Honeywell RTH3100C Support Question
Honeywell RTH3100C Support Question
Find answers below for this question about Honeywell RTH3100C.Need a Honeywell RTH3100C manual? We have 1 online manual for this item!
Question posted by blpearsall on July 12th, 2018
Honeywell Rth3100c Function 6 Setting
A little booklet that came with the thermostat shows function 6 being set to 5 which says for gas or oilfurnaces. My furnace is an electric-heat pump system. Position 9 says for electric furnaces.I have another manual that I downloaded that says to set function 6 to 3 for heat pump.Who do I believe? It is working on position 5 at the moment.
Current Answers
Answer #1: Posted by BusterDoogen on July 12th, 2018 12:48 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
For assistance with this product, please visit http://yourhome.honeywell.com.
Or call Honeywell Customer Care toll-free at 1-800-468-1502.
To save time, please note your model number and date code before calling.
Or call Honeywell Customer Care toll-free at 1-800-468-1502.
To save time, please note your model number and date code before calling.
I suggest you use the setup shown in this models manual. This video may also be helpful.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Honeywell RTH3100C Manual Pages
Owner's Manual - Page 1
RTH3100C
Non-Programmable Digital Thermostat
Installation Guide
69-1889EF-1
Owner's Manual - Page 2
... http://yourhome.honeywell.com
or call Honeywell Customer Care toll-free at the furnace or the fuse/circuit breaker panel before you begin. Registered Trademark. All rights reserved. For assistance with this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. CAUTION: ELECTRICAL HAZARD...
Owner's Manual - Page 3
... tips 2 Pre-installation checklist 3
Old thermostat removal Remove old thermostat 5 Identify and label wires 6
New thermostat installation Wallplate mounting 8 Wire connections 11 Battery installation 13 Thermostat mounting 14
RTH3100C
System setup How to change settings 15 Set auxiliary heat cycle rate 16 Set emergency heat cycle rate 17 Set temperature display 18
Appendices In case...
Owner's Manual - Page 4
Just follow the simple, step-by-step instructions in three simple steps
• Label wires and remove your old thermostat (see pages 5-7). • Install and wire your new thermostat (see pages 8-14). • Set your heating/cooling system
(see page 7).
Installation tips
• Have everything you begin (see pages 3-4). • Do not use wire color...
Owner's Manual - Page 5
APrbeo-uintsytoaullratnieown cthercmkloissttat
Check to make sure your package includes the following items:
RTH3100C
RTH3100C thermostat (wallplate attached to back)
Operating Manual
Wall anchors and mounting screws
(2 each)
Wire Labels
Owner's Manual - Page 7
Is there a sealed tube containing mercury? RTH3100C
Leave wallplate in place. If so, see inside front cover of this manual for proper disposal instructions. Old thermostat
Cover
Remove cover and thermostat, but leave wallplate with wires attached. Turn off power at heating/cooling system (or fuse/circuit-breaker panel). 2.
Remove your old thermostat
1.
Owner's Manual - Page 8
Do not use
If any wires are not attached to terminals in your old thermostat, do not connect them to your new thermostat.
Wrap the bare metal ends of each unused wire with electrical tape, so it cannot touch and short out other wires. Installation Guide
Identify wires you will not use unconnected wires.
Owner's Manual - Page 9
...the label matching the letter on your old thermostat. (Adhesive labels are supplied in your thermostat package.) Remove the old wallplate only after ...all wires are labeled. Do not let wires fall into wall opening . E
IGNORE WIRE COLORS: Use only letter designations to disconnect wires one by one. As you disconnect each wire. RTH3100C...
Owner's Manual - Page 11
Level wallplate if desired (lay level across tabs). Mark positions of both screw holes.
AMbaoruktwyaolulprlanteewmthoeurnmtinosgtaptosition
1. Pull wires through wallplate.
2.
RTH3100C
3.
Owner's Manual - Page 13
Use a screwdriver to loosen screw terminals, insert wires, then tighten screws.
3.
Labels don't match?
Connect wires (typical installation)
1. If labels do not match letters on terminal.
2. Push any excess wire back into the wall opening. Match each labeled wire with same letter on thermostat, see next page.
11
RTH3100C
Owner's Manual - Page 15
Install batteries
Install two fresh AA alkaline batteries in back of thermostat 13
RTH3100C
Back of thermostat.
Owner's Manual - Page 17
Press s to advance to control the heating and cooling system in your home. RTH3100C
System setup (set thermostat to match your system)
Next, you must set the thermostat to next function. Press t to exit and save settings.
15
Press and hold the s and t buttons to enter system setup. Press and hold ts to change settings. Function number
6
Setting
Setup
5
To begin, press...
Owner's Manual - Page 18
...
Function 6: Auxiliary heat cycle rate
Setup
65
Press to the next function.
16
Press the t button to select your auxiliary heating system and optimize its operation:
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems 3 For hot water systems & furnaces of over 90%
efficiency 9 For electric furnaces
When finished, press to advance to change setting...
Owner's Manual - Page 19
... the t button to select your emergency heating system and optimize its operation:
9 For electric furnaces 1 For steam or gravity systems 3 For hot water systems & furnaces of over 90%
efficiency 5 For gas or oil furnaces of less than 90%
efficiency
When finished, press to advance to change setting. RTH3100C
Function 8: Emergency heat cycle rate
Setup
89
Press to the next function.
17
Owner's Manual - Page 20
Installation Guide
Function 14: Temperature display
Setup
14 0
Press the t button to select Fahrenheit or Celsius temperature display:
0 Fahrenheit temperature display (°F) 1 Celsius temperature display (°C)
Press to exit and save changes.
18 When finished, press and hold both buttons to change setting.
Owner's Manual - Page 21
... the temperature is set higher than the Inside temperature.
• Check circuit breaker and reset if necessary. • Make sure heating & cooling power switches are on . • Make sure furnace door is closed . • Wait 5 minutes for the system to Heat. In case of difficulty
RTH3100C
If you have difficulty with your thermostat, please try the...
Owner's Manual - Page 23
... Care toll-free at 1-800-468-1502. RTH3100C
For assistance with this product, please visit http://yourhome.honeywell.com. To save time, please note your model number and date code before calling.
Cover plate Part No. 50002883-001 *Use to remove thermostat from wallplate. Or call Honeywell Customer Care toll-free at 1-800-468...
Owner's Manual - Page 24
... .
Customer Care will make the determination whether the product should be returned to the following address: Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr. N., Golden Valley, MN 55422, or... within the terms stated above.
This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was in the workmanship or materials, under normal use and service...
Owner's Manual - Page 25
... or limitation of incidental or consequential damages, so this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr., Golden Valley, MN 55422 or call 1-800...HONEYWELL MAKES ON THIS PRODUCT.THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE ONE-YEAR DURATION OF THIS WARRANTY. RTH3100C...
Owner's Manual - Page 26
Rev. 04-06 Registered Trademark. © 2006 Honeywell International Inc. 69-1889EF-1 M.S. on recycled paper containing at least 10% post-consumer paper fibers.
® U.S. Automation and Control Systems
Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée 35 Dynamic Drive Scarborough, Ontario M1V 4Z9
http://yourhome....
Similar Questions
How To Reset Your Thermostat
I'm having a problem with my thermostat it's got cooling off heat an only working on E M Heat would ...
I'm having a problem with my thermostat it's got cooling off heat an only working on E M Heat would ...
(Posted by Quintinmoore48 3 years ago)
Thermostat Doesnâ??t Record Proper Temperature Readings And Forces Furnace
furnace kicks on and off multiple times and records inaccurate temperatures. Is this a furnace issue...
furnace kicks on and off multiple times and records inaccurate temperatures. Is this a furnace issue...
(Posted by Johnsonashleigh 5 years ago)
Will A Ct87k Thermostat Work For Oil Baseboard Hot Water Heat
(Posted by jcoffCONN 10 years ago)
How To Set Up Honeywell Heat Pump Nonprogrammable Thermostat Rth3100c
(Posted by yanSjever 10 years ago)