Hoover H3045 Support Question
Hoover H3045 Support Question
Find answers below for this question about Hoover H3045.Need a Hoover H3045 manual? We have 1 online manual for this item!
Question posted by luisahenriques on August 4th, 2011
Hoover Floor Mate
Where in Etobicoke can I go and pick up a hoover floor mate?
Current Answers
Related Hoover H3045 Manual Pages
Manual - Page 2
...; Do not pick up anything that is well ventilated.
• Avoid picking up or use flammable or combustible materials such as a toy or to run appliance over floor electrical outlets. ...such as a handle, close door on carpets.
• Connect to a Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer.
• Always disconnect cord from heated surfaces.
•...
Manual - Page 3
... hoover.com • 1-800-944-9200 - hoover.com
C
D
B
*
*
E
Continued §
3
Hard floor cleaner B. Proof of date of purchase may be required for cleaning grout and Grout Cleaner
A
© 2007 Hoover,...your sales receipt and attach it to clean Recommended cleaning sequence 12 Cleaning floors 13 Picking up spills 13 Storage 14 Maintenance
Cleaning the nozzle 14 Cleaning the ...
Manual - Page 4
...
15
11 19
12
11
14 13
This user manual applies to release
cleaning solution 4. Nozzle release buttons: release nozzle for wet pickup and dry vacuuming 5. Cord hooks: top hook rotates
for household use. Cleaner Description
1 2
1
3
This cleaner is intended for quick cord release 19. ON/OFF switch 3. Clean solution tank...
Manual - Page 5
Turn brushes slightly until you hear it rests on the floor. Install brushes and nozzle
5
To install brushes, place handle in upright position. Align post (A) on brush block with slot in bottom handle
support (D).
4
Push upper ...
Manual - Page 8
...to the DRY VAC position.
CAUTION: To prevent damage to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile and sealed wood.
Mode selector dial
...floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position. General operation
Your HOOVER FloorMate™ SpinScrub™ Cleaner can be used to wood floors, follow the flooring...
Manual - Page 9
...,
laminate wood, polyurethane sealed wood or other tiles, some models include a set of HOOVER® Grout Cleaner*.
*Available at additional cost if not included with gray bristles.
The ...cup.
19
For hard surface floors such as these for tile floors where extra attention is to be cleaned using water, use one
A
cup (2 oz.) HOOVER® Floor to Floor™ Cleaner. Carry tank ...
Manual - Page 10
... cap. Fill tank to prevent leaking.
23
23
Slide tank straight into tank (B). Rotate cap clockwise until latch snaps in place for proper per- CAUTION: HOOVER® Grout Cleaner* cannot be locked in place.
10 Cap must be used in place. formance and to fill line (C) (1 quart) with warm water.
21...
Manual - Page 11
... straight out.
24
B
25 Remove tank lid (C). The filter may need to be emptied after dry vacuuming and before wet operation.
Remove filter lid (A), then remove filter (B). Recovery (lower) tank
Automatic shut-off... shut-off is low or reduced. When the shut-off activates, the cleaner will not pick up debris and the sound of the motor will change. Empty tank.
25
C
To clean filters
The ...
Manual - Page 12
... in place.
29
29
To replace recovery tank, place bottom of the floor surface.
30
The Mode selector dial turns the brushes on the filter screen...
Remove debris from the lid. E
How to clean
Recommended cleaning sequence
Use your HOOVER® FloorMate™ SpinScrub™ Cleaner to:
• Dry Vacuum to the DRY VAC position (A).
For wet pickup, turn the dial to the WET...
Manual - Page 13
...a loss of these conditions exist.
1 Set Mode selector dial to DRY VAC position and vacuum floor. Ensure that have been sealed with a polyurethane coating and can be cleaned with water....to operating position. Cleaning floors
NOTE: Your HOOVER® FloorMate™ SpinScrub™ cleaner may also be used to pick up the spill. Do not use the cleaner to pick up the dirty solution throughout...
Manual - Page 16
.... Turn cleaner OFF and disconnect from electrical outlet. Remove tanks to lock in the upright position. Remove nozzle.
Tilt cleaner back so handle rests on floor.
38
Push two brush release buttons (B) and remove the brush assembly. Replace nozzle, making sure latches (E) are out. A Place handle in place. The brushes can...
Manual - Page 17
... minor problems.
What's the problem? Cleaner won't run Low suction
Water puddling behind cleaner
Won't pick up dirty solution
Cleaner pushes a line of dry debris in front of it Cleaning solution won't ...selector dial to
turn cleaner ON.
it may be full
and the automatic shut-off floor by pushing down on
handle to pick up debris that is too large to clear the squeegee. Make sure solution tank...
Manual - Page 18
... the complete model number when requesting information or ordering parts. (The model number appears on -line at hoover.com OR Checking the Yellow Pages under "Vacuum Cleaners - In Canada, contact Hoover Canada, Carson Building, 100 Carson St., Etobicoke, Ontario M8W 3R9 Phone: 1-800-263-6376 Mon-Fri 8am-7pm EST. Lubrication
The motor is...
Manual - Page 19
... a limited one full year from date of purchase.
In Canada, contact Hoover Canada, Carson Building, 100 Carson St., Etobicoke, Ontario M8W 3R9 Phone: 1800-263-6376 Mon-Fri 8am-7pm EST.
19 This warranty provides, at hoover.com
This warranty does not cover pick up delivery, or house calls; Military Exchange.
however, if you...
Manual - Page 44
HOOVER y
son marcas registradas
HOOVER et
sont des marques déposées
HOOVER and
are registered trademarks
R5 7/07 H3030,H3032,H3040,H3044,H3045,H3030-050
Printed in China
59178-466
Similar Questions
Hoover Floor Mate 40010 Replacement Of Satin Silver Hose
All done but the big piece on the bottom won't fit back in in order to start the floormate
All done but the big piece on the bottom won't fit back in in order to start the floormate
(Posted by Cleany77 9 years ago)
How Do I Remove Handle From Hoove Floor Mate To Prepare For Shipping
(Posted by terryloul 10 years ago)
Hoover Floor Mate H3000 How Do I Connect The Solution Feed Tube To The Spray B
need a detailed parts dia. for the underside of mach.
need a detailed parts dia. for the underside of mach.
(Posted by onepenn 11 years ago)
Difference Between H3044 And H3045
Could you tell me the difference between the H3044 and H3045? Thank you. Joyce
Could you tell me the difference between the H3044 and H3045? Thank you. Joyce
(Posted by joycebickel 12 years ago)
Why Isn't There Any Suction From The Vacuum?
For some reason the vacuum is no longer picking things up. I've cleaned the filter and emptied the c...
For some reason the vacuum is no longer picking things up. I've cleaned the filter and emptied the c...
(Posted by patricksjoberg 13 years ago)