Honeywell RTH2310B Support Question
Honeywell RTH2310B Support Question
Find answers below for this question about Honeywell RTH2310B.Need a Honeywell RTH2310B manual? We have 1 online manual for this item!
Question posted by thaefs on October 4th, 2012
The Thermostat Temp Is 5 Degrees Higher Than Other Thermometers In The House
what can we do to get the correct indoor temperature on the thermostat. The temp is approx 5 degrees higher than others in the same area of the house
Current Answers
Related Honeywell RTH2310B Manual Pages
Owner's Manual - Page 1
Quick Installation Guide
RTH2310
Programmable Thermostat 69-2214EF-04
Owner's Manual - Page 2
...-468-1502.
1
Do you need assistance? Just follow the simple step-by-step instructions in the following pages.
1) Identify your system type. 2) Remove your old thermostat. 3) Identify the wires. 4) Mount the new wallplate. 5) Connect the wires. 6) If the wire labels don't match. 7) Specify the furnace type. 8) Install the batteries. 9) Install the...
Owner's Manual - Page 3
... the following systems:
• Gas, oil or electric furnace • Central air conditioner • a hot water system with heat pumps or multi-stage systems.
2
This thermostat is not compatible with or without pump • a millivolt system • a central heating and cooling system
If you are not sure of your system type...
Owner's Manual - Page 4
Do not remove wallplate yet. Quick Installation Guide
2 Remove Old Thermostat
2.
1) Turn power off at the heating/cooling system.
2) Remove old thermostat, but leave wallplate with wires attached.
Contact your old thermostat in the trash if it contains mercury in a sealed tube. MERCURY NOTICE: Do not put your local waste management authority for instructions...
Owner's Manual - Page 5
... screw designations to prevent them from falling though the wall opening.
4 If any wires are not attached to your old thermostat or are labeled.
Do not use C or C1 wires
Identify and label each of each wire. Do not use non... to a terminal marked C or C1, they will not be connected to your new thermostat. Wrap the wires around a pencil to identify wires.
RTH2310 Programmable...
Owner's Manual - Page 6
Quick Installation Guide
4 Mount New Wallplate
4.
1) Remove coverplate.
2) Loosen screw (the screw remains captive on wallplate).
3) Remove thermostat.
4) Mark and drill appropriate mounting holes (or use existing holes). Pass wires through opening of wallplate and secure wallplate to the wall using provided screws.
5 Insert plastic anchors.
Owner's Manual - Page 7
... with the terminal having the same letter.
2) Loosen the terminal screws using a screwdriver, insert the wires, then tighten the screws.
3) Push any terminal on the thermostat, see next page.
6 Labels don't match? If a wire does not match any excess wire back into the wall opening.
Owner's Manual - Page 9
J2 jumper
HG Leave the jumper in this position if you have an electric furnace.
8 Set the Jumper J2, on the back of the thermostat, if you have connected a wire to the G terminal. HE Place the jumper to this factory-set position if you have a gas or oil furnace.
RTH2310 Programmable Thermostat
7 Specify Furnace Type
6.
Owner's Manual - Page 10
Observe the
polarity. 3) Reinstall the battery cover. After the batteries are holding the thermostat. The thermostat will hear a clicking
sound. By default, the setpoint is normal that the displayed temperature be higher than the ambient temperature if you are installed, the thermostat performs a series of tests for approximately 5 seconds. It is 70 °F (21 °C).
9 You ...
Owner's Manual - Page 11
RTH2310 Programmable Thermostat
9 Install thermostat
8.
1) Mount the thermostat on the wallplate.
2) Tighten the screw and install the coverplate.
3) Turn power back on at the heating/cooling system.
10
Owner's Manual - Page 12
DISPLAY
DESCRIPTION
OPTIONS 1
Temperature display
°C or °F
Time display
12 h or 24 h
Early Start 2
On or Off
Heating cycles per hour 3
2, 3, 4, 5 or 6 4
Cooling cycles per hour 3
2, 3, 4, 5 or 6 5
1 Default ...
Owner's Manual - Page 13
Guide d'installation rapide
RTH2310
Thermostat programmable 69-2214EF-04
Similar Questions
What Does It Mean When The # 3 Is In The House Symbol On The Thermostat?
We replaced the furnace filter last night but there is a house symbol on the thermostat and the air ...
We replaced the furnace filter last night but there is a house symbol on the thermostat and the air ...
(Posted by yvonne5643 7 years ago)
Why Is The T'stat Temp 5 Degrees Below The Air Temperature?
(Posted by jwbe36348 10 years ago)
Why Does My Rth111 Thermostat Reads 10 Degrees Higher Than It Should?
(Posted by zenobug 11 years ago)
Why Is Thermostat Temperature Set 5 Degrees Higher Than Required
(Posted by perhar71 11 years ago)
Indoor Thermometer Temperature Reading (r)doesn't Change With Indoor Temperature
The thermometer seems to be broke and stuck at 76 even as the temperature changes. An independent th...
The thermometer seems to be broke and stuck at 76 even as the temperature changes. An independent th...
(Posted by dwbradway 11 years ago)