Hayward TigerShark Support Question
Find answers below for this question about Hayward TigerShark.Need a Hayward TigerShark manual? We have 2 online manuals for this item!
Question posted by mahassani on February 21st, 2013
How To Replace Floating Power Cord For Aquavec Hayward Pool Electric Cleaner
how to
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Hayward TigerShark Manual Pages
All Models - Page 3
... warranty period, repairs will be repaired at its sole option and own expense, replace the Tigershark or any warranties or representations concerning Aqua Vac Pool Cleaners, Inc.'s products or to comply with carefully specified engineering requirements.
Years
COVERAGE Parts & labor on electrical supply not as indicated are not covered by anyone other failures of the...
All Models - Page 6
...pool water chemistry, improper installation, and other factors. Throughout this manual reference to any pool plaster or vinyl liner in Customer's pool. Connect the floating cable (#2) to minimize cord...the use the cleaner in Customer's pool by Hayward Pool Products.
4. Use only the original TigerShark Power Supply manufactured by reason of the Cleaner. Deterioration, discoloration...
All Models - Page 9
...cleaner must be in the remote control may need to avoid cleaner floating.
9 To reset depress the small black button located above the flotation cord connection on the front of the power...Turn cleaner off and remove from the pool. The distance between the remote control and the power supply. HAND HELD REMOTE CONTROL
Troubleshooting the remote control function
If the TigerShark Plus...
All Models - Page 11
... the inside of the bottom lid. • Replace the filter cartridge in the opposite diagonal position (Fig.
b). Also, periodically stretching the cord out in the sun should be checked periodically for thorough cleaning. e).
• Pull out the filter cartridge. Remember: The cleaner your cleaner will then circle the pool in lock position. • Filter cleaning...
All Models - Page 12
...TigerShark cannot climb pool walls:
• Clean the filter. Check and clean if necessary following the instructions in water and reset the power. FAQS" at our website for lifting fine or heavy debris. Replace...avoid clogging the TigerShark's filter elements, be clogged or too heavy from the pool before operating the cleaner. • In a pool with debris. If TigerShark starts working ...
All Models - Page 13
...Tigershark/TigerShark 2 Height 19 in. (48.3 cm) Width 19 in. (48.3 cm) Length 19 in. (48.3 cm) 42 lbs (19.1 kg)
21 in. (53.3 cm) 19 in. (48.3 cm) 21 in different swimming pools and electrical... AC (220-240 volts for TigerShark 2®) Floating High Impact ABS - Voltage
24V DC
22V DC
5V DC
Current (amp)
2.62
0.63 - Self-Diagnostics
Electronic Power-On Self-Test w/Memory - For...
All Models - Page 18
... any twists that may be present in the handling of the vacuum and inspect the electrical cord frequently for safety. ALWAYS STAY OUT OF THE POOL WHILE CLEANER IS IN OPERATION.
7. NEVER ALLOW PLUG TO ENTER THE POOL.
8. IMPORTANT SAFETY INSTRUCTIONS
The TigerShark automatic swimming pool vacuum cleaner has been manufactured with fresh water and remove any other...
All Models - Page 1
...; SERIES
by
Owner's Manual
ROBOTIC POOL CLEANER
Models: TigerShark, TigerShark QC, TigerShark Plus, TigerShark2, TigerShark2 Plus
IMPORTANT SAFETY INSTRUCTIONS
...that could cause serious personal injury, death or major property damage and if ignored presents a potential hazard.
Hayward Pool Products 620 Division Street, Elizabeth, NJ 07201
Phone: (908) 351.5400 www.haywardnet.com CAUTION warns ...
All Models - Page 2
... can result in off .
WARNING -
WARNING - Hazardous Pressure. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 2 of two functioning suction outlets per pump installed in violent separation
of the pump housing and cover, and/or filter housing and clamp due to use Pool or Spa if any suction outlet component is discharged. o Installation of a vacuum...
All Models - Page 3
... GFCI, push the test button. A permanently-installed pool is flowing, indicating the possibility of 16
ROBOTIC POOL CLEANER
ISRC10202 REV C SAVE THESE INSTRUCTIONS
HAYWARD® Pool Products Limited Warranty
To original purchasers of electric shock replace damaged wiring immediately.
WARNING - Power should interrupt power.
Hazardous voltage can cause serious or fatal...
All Models - Page 4
DO NOT start cleaner out of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C
In order to ensure
cleaner's optimal performance. 2. Cleaner may periodically go to "On" position when unit is a normal part of 10 feet from the pool that it is excessively dirty. 3. Only plug into a GFCI (Ground Fault Circuit Interrupter) protected 110-120...
All Models - Page 5
... the pool by Hayward Pool Products.
4.
Keeping the TigerShark permanently in order to the pump & drive motor seals, which will go into Quik Clean cycle. Page 5 of 10 feet from the water at a minimum distance of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Connect the floating cable (page 9, #2) to the "on page 9. Connect the power...
All Models - Page 7
... of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C The TigerShark QC pool cleaner will automatically shutoff in 4 hours. The Remote Control can be indicated by the light on the cycle selection switch located on the cycle selection switch. When the TigerShark QC model is indicated by the light on the power supply. If the...
All Models - Page 8
... buttons (along the right side of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Turn cleaner off and remove from floating. Pressing on the power supply. • The Turning Foot may be tripped. HAND HELD REMOTE CONTROL
TROUBLESHOOTING THE REMOTE CONTROL FUNCTION
If the TigerShark Plus does not turn when the remote control is...
All Models - Page 9
PART REFERENCE
Ref. # 1 2 3 4 5 6 7
Description Power Supply Floating Cable 55' / 100' Handle Handle Latch On/Off Switch Bottom Lid Latch Bottom Lid Assembly
Ref. # 8 9 10 11 12 13 14
Description Filter Cartridge Impeller Tube Drive Track Wheel Wheel Brush Motor Unit (Sealed) High Velocity Inlet
Page 9 of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C
All Models - Page 10
... (page 6, Fig 2).
• Remove any debris that you may or may become coiled (like a telephone cord).
Reverse handle position after each use to remove debris. Your cartridge is out of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Using a garden hose with a spray nozzle, pressure-wash the filter elements to avoid...
All Models - Page 11
... HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Opening
the Motor Unit will automatically VOID your TigerShark require
dealer service (page 13, Fig. This inlet creates extra suction for additional information. You may be sure all chemical powders are stuck. Inspect brushes and replace if worn. j). • The sealed Motor Unit (page 9, #13) and the Power...
All Models - Page 12
... Drive Track & Acetal/Stainless Steel Bearing System
Power Supply
Primary Voltage Secondary Voltage Rated Output Current Weight
110-120 volt AC (220-240 volts for TigerShark2) Floating High Impact ABS - Double Redundant Radial Shaft Seals & 0-Rings.
Metal Parts of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C Sealed, Watertight, High Impact...
All Models - Page 15
... identify them by page and fig #. Laying
cord, straightened out in the water. • Inspect belts and filters frequently. be minimal if the unit is helpful. • Avoid allowing the unit to continual product improvement, parts may vary depending on the year of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ROBOTIC POOL CLEANER
ISRC10202 REV C
All Models - Page 16
... records. ROBOTIC POOL CLEANER
Warranty Card Registration
Register online at www.haywardnet.com
Please Print Clearly: First Name Last Name Street Address City State___________ Zip Phone Number Purchase Date E-Mail Address Serial Number
Years Pool has been in a safe and convenient location for :
In Ground
Above Ground
Spa
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 16...
Similar Questions
Can The Power Cord On Model Rc9990 Be Replaced With A Foam Cord From An Older On
The vinyl power cord for the Rc9990 is junk...it constantly twist itself up even when you reverse th...
The vinyl power cord for the Rc9990 is junk...it constantly twist itself up even when you reverse th...
(Posted by steveconar 9 years ago)
How To Replace The Power Cord On A Tiger Shark Pool Sweeper?
(Posted by migmuta 10 years ago)
How Do I Change Floating Power Cord On My Shark Robot
(Posted by Vicjo 10 years ago)