Homelite UT09521 Support Question
Homelite UT09521 Support Question
Find answers below for this question about Homelite UT09521.Need a Homelite UT09521 manual? We have 4 online manuals for this item!
Question posted by jeffvungtau on September 16th, 2013
Stops Running
The blower will start but then will die after several seconds or a few minutes. It will start up then it does the same thing.
Current Answers
Related Homelite UT09521 Manual Pages
User Manual - Page 5
....
Do not operate this unit.
Never start or run the engine inside the muffler.
Product users on the blower must comply with the inhalation of dust.
Check the...the engine to cool.
Empty fuel tank into your body away from moving parts have stopped. breathing exhaust fumes can kill.
Always wear eye protection with side shields marked to ...
User Manual - Page 6
... container in a well-ventilated area. Select bare ground, stop the engine before starting the engine. Prolonged periods of operation can be appropriate to vibration. For...blower nozzle in the direction of people or pets.
Never run the unit without the blower tubes installed. Never place objects inside the blower tubes. Use only as blowing leaves and lawn...
User Manual - Page 7
... protection.
Page 5 -
Some of these symbols will result in death or serious injury. Do not run unit without tubes in place.
SYMBOL
NAME
EXPLANATION
Safety Alert Symbol
Indicates a potential personal injury hazard.
Blower Tubes
Do not run unit if the air inlet cover becomes opened, damaged, or unsecured in any way. CAUTION:
Indicates...
User Manual - Page 8
... operated at housing) Weight...9.6 lbs. English
UPPER BLOWER TUBE AND SWEEPER NOZZLES
The blower tube and sweeper nozzle can be assembled and installed... jobs.
Page 6 - Before use of this product requires an understanding of the information on the blower without using any speed between idle and full throttle.
FEATURES
PRODUCT SPECIFICATIONS
Engine Displacement...26cc Air Velocity:...
User Manual - Page 9
...
To prevent accidental starting that all hang tags and store with this product until you unpack it.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
Align raised tabs on blower housing outlet to ...-4672 for use and retighten if needed .
To remove, rotate the upper blower tube and sweeper nozzle to modify this product or create accessories not recommended for assistance.
...
User Manual - Page 10
... FUEL. Blower should be required. Remember that can start - The... fuel mixture carefully into your lawn Keeping decks and ...run (no more than 4 pulls). NOTE: We recommend you see fuel in serious personal injury.
Ethanol. STARTING AND STOPPING
See Figure 3.
Do not use of an oxygenated fuel containing more than the percentages of a second is normal for starting...
User Manual - Page 11
... grip until the engine runs.
not early in burns and/or other equipment, CLEAN UP! TO STOP THE ENGINE:
To stop position " ". OPERATION
Set the choke lever to the stop the engine, set the choke lever to the ground.
After using power blowers instead of hoses for many lawn and garden applications, including areas...
User Manual - Page 12
...leaks.
If you notice a power loss with plastic parts. Spark arrestors may need to stop, and disconnect spark plug wire and move it away from various types of commercial solvents ... do so could cause serious personal injury. WARNING:
To avoid a fire hazard, never run the blower without the spark arrestor in a fire that only qualified service technicians perform this service.
Failure...
User Manual - Page 13
.... Page 11 - Keep away from corrosive agents such as garden chemicals and de-icing salts.
Abide by all fuel from the product.
An engine adjusted for the safe storage and handling of gasoline. In order to maintain this engine if it stops.
Run engine until it is inaccessible to children. HIGH ALTITUDE...
User Manual - Page 14
...plug.
Ignition lead wire shorted, broken, or Replace lead wire or attach to start . Ignition inoperative.
plug. Contact authorized service center. Water in tank.
Contact ... SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.
Engine hard to start . Engine overheats. CAUSE
REMEDY
No fuel in gasoline or stale fuel mixture. Spark ...
User Manual - Page 15
... rental or commercial. Bump Knobs, Outer Spools, Cutting Lines, Inner Reels, Starter Pulleys, Starter Ropes, Drive Belts, Tines, Felt Washers, Hitch Pins, Mulching Blades, Blower Fans, Blower and Vacuum Tubes, Vacuum Bags and Straps, Guide Bars, Saw Chains
Homelite reserves the right to change or improve the design of purchase.
Two...
User Manual - Page 16
...:
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
(i) Controlled hot air intake system.
(ii) Intake manifold.
(iii) Air filter.
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto...
User Manual 2 - Page 1
HOMELITE 26cc BLOWER MODEL NO. UT09521 ALL VERSIONS REPAIR SHEET
User Manual 2 - Page 3
MODEL NUMBER UT09521
PARTS LIST (FIGURE A)
KEY NO.
HOMELITE 26cc BLOWER - MAY BE PURCHASED LOCALLY 3 PART NUMBER DESCRIPTION
QTY
1
570543002 Upper Blower Tube...1
2
580537002 Sweeper ...940654088 Combustion Warning Label...1
11
940868002 Choke Label...1
12
940734078 Starting Instructions Label...1
Not Shown:
988000332 Operator's Manual...1
11-19-10 (REV...
User Manual 2 - Page 5
... 1
44
561635001 Primer Bulb 1
45
901551001 Heat Dam Gasket 1
46
521608001 Choke Cover 1
47
660345001 Screw (M4 x 12 mm, T.F 1
48
300759005 Fuel Filter 1
5 MODEL NUMBER UT09521
KEY NO.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
PARTS LIST (FIGURE B)
PART NUMBER
DESCRIPTION
QTY
KEY...
Engine Starting Procedure - Page 1
... into fuel tank.
Color: Yellow. FRONT WARNING: This Engine Starting Procedure is already hot:
ENGINE STARTING PROCEDURE
3 6 8
5 7
4 9
1
2
SET choke lever to the STOP position. TO RESTART A WARM ENGINE:
If the engine/unit is not a substitute for 10 seconds, SET choke lever to RUN. Go to step 3.
TO START:
1
2.6 oz.
1 GALLON
GAS
2
50:1 Ratio = Mix 2.6 oz 2-cycle...
Similar Questions
Replacing The Momentary Stop Switch
I am ready to reinstall the new stop switch but I do not remember which wire is connected to which e...
I am ready to reinstall the new stop switch but I do not remember which wire is connected to which e...
(Posted by Melissadee78 6 years ago)
Blower Does Not Start In Vacuum Position
Blower starts in blower position but not in vacuum position
Blower starts in blower position but not in vacuum position
(Posted by georges46584 9 years ago)
Will Not Start, Sometimes Tries To Fire, But Will Not Continue To Run.
(Posted by freddie64123 9 years ago)
Ignision Coil
how much space should i leave betwwen ignition coil and flywheel on my homelite blower (Ut09521)
how much space should i leave betwwen ignition coil and flywheel on my homelite blower (Ut09521)
(Posted by riteshpatel2002 10 years ago)
How To Replace The Ignition Module On Homelite Ut09521
What is the gap supposed to be between the ignition module and the flywheel? How to properly seat t...
What is the gap supposed to be between the ignition module and the flywheel? How to properly seat t...
(Posted by treeant34 10 years ago)