.
2. Blockage.
2. Belt broken or stretched.
3. Check items under "Vacuum won 't pick up or Low suction Dust escaping from...
Product Manual - Page 14
... of authorized service outlet locations call 1-800-944-9200. Mon-Fri 8am-7pm EST. This will only result in Glenwillow for service. Always identify your vacuum to find the service outlet nearest you need further assistance: To speak with a customer service representative call1-800-263-6376; In Canada, contact Hoover®...
Similar Questions
Hoover Wind Tunnel Will Not Turn On
My Hoover Windtunnel modelUH70830 will not turn on when plugged in and the red start button is pushe...
My Hoover Windtunnel modelUH70830 will not turn on when plugged in and the red start button is pushe...
(Posted by alvalady44 5 months ago)
Handle Release Is Broken On My Wind Tunnel
How can I get it to go down
How can I get it to go down
(Posted by Misty1247 10 years ago)
Wind Tunnel Why Would There Be Lack Of Suction?
My wind tunnel filter wont spin. I got a new one same problem .No suction. What is the possible prob...
My wind tunnel filter wont spin. I got a new one same problem .No suction. What is the possible prob...
(Posted by cmcgilvary 10 years ago)
Hoover Wind Tunnel Won't Start Changed Full Bag Checked Hoses ?
no sound or anything when I plug in and push start button, is there a fuse I could have tripped or b...
no sound or anything when I plug in and push start button, is there a fuse I could have tripped or b...
(Posted by gsbiggs 12 years ago)
Hoover Wind Tunnel Vacumn Cleaner
WHAT IS THE DIFFERENCE BETWEEN THE HOOVER WINDTUNNEL VACUMN UH70015 AND MODEL UH70010?
WHAT IS THE DIFFERENCE BETWEEN THE HOOVER WINDTUNNEL VACUMN UH70015 AND MODEL UH70010?
(Posted by sharonj6 13 years ago)