Hayward Pro-Grid Support Question
Hayward Pro-Grid Support Question
Find answers below for this question about Hayward Pro-Grid.Need a Hayward Pro-Grid manual? We have 3 online manuals for this item!
Question posted by Dougjui on June 1st, 2014
Hayward De Filter How To Install To Replace Top Collector Manifold
The person who posted this question about this Hayward product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hayward Pro-Grid Manual Pages
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 1
...
144
545
9.0
MAXIMUM WORKING PRESSURE FOR ALL MODELS 50 PSI (3.45 BAR)
KGS 1.4 2.0 2.7 3.4 4.0
ATTENTION INSTALLER: THIS MANUAL CONTAINS IMPORTANT INFORMATION ON THE OPERATION, AND SAFE USE OF THIS EQUIPMENT.
ISDE2423 Rev C INSTALLATION, OPERATION, & PARTS
PRO-GRID VERTICAL DE FILTER SERIES
MODEL
DE2420 DE3620 DE4820 DE6020 DE7220
EFFECTIVE FILTRATION RATE
DESIGN FLOW RATE
RECOMMENDED...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 2
...over or near filter. • If water leakage appears in the pool and spa equipment. Reassemble the clamp system per the instructions in the OPEN position. • Use ONLY Hayward clamp system ...system and pump controls are important but not related to the pool by a qualified pool professional. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 2 of access to hazards. CAUTION To reduce risk...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 3
...FILTER... clear of 12
Pro-GridTM VERTICAL D.E. ...installed. Suction outlet covers and grates have a finite life.
USE ONLY HAYWARD GENUINE REPLACEMENT...installed a minimum of three feet (3') [.94 meter] apart, as measured from the suction outlets can result in an increased potential for such seating areas.
• The pool or spa circulation system shall be inspected frequently and replaced...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 4
... will drain by a qualified professional. Connect the pool suction plumbing between the skimmer, pool outlet and the pump. 6. It uses diatomaceous earth (D.E.), which is time to clean (backwash) your
filter. Do not over or near filter. 9. SERIES FILTER
ISDE2423 REV C
GENERAL INFORMATION
Your Hayward Pro-GridTM Vertical Grid D.E. Filter combines superior water filtration with the two...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 5
.... Figure 3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Verify that upper and lower filter bodies are missing, damaged or not genuine Hayward components. (See Fig 2) 2.
As the filter removes dirt from the filter to return to backwash more than a minute or two without the D.E.
Non-Hayward clamp components may be necessary to the pool. 4. SERIES FILTER
ISDE2423 REV C
STARTING...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 6
.... The manual air relief valve must be installed and serviced only by lifting over the upper filter body. Using 3/4" wrenches, loosen and remove the clamp nut and the clamp bolt. (Fig 5) 6. Do not to add fresh D.E. (D) POOL OR SPA BOOST - Do not use for normal filtering. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Also use for regular Vacuuming...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 7
... not have been removed with Jack's Formula 327 Multilube. 2. Replace filter element cluster into filter tank, carefully fitting top collector manifold outlet over outlet elbow O-ring. You may find some debris on the filter element cluster, which may now be cleaned by washing inside and outside with the
Hayward cleaning wand (EC2024).
Notice: •Do not use...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 8
...installed and serviced only by a qualified professional.
Place the metal reinforced seal on the filter bodies with rounded end of the nut (Fig 8) towards the ends of 12
Pro... HAYWARD GENUINE REPLACEMENT PARTS SERIES FILTER
ISDE2423 REV C
WARNING
This product should be performed directly into the filter whenever needed. Replace the filter clamp around the upper and lower filter bodies...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 9
... with a Manual Air Relief Valve (MAR) pre-installed from damage. 1. Then REMOVING CARTRIDGES per the instructions on the upper filter body. 6.
Check the o-ring seals, replace as required). Be sure flow rate through filter is aligned with the "LOCK" position on the pad.
2. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Turn the MAR clockwise until all electric...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 11
.... Filters which become defective during the warranty period, except as a result of freezing, negligence, improper installation, use or care, shall be made directly to the nearest authorized Hayward service center.
For such products, the warranty established by others. Hayward Pool Products 620 Division Street Elizabeth, NJ 07207
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Hayward...
Models: DE2420 DE3620 DE4820 DE6020 DE7220 - Page 12
... Product Serial No
□ New Installation
□ Replacement
Purchased Date Purchased from Company name Address City State_________ Zip
Please send me more information on these other products from Hayward:
Type of Pool:
□ Vinyl □ Fiberglass □ Gunite □ Above-ground
□ Pump □ Filter □ Automatic Pool Cleaner □ Light □ Chlorinator...
DEX2420MAR2 Manual Air Relief Valve - Page 1
... position. · Before starting system pump fully open position. Close filter drain. 4. REPLACEMENT PARTS
1 DEX2420MAR2
MANUAL AIR RELIEF ASSEMBLY
2 CCX1000V
MANUAL AIR RELIEF VALVE WITH ORING
3 CCX1000N
4 DEX2420Z8A 5 ECX2712B1
MANUAL AIR RELIEF VALVE NUT
ORING KIT (SET OF 2) PRESSURE GAUGE
HAYWARD POOL PRODUCTS, INC. 620 Division St., Elizabeth, NJ 07207 TEL: 908...
Model C9002SEP - Page 1
...HAYWARD PRO GRID D.E. Open the by -pass valve (if equipped).
Rinse off top cover to gain access to insure a reliable sealing surface. Place cover on the
collector hub in clockwise direction (hand tight only). 8.
Close the air relief valve after each filter... the pump. TYPICAL INSTALLATION
RETURN TO POOL OR
WASTE LINE
To Pool Backwash the filter for approximately 2 minutes...
Model C9002SEP - Page 2
NO. Working
Pressure
PSI
BAR
50
3.45
Pro-Grid D.E.
DESCRIPTION
1 CX900G Locking Knob
2 CX900H O-Ring
3 CX900W Washer
4 CX900J E-Ring
5...
(Air Relief Valve)
Rev. 11/00 A
© 2000 Hayward Printed in U.S.A. SEPARATION TANK
Max. Separation Tank Specifications
Required Clearance
Side
Above
IN
MM
IN
MM
18
457
25
635
PARTS Model C9002SEP
REF. HAYWARD PRO GRID D.E.
Similar Questions
Collector Manifold Hayward Swimclear How To Replace
(Posted by fonecjhart 9 years ago)
How To Replace Manual Air Relief Valve On Hayward Pro Grid 2420 Filter
(Posted by siyo 10 years ago)
Video How To Replace A Manifold In A Hayward Pool Filter
(Posted by Pedifluk 10 years ago)
Pro-grid Filter Leaking At Base Of Manual Air Relief Valve
The filter is leaking at the top, at the base of the manual air relief valve. What would cause this,...
The filter is leaking at the top, at the base of the manual air relief valve. What would cause this,...
(Posted by lwallas 11 years ago)