Hayward Pro Series Side-Mount Support Question
Hayward Pro Series Side-Mount Support Question
Find answers below for this question about Hayward Pro Series Side-Mount.Need a Hayward Pro Series Side-Mount manual? We have 3 online manuals for this item!
Question posted by bmeroney51 on August 25th, 2021
How Are Laterals Removed From Hayward S310s Sand Filter?
Sand is removed. I want to check integrity of laterals, Can they be removed and inspected without removal of inlet and outlet tubes?
Current Answers
Answer #1: Posted by SonuKumar on August 26th, 2021 12:45 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,653,150
Member since:
May 9th, 2021 Points: 16,653,150
https://www.youtube.com/watch?v=HpEpQp-3yhA
https://www.youtube.com/watch?v=F3MdM18FWx8
https://www.hayward-pool.com.au/assets/documents/poolsaustralia/pdf/manuals/ProSeriesSideMount.pdf
https://www.haywardflowcontrol.com/assets/documents/pools/pdf/hstc/literature/ProSeries-SM.pdf
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Hayward Pro Series Side-Mount Manual Pages
Models: S210S S244S - Page 1
...for personal injury.
SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207 Tel: ...'S MANUAL
INSTALLATION, OPERATION & PARTS
IS210S-06 Rev B
MODELS S210S, S244S PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be followed, including the following signal words and...
Models: S210S S244S - Page 2
... - All electrical wiring MUST be blocked by young children. Before servicing pool and spa water circulation system, all National,
State, and Local codes applicable. Do not operate pool and spa circulation system unless filter manual air relief valve body is discharged.
Failure to keep suction outlet components clear of the pump housing and cover, and/or...
Models: S210S S244S - Page 3
... on how to install and/or service the filter.
1.
Your Hayward Pro Series high-rate sand filter is automatically directed by the sand bed, and filtered out. This means it is backwashed (cleaned) of time, the accumulated dirt in place on Page 5.)
d. Assemble pump and pump mounting base (if supplied) to the filter according to the bottom of operation.
f. Electrical...
Models: S210S S244S - Page 4
...filter is a large amount of Hayward Pool Products, Inc.
FILTER CONTROL VALVE FUNCTIONS
FILTER-Set valve to BACKWASH. When filter pressure gauge rises 6-8 PSI (0.41-0.55 BAR) above start pump for proper operation of filter sand.... Insufficient chlorine or an out of underdrain laterals.
To properly sanitize your local authorized Hayward dealer or service center. Depress Vari-Flo control...
Models: S210S S244S - Page 5
... Assembly (S210S) Bottom Elbow Assembly (S244S) Lateral (Screw in) Prior 2005(20") Lateral (One piece) (20") Lateral (Screw in) Prior to 2005 Lateral (One piece) Lateral Holder Assy w/S200DN Lateral Holder Assy w/S240DN Plastic Air Tube (S210S) Plastic Air Tube (S244S) Air Tube Lock Screw Drain Cap Kit (Round) Drain Cap Assy Sand shield, corrugated Filter Stand Support O-Ring (Large) (S210S...
Models: S210S S244S - Page 6
...Check surface of sand if necessary).
4. chlorine will naturally dissipate
CHLORINE (STABILIZED) 1.0 to 70 ppm Add Stabilizer
Dilution - WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Backwash filter. Operate filter for debris.
2. for your records. POOL WATER WON'T CLEAR UP
1. POOL CHEMISTRY GUIDELINES
SUGGESTED POOL... or caking (remove 1 "
of filter sand
3.
Models: S210S S244S - Page 7
...improper installation, use or care, shall be responsible for cartage, removal and/or reinstallation labor or any other rights, which become defective...Hayward Pool Products, Inc.
All other products from Hayward:
Type of In-Ground Pool:
□ Vinyl □ Fiberglass □ Gunite
Size of 8
MODEL S210S, S240T
IS210S-06 Rev B
HAYWARD® LIMITED WARRANTY
This equipment was inspected...
Models: S210SV S244SV - Page 1
...a potential hazard. SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207 Tel: ...
OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
IS210SV Rev B
MODELS S210SV, S244SV PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be alert to the potential for personal injury. ...
Models: S210SV S244SV - Page 2
... and distances to remove pressure test plugs and/or plugs used as listed on the equipment. Stand clear of the body or limbs can result in mechanical entrapment. Do not operate pool and spa circulation system if a system component is damaged, broken, cracked, missing, or not securely attached. WARNING - Suction outlets in filter upper body...
Models: S210SV S244SV - Page 3
... and should be installed, not more than 6 feet above pool water level, on electrical connections. This helps protect the under-drain laterals from internal diffuser elbow pipe. WARNING - Use no more than the recommended amount of pool water through your filter.
Your Hayward Pro Series high-rate sand filter is continuous and automatic and provides for bonding requirements. As...
Models: S210SV S244SV - Page 4
... and LOCKED by unscrewing drain cap at base of Hayward Pool Products, Inc. WARNING - Once water flow is clean. (It will vary from pool to pool depending upon the pump and general piping system.) As the filter removes dirt and impurities from the pool water, the accumulation in your filter operation schedule based on piping system and valving...
Models: S210SV S244SV - Page 5
...Lateral (Screw in) Prior 2005(20") Lateral (One piece) (20") Lateral (Screw in) Prior to 2005 Lateral (One piece) Lateral Holder Assy w/S200DN Lateral Holder Assy w/S240DN Plastic Air Tube (S210S) Plastic Air Tube (S244S) Air Tube Lock Screw Drain Cap Kit (Round) Drain Cap Assy Cap Plug Filter...
FILTER
LBS
KG
SAND**
0.45-0.55mm 200
90
0.45-0.55mm 300
135
**Also known as No. 20 Silica Sand....
Models: S210SV S244SV - Page 6
... range (adjust as required). Operate filter for algae in pool and superchlorinate as required.
2. Be sure Vari-Flo valve is sufficient.
3. Check for longer periods. for debris.
2.
POOL WATER WON'T CLEAR UP
1. Check chlorine, pH and total alkalinity levels and adjust as required.
2. Check skimmer and pump strainer baskets for crusting or caking (remove 1 "
of filter sand
3.
Model: S310S - Page 1
.../or death.
SAVE THIS INSTRUCTION MANUAL
Use only High Rate Sand No. 20 Silica Sand (.45mm - .55mm)
HAYWARD POOL PRODUCTS, INC.
620 Division Street Elizabeth, NJ 07207 Tel: 908-351-5400 WWW.HAYWARDPOOL.COM OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
IS310S Rev B
MODELS S310S PRO™ SERIES HIGH RATE SAND FILTERS
Basic safety precautions should always be followed, including the...
Model: S310S - Page 2
... in suction outlet cover. Do not operate pool and spa circulation system unless filter manual air relief valve body is running .
Hair can result in an increase potential for suction entrapment as the filtration system, pumps and heater must be positioned so as to prevent their being
used in winterization of the pool/spa from
near...
Model: S310S - Page 3
... manually resequenced to Rinse, and then Filter, to the bottom of time, the accumulated dirt in
firmly. Your Hayward Pro Series high-rate sand filter is a high performance, totally corrosion-proof filter that it is loaded into the filter tank and functions as recommended by your pool dealer.
Filter sand is directed to resume normal filtering. This entire sequence is time to...
Model: S310S - Page 4
... the pump, set valve to waste.
Leave valve in your local authorized Hayward dealer or service center. PLEASE REALIZE: Pure, clear swimming pool water is not necessary for continuous operation. However, this "inactive" position.
3. Page 4 of underdrain laterals.
WASTE-To bypass filter for draining or lowering water level and for regular vacuuming. CLOSED-Shuts...
Model: S310S - Page 5
... B
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Top Closure Dome Valve/tank o-ring Flange Clamp Filter Tank w/Base Top Diffuser Elbow Assembly Elbow Assembly Lateral (Screw in) Prior 2005 Lateral (One piece) Lateral Holder Assy Plastic Air Tube Air Tube Lock Screw Drain Cap Kit (Round) Drain Cap Assy Sand shield Filter Stand Support O-Ring Bulkhead Fitting...
Model: S310S - Page 6
...) 0.3 to 70 ppm Add Stabilizer
Dilution - Page 6 of sand if necessary).
4. SHORT FILTER CYCLES
1. Check chlorine, pH and total alkalinity levels and adjust as required). Check skimmer and pump strainer baskets for longer periods. POOL WATER WON'T CLEAR UP
1. for crusting or caking (remove 1 "
of 8
MODEL S310S
IS310S Rev B
Pipe Size [mm]
1" [32]
MAXIMUM RECOMMENDED...
Model: S310S - Page 7
... returned, transportation paid, to the nearest authorized Hayward service center.
Hayward Pool Products, Inc. 620 Division Street Elizabeth, NJ 07207
▼DETACH HERE: Fill out bottom portion completely and mail within 90 days of the receipt of 8
MODEL S310S
IS310S Rev B
HAYWARD® LIMITED WARRANTY
This equipment was inspected before shipment from our plant. Mail to...
Similar Questions
How To Remove Laterals From Hayward Side Mount Filter
(Posted by pelrdh0819 1 year ago)
Remove Lateral Unit.
How to remove a laterals from a S244S Hayward side mount filter?
How to remove a laterals from a S244S Hayward side mount filter?
(Posted by gmcclendon62 7 years ago)
Leaky Bulkhead Fitting On S244s Sand Filter
i have a leak i believe is coming from one of the bulkhead penetrations on my filter. is there a spe...
i have a leak i believe is coming from one of the bulkhead penetrations on my filter. is there a spe...
(Posted by exitalabama 9 years ago)
How Do I Remove The Outlet Fitting On My Super Hayward Pump That Rusted And
broke?
broke?
(Posted by fige 10 years ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)