Harman Kardon ONYX STUDIO 5 Support Question
Find answers below for this question about Harman Kardon ONYX STUDIO 5.Need a Harman Kardon ONYX STUDIO 5 manual? We have 3 online manuals for this item!
Question posted by Cpsenour on July 7th, 2021
Red Light Blinking
Current Answers
Answer #1: Posted by SonuKumar on July 7th, 2021 10:19 PM
The red blinking in general is an indication of "protect" mode. This is a case where a problem has been detected and the unit shuts down to prevent further damage to either the receiver or the speakers.
try reset please
How do I reset my Harman Kardon Onyx?
Hard Reset HARMAN KARDON Onyx Studio 5
To start whole operation HARMAN KARDON speaker must be turned on, if not press Power Button once.
Then, click simulteaneusly Bluetooth Button and Volume Up Key.
Hold it for few seconds.
Speaker will be power off and you will need to press Power Button once again.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Harman Kardon ONYX STUDIO 5 Manual Pages
Similar Questions
It won't stay on. The red light comes on when plugged in and shuts off after less than a minute. Fai...
I'm unable to connect two onyx 3 wireless speakers to play at same time
Is there a light that flashes indecating charging?
i used my harman kardon onyx studio yesterday at a barbeque party. Before we went home it was still ...