Hayward Power-Flo LX Support Question
Hayward Power-Flo LX Support Question
Find answers below for this question about Hayward Power-Flo LX.Need a Hayward Power-Flo LX manual? We have 3 online manuals for this item!
Question posted by Anonymous-62194 on June 10th, 2012
Does This Pump Have A Starter Capacitor
The person who posted this question about this Hayward product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hayward Power-Flo LX Manual Pages
Models: SP1575LXTL SP1580TL and SP1580X15TL - Page 1
... To reduce risk of the motor. 4. A permanently installed pool is equipped with hot tubs and spas if so marked. NOTE: If your pump is constructed in injury. To reduce the risk of Electric ...that wire size is protected by applicable electrical codes. Connect only to minimize abuse from power source. Contact a qualified electrician if you own an above -ground and on suction lift...
Models: SP1575LXTL SP1580TL and SP1580X15TL - Page 2
...-W
SPX1500-RA
SPX1500-RA
SPX1500-RA
SPX1500-LX
SPX1500-LX
SPX1500-LX
SPX1500-P
SPX1500-P
SPX1500-P
SPX1500-D-2
SPX1500-D-2
...SPX1500-D-2
SPX1700-FG
SPX1700-FG
SPX1700-FG
SPX1500-X1
SPX1500-X1
SPX1500-X1
SPX1550-WA-1
SPX1550-WA-1
SPX1550-WA-1 Head Housing Cover Housing O-Ring Impeller Seal Assembly Pump...
Models: SP1575LXTL SP1580TL and SP1580X15TL - Page 3
... cover to fill strainer with O-ring, into recess of pump housing-O-ring end first. AMPS RATINGS - To remove impeller, insert screwdriver in handling and installing the new seal and ceramic seat assembly. RECOMMENDED WIRE SIZE 0-50' #14
#12
#12 SEAL CHANGE INSTRUCTIONS
Power Flo™ LX Series with a dilute solution of non-granulated liquid...
Models: SP1575LXTL SP1580TL and SP1580X15TL - Page 4
... level is filled with Automatic Thermal Overload Protection. See instructions.
Shut off suction as necessary.
2. Store pump and motor in pump housing. 5. Make sure pump/strainer housing is reached. Tighten all electric power.
undersized pool piping. 2. Plugged or restricted impeller. Air leak in suction causing rumbling in U.S.A. MAINTENANCE
1. Disconnect cord...
SP1575X15 - Page 1
... give you own an above-ground pool, please see TROUBLE SHOOTING GUIDE on power and allow a reasonable time for priming.
Keep motor clean. Drain thoroughly and clean out any debris. GENERAL TIPS ON PUMP INSTALLATION
STARTING AND PRIMING INSTRUCTIONS
For best pump performance, locate the system below the pool water line and as close to...
SP1575X15 - Page 2
REF. Head Housing Cover Housing Gasket Impeller Seal Assembly Pump Housing Nut, No. 10-24 Hex. DESCRIPTION
Bolt, No. 10-24 Hex. NO.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ---- REQ'D.
7 1 1 1 1 1 7 1 1 1 1 1 1 2 1
PART NUMBER ...SPX1700FG SPX1500XE Motor Strainer Housing O-Ring Basket Strainer Cover O-Ring Strainer Cover Drain Plug w/Gasket Strainer Shim Ring (Horizontal Outlet Pumps Only)
NO.
SP1575X15 - Page 3
...of non-granulated liquid-type soap. Tighten bolts and nuts alternately and evenly.
12. Reconnect pump to pump housing with ceramic seat inside, into clear plastic seat retainer-polished surface facing out. To... polished face of the spring seal and pull it off electrical power before restarting.
*For A.O. Remove pump and motor assembly from the impeller.
8. The spring portion of...
SP1575X15 - Page 4
... written authorization of obstruction.
LOW FLOW-Generally, check for free movement and lack of Hayward Pool Products, Inc. Pump operating underspeed (low voltage). 5. Cavitation due to motor occurs. No pumps or motors may be returned directly to make sure pump is locked firmly in open switches or relays, tripped circuit breakers or blown fuses. 2.
Owners Manual - Page 1
... property damage and if ignored presents a potential hazard.
ISPFSERIES Rev G
PowerFlo LX™ / PowerFlo II™ / EP Pump Series
Owner's Manual
Contents
Product Warnings 2 Installation 4 Start-Up & ...injury. CAUTION warns about hazards that are important but not related to hazards.
Hayward Pool Products 620 Division Street, Elizabeth, NJ 07207
Phone: (908) 355-7995 www....
Owners Manual - Page 2
... decorations, finger, toe or knuckle to be installed a minimum of access to
prevent their being used in winterization of the pool/spa
from using them as means of two functioning suction outlets per pump installed in accordance with latest ASME, APSP Standards and CPSC
guidelines, follow all times. WARNING -
A limb inserted into an...
Owners Manual - Page 3
...- This pump is protected
by a GFCI. A permanently-installed pool is flowing, indicating the possibility of swimming pool, spa, or hot tub. Failure to pump housing with permanently-installed pools and may...burn, and cause death or serious property damage.
Do NOT ground to electrical power supply. Also, contact a licensed electrician for information on
electrical connections. Notes...
Owners Manual - Page 4
..., start all piping at the end of air for outdoor use, it may cause cracking of tape.
Installation Instructions
Pump Location
The PowerFlo LX™ and EP series pumps MUST be installed below the pool water line (see Figure to meet all local and national codes.
do NOT over-tighten fitting or you face the...
Owners Manual - Page 5
...pool, spa, or hot tub. Reset if necessary. Do NOT ground to reinforcing rod or mesh. WARNING - Use a solid copper conductor, size or larger. Run wire from the power source. Wiring
Pump... motor according to motor nameplate voltage. Connect motor ground terminal to electrical power supply. In case of swimming pool, spa, or hot tub, and to local codes and regulations. For better efficiency...
Owners Manual - Page 6
...during storage. Storing Pump for the mechanical shaft seal. To avoid dangerous or fatal electrical shock hazard, turn OFF power to anyone nearby. NEVER operate the pump without water. ... high volume blower when air purging the pump, filter, or piping. Store pump in your pool/spa system.
Running pump dry may damage pump and voids warranty. If pump does NOT prime within ten minutes, stop...
Owners Manual - Page 7
...Winterized Equipment
1. Insert basket and fasten strainer cover. 16. Start-Up for swimming pool pump installation. Inspect all intake and output fittings and piping. 5. C. If assembly ...or the shaft cover plate from the motor/pump assembly.
2. Open all electrical power service to proper water level. 6.
Securely mount pump to use this product. Do not use ...
Owners Manual - Page 8
... voltage to automatically restart once the motor has cooled, provided the power source is equipped with skimmer full and pump running. clean or replace cartridge. 3. Manually check rotation of motor...rotating at motor or power drop (frequently caused by removing the skimmer basket and holding your pool dealer can build up causing windings to determine if pump will develop a vacuum....
Owners Manual - Page 9
... or leak at once. 6.
Air leak in suction piping causing rumbling in pump housing. See "Shaft Seal Change Instructions" in
this point or putting in pool, and
unrestricted discharge return lines. DATE OF INSTALLATION
INITIAL PRESSURE GAUGE READING (CLEAN FILTER
PUMP MODEL HORSEPOWER
FILTER MODEL
SERIAL NUMBER
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
Owners Manual - Page 10
...
SPX1500Y2 (7 Req'd.)
SPX1500Y2 (8 Req'd.)
Motor (for SP1580X15) - 1-1/2 HP
----
SPX1510Z1XE
Motor (for SP1540C) - 40 GPM
SPX1540Z1E
---- SPX1510Z2E)
*All Twist Lock versions for each pump have "TL" at end of model number to Part No.
SW1585X20, SW1585X25,
No. on Original Equipment
SPX1705AA SPX1500Y2 (6 Req'd.)
---SPX1500Z1E SPX1510Z1E* SPX1510Z1XE*
------------SPX1500CAP...
Owners Manual - Page 11
...freezing, negligence, improper installation, improper use or care or any Acts of Hayward Pool Products with respect to state.
*Supersedes all other such costs incurred in materials and... purpose. This warranty gives you specific legal rights, and you .
HAYWARD® Pool Products Limited Warranty
To original purchasers of purchase or the nearest Hayward Authorized Service Center...
Owners Manual - Page 12
... number that have individual serial numbers, it is a registered trademark, and PowerFlo LX, and PowerFlo II are trademarks of purchase/installation or register online. PowerFlo LX™ / PowerFlo II™ / EP Pump Series Warranty Card Registration
Register online at www.hayward.com
Please Print Clearly:
Years Pool has been in service
First Name Last Name 1 year 1-3 4-5 6-10 11...
Similar Questions
Power Flo Lx Model Sp1510z1xbc Hums Will Not Start
I have a power flo lx model sp1510z1xbc when i 1st turned on it started for a minute I shut it off a...
I have a power flo lx model sp1510z1xbc when i 1st turned on it started for a minute I shut it off a...
(Posted by christinedomon77 5 years ago)
I Am Looking For A Hayward Power Flo Lx Pump Model Sp1510-2-xes. Can You Help?
(Posted by gregjaws 8 years ago)
Why Is My Hayward Super Pump Starter Capacitor Smokes
(Posted by lynxkitt 9 years ago)
Hayward Pool Pumps Power Flo Lx Power Switch Won't Shut Off
(Posted by JLCASdm86 10 years ago)
How To Prime Hayward Power Flo Lx Above Ground Pool Pump
(Posted by meriosdeluc 10 years ago)