Hayward Turbo Cell Support Question
Hayward Turbo Cell Support Question
Find answers below for this question about Hayward Turbo Cell.Need a Hayward Turbo Cell manual? We have 3 online manuals for this item!
Question posted by landmarkmg on June 8th, 2012
Replaced Aqua-rite T-cell-15 With Hayward Turbo Cell 15. No Salt Reading.
Had salt checked at 28000 ppm
Current Answers
Related Hayward Turbo Cell Manual Pages
Model: T-CELL-3 - Page 1
... MENU SETTING REQUIRED!
The T-CELL-3 and GLX-CELL-3-W are compatible with the T-CELL-3 or GLX-CELL-3-W chlorinator cell before attempting to an AQR-PRO: 1. firmware version 1.5 or later • AQR-PRO (Aqua Rite Pro) - To change cell type, slide the Main Switch from "Auto" to "Super Chlorinate" and back to 15,000 gallons. Push the Diagnostic button to the...
Model: T-CELL-3 - Page 2
...up and down keys on your Aqua Rite Pro, Aqua Logic or Pro Logic system.
If the readings stabilize in the 13 ppm range then you plan on ...check your filter pump operating time (say from 12 hours/ day to ensure operation is normal. IMPORTANT INFORMATION
Regarding Extended Pool Filtration cycles, and Low Flow Rate conditions
THE AMOUNT OF CHLORINE PRODUCED BY YOUR HAYWARD/GOLDLINE SALT...
Model: T-CELL-9 - Page 1
... version is less that 4.10, the T-CELL-9 or GLX-CELL-9-W cannot be used . 2. peatedly pushing the ">" until "t-xx" appears on the display ("t-15" is displayed, then push "+". 4. Enter the Configuration Menu. 3. Config is the factory
default). 3. all 2009 or later) - firmware version 1.5 or later • AQR-PRO (Aqua Rite Pro) - Push the Diagnostic button repeatedly...
Model: T-CELL-9 - Page 2
... 3. WHEN USING 2 SPEED OR VARIABLE SPEED PUMPS ON LOW SPEED, CHECK TO BE SURE YOUR SALT CELL IS RECEIVING ADEQUATE FLOW.
If you are preventing the over-chlorination or under-chlorination of 2 (say from 12 hours/ day to 8 hours/day), then increase your Aqua Rite, or the up or down keys on your chlorination setting...
Model: T-CELL-15 - Page 1
...the factory
default). Push ">" until Chlor. Exit Settings Menu by pushing the "Settings" button. 2. When replacing an existing T-CELL-15 or GLX-CELL-15, no re-configuration is necessary with the following models: • AQR (Aqua Rite - firmware earlier than version 1.5 • AQ-RITE-XL (Aqua Rite XL)
Connecting to exit. Access the Settings Menu by pushing the "Menu" button...
Model: T-CELL-15 - Page 2
... check your chlorination setting by a factor of 2 (say from 12 hours/ day to 8 hours/day), then increase your Aqua Rite Pro, Aqua Logic or Pro Logic system. By properly adjusting your setting, you are APPROXIMATIONS to 16 hours/day), then reduce your chlorination setting by a factor of your pool requires. If the readings stabilize in the cell...
Similar Questions
How To Recalibrate Your Hayward Aqua Rite Turbo Cell P-4
(Posted by alexudoa 10 years ago)
How To Calibrate Compupool Generic Aqua Rite (t-cell-15) Replacement Salt Cell
with aqua rite system
with aqua rite system
(Posted by markvGu 10 years ago)
Replacing Aqua Collection T15 Turbo Cell
Can I replace my old aqua collection turbo t15 cell with a hayward swim pure t15 Cell?
Can I replace my old aqua collection turbo t15 cell with a hayward swim pure t15 Cell?
(Posted by Rrisk 10 years ago)