Hoover F7458-900 Support Question
Hoover F7458-900 Support Question
Find answers below for this question about Hoover F7458-900 - Widepath All Terrain Floor Cleaner.Need a Hoover F7458-900 manual? We have 1 online manual for this item!
Question posted by kahunro on April 2nd, 2014
How Do You Replace Collection Tank Handle On Hoover F7458900
The person who posted this question about this Hoover product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hoover F7458-900 Manual Pages
Product Manual - Page 1
...?
All rights reserved. #56518217 ID100262-R2 For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST. página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. IF USED COMMERCIALLY WARRANTY IS VOID.
©2011 Techtronic...
Product Manual - Page 2
...
Hint: Attach your HOOVER® product. Follow the authorized dealer locator link to register by phone. Fri 8am- 7pm EST.
Model
1-800-944-9200
MFG.
Verification of date of purchase may be required for an automated referral of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...7
Cleaner Description 7 The Tanks...8 How to Clean...10...
Product Manual - Page 3
...INJURY:
• To avoid internal component damage, use only Hoover® cleaning products intended for its intended use cord as a handle, close door on cord or pull cord around sharp edges... the carpet cleaner. • Do not unplug by or near children. Do not immerse product.
• Connect to run appliance over floor electrical outlets. • Do not use without tanks in the ...
Product Manual - Page 5
...F. NOTE: Phillips screwdriver needed for assembly. Upper Handle C. Cleaner ASSEMBLY
Carton contents
1.1
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner
G
C
H
D
F
I . Hose/Tool Caddy* G Hose H Stair/Upholstery Nozzle I
B
E
A
A. Attach handle
1.2 Remove tank.
1.3 Position cord protector.
1.4 Slide handle down.
1.5 Insert bolts and attach nuts. 1. Tighten...
Product Manual - Page 6
...
1.15 Store Tools on select models only)
1.10 Insert tabs.
1.11 Slide caddy down. Attach hose/cord hook
1.9 1.9 Snap hook onto
cleaner.
1.7
1.8
Attach tool caddy
(for storage on hook (C). Check tank to make sure it to cleaner.
Replace upper tank
1.6 Position bottom of tank onto cleaner.
1.6
1.7 Push top of tank and tank handle while supporting back of cleaner as shown.
1.15
Product Manual - Page 7
... be lifted by visiting www.hoover.com, or your cleaner from images shown.
HOW TO USE
Cleaner Description
1. SpinScrub® Hand Tool*
5
19
20
6. Clean Water Tank Handle
8. SpinScrub® Mode Selector 14. Cord/Hose Hook 23.
Carry Handle
6
7. Hose*
of nozzle to operating position. CAUTION !
24. DAMAGE YOUR FLOOR. To turn cleaner ON, push switch down. Dirty...
Product Manual - Page 8
SpinScrub® mode selector
Your SteamVac® cleaner has two agitator brush settings. POWER SCRUB -
Replace container cap and tighten.
2.11 Position bottom of tank onto cleaner using one hand on each side of the tank to center it on tank handle and pull forward.
2.9
F
2.10
2.8 Fill tank (E) with Hoover® Carpet/Upholstery Detergent.
CAUTION !
IMPORTANT
Use only ...
Product Manual - Page 9
In case of tank. Certain oxygenated-type cleaners, such as OxiClean* and TuffOxi** will stop and the tank must be a small amount of tank to unlock lid. IMPORTANT
Make sure the tank handle is a trademark of
C
Tuff Products for 15 minutes.
CAUTION !
Use only HOOVER® SteamVac® Oxy detergent for this purpose.
*OxiClean is a registered
B
A
trademark of...
Product Manual - Page 10
Do not use . Wet a white absorbent cloth with HOOVER® Spot & Stain Spray Cleaner*- When cleaning entire floor, move furniture out of the Dirty Water Tank
lid (B).
Vacuum thoroughly -
Test for best results. f. To avoid wetting and possible damage to a non-wood hard floor surface or place waterproof material (e.g. plastic) underneath them before ...
Product Manual - Page 11
...tanks will be emptied and filled.
3.2a
AUTO WASH RINSE
3.3
WASH AUTO RINSE
OFF
Rinse ON
Step on handle release pedal and lower handle to operating position.
3.1 Set Rinse Setting switch to keep the cleaner...and 2 without squeezing trigger (dry stroke).
Release trigger and slowly push cleaner forward over floor electrical outlets.
In this setting, rinsing will be done on the ...
Product Manual - Page 12
... spills
Your HOOVER® SteamVac® cleaner may vary from images shown. 12
If the spill remains, place either the stair/ upholstery nozzle or floor nozzle with suction only.
To help prevent matting and resoiling the carpet, keep children and pets away from surface until it . Rinse the Dirty Water Tank lid and let...
Product Manual - Page 14
...handle in sink and raising nozzle above your thumb, push forward and up for storage or placed back on the latch (H) to Attach Tools
! After Using Tool
Drain suction hose by turning cleaner ON and holding nozzle up on the cleaner.
4.7
4.8
Actual model may vary from moving parts, unplug cleaner... and remove hose from moving parts, unplug cleaner. Press the trigger.
4.8 The tool caddy...
Product Manual - Page 15
... on page 12 and "After Using Tool" instructions on stairs.
Fill detergent container with HOOVER® detergent according to instructions for Figs. 2.9 to aid in upright position.
Press ... water tank according to clean lower half.
!
Agitator brushes will not rotate while handle is completely dry before using the tool again. End with dry strokes.
WARNING ! Turn cleaner ON....
Product Manual - Page 16
...and press the solution trigger. Make crisscrossing strokes to remove more than 2 passes with HOOVER® detergent according to repeat the cleaning process.
overlap each pass.
Attach hose ... cleaner ON.
4.11 Gently press the tool onto the fabric.
Do not use .
Place handle in upright position. Dry hands and plug cleaner into a properly grounded outlet. Empty Dirty Water Tank...
Product Manual - Page 17
... hole (D). CAUTION ! To reduce the risk of nozzle.
Make sure that handle rests on the floor.
5.1 Lift up rear edge of injury from moving parts, unplug cleaner before servicing.
Slide nozzle up tabs (A) on properly. B A
Slide nozzle completely onto cleaner. Replace Dirty Water Tank (Fig. 2.16).
To reduce the risk of brush assembly with these directions...
Product Manual - Page 18
Replace on cleaner. • Empty Dirty Water Tank, rinse tank and lid
thoroughly with bearings that contain sufficient lubrication for at least 15 minutes. Lubrication
The motor is equipped with clean water and let air dry. Therefore, do not add lubricant to Unclog
Remove Clean Water Tank.
5.5-5.6 Turn valve cap (A) counter clockwise and remove. valve:
How...
Product Manual - Page 19
... empty.
3. Dirty Water Tank lid not on correctly.
2. Refill container according to aid in place.
Detergent won't dispense
Brushes/brush indicator won't rotate during floor cleaning.
1. Valve cap clogged.
1. Remove and clean valve cap (see instructions below . Clean screen.
CAUTION ! Unplug the cleaner before servicing. A 6.2
• Use HOOVER® brand detergents; B
•...
Product Manual - Page 20
...a customer service representative call 1-800-944-9200. Follow the service center link to Hoover®, Inc., Company in delay. If you . • For an automated referral... under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. 7. Service
To obtain approved Hoover® service and genuine Hoover® parts, locate the nearest Authorized Hoover® Warranty ...
Product Manual - Page 21
...® Quick & Light™
Hoover® SteamVac®
Hoover® MaxExtractTM Dual V®
Hoover® MaxExtractTM Dual V® All Terrain
Hoover
Platinum
Collection®
Hoover® FloorMate®
1 Allergens: pollen, pet dander, dirt, and...
Product Manual - Page 22
... to state.
22 This warranty does not apply to correct any replacement or repair performed under the laws of the state of Canada. Military Exchanges and Canada. This warranty does not cover products purchased from a party that vary from state to a Hoover® Sales and Service Center for a full one year from...
Similar Questions
I Need A Beater Bar End Cap For Hoover Floor Cleaner Model Fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
(Posted by scottgrippa 1 year ago)
Brushes Won't Turn On Hoover Max Extract All Terrain Carpet Cleaner
(Posted by whh5an 9 years ago)
Hoover Maxextract All-terrain Carpet Cleaner Detergent Won't Come Out
(Posted by Hennnewma 9 years ago)
How Can I Replace The Tank Lock Latch Lever? (there Are Two Of Them)
(Posted by jthelle 11 years ago)
Brushes Won't Spin On Hoover Maxextract All Terrain Carpet Cleaner
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
(Posted by tsbequette 12 years ago)