Get support for Harbor Freight Tools 63022 - 2 HP Gasoline Auger Powerhead

Harbor Freight Tools 63022 Support Question

Harbor Freight Tools 63022 Support Question

Find answers below for this question about Harbor Freight Tools 63022 - 2 HP Gasoline Auger Powerhead.
Need a Harbor Freight Tools 63022 manual? We have 1 online manual for this item!
Question posted by dgduren on May 10th, 2020

Looking For Throttle Cable

I am searching for throttle cable part number for predator item 63022 - 2 HP Gasoline Auger Powerhead.

Current Answers

Answer #1: Posted by techyagent on May 19th, 2020 9:17 PM
This answer was accepted by the poster of the original question.
techyagent

Member since:
June 17th, 2014

Points: 4,799,790
1,060
points
You cannot buy the whole throttle cable. You need to buy the whole pull cable assembly.

Please buy from the link below:-

https://www.amazon.com/Starter-Recoil-Harbor-Freight-Predator/dp/B07MGPTT6P



Thanks


Techygirl

Related Harbor Freight Tools 63022 Manual Pages

User Manual - Page 1

... All rights reserved. Tools required for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the back of... Email our technical support at: [email protected] Email our engine support at: predator@harborfreight.com When unpacking, make sure that the product is a poison you cannot...
User Manual - Page 2

... call 1-888-866-5797. ITEM 63022 Table of Contents Specifications 2 Safety 3 Setup 7 Operationr 9 Maintenances 12 Troubleshooting 16 Warranties 18 Parts Lists and Diagrams 20 Specifications Maximum Bit Size Drive Shaft Accessories Displacement Engine Type Cooling System Fuel Type Capacity Type Oil Ratio Run Time @ 50% Load with gasoline) 25:1 gasoline-to the last pages...
User Manual - Page 3

... ITEM 63022 ...Auger may occur. Page 3 Maintenance Obey all instructions. Setup Operation Symbol Definitions Symbol Property or Statement RPM Revolutions Per Minute HP... Horsepower WARNING marking concerning Risk of Fire. WARNING marking concerning Risk of Eye Injury. Do not refuel while operating. Read all safety messages that can start fires around dry vegetation. Gasoline...
User Manual - Page 4

...Do not operate if gasoline has been spilled. Do not leave the Auger unattended when it from the Auger during use . 26... from rotating Bit: Stand on . ITEM 63022 Buried utility lines may get pulled into...this Auger. Fully squeeze the Throttle to prevent it is necessary when...tool. 8. Use only accessories that may be suitable for one Auger may become hazardous when used on the Auger...
User Manual - Page 5

... the tool as possible. 2. Parts, especially exhaust system components, get very hot during operation. 35. Keep the Auger, Engine, and surrounding area clean at all times. 36. Use the Auger, accessories, etc., in accordance with only one hand can be performed. Page 5 Stay clear of the Auger for the application. Operation Maintenance ITEM 63022 For technical...
User Manual - Page 6

... dust mask/respirator during service. 5. Have the Auger serviced by the manufacturer or distributor. b. Do ...Auger. Store Auger out of the reach of ignition around the Auger, especially when refuelling. 3. Follow scheduled engine and Auger...the engine while the smell of the Auger is maintained. SAVE THESE INSTRUCTIONS. ...or any part of the Auger or its "OFF" position. Keep...
User Manual - Page 7

... U.S. IMPORTANT! You operate the Auger without the proper 25:1 fuel/oil mix in its Fuel Tank. Running the Engine without treating the gasoline with fuel stabilizer will need to be required. The operator should contact local fire agencies for standards set up or use . Setup Operation Maintenance ITEM 63022 For technical questions, please call...
User Manual - Page 8

Safety Components and Controls Starter Handle Handle Power Switch Fuel Tank Throttle Choke Bit Setup Operation Maintenance Page 8 For technical questions, please call 1-888-866-5797. ITEM 63022
User Manual - Page 9

... or a dirty fuel container. Do not run the Engine with an improper mixture WILL permanently damage the Engine. 1 GALLON UNLEADED GASOLINE 5 FLUID OUNCES 2-CYCLE OIL APPROVED CONTAINER Figure A: Fuel-Oil Mixture 4. ITEM 63022 For technical questions, please call 1-888-866-5797. Do not smoke. 1. Note: Do not use E85 ethanol. It can cause...
User Manual - Page 10

.... Squeeze and release the Throttle. 5. Keep all bystanders ...Figure C 4. Move the Power Switch to prepare the Auger. ITEM 63022 Read the section that is felt. RUN if the Engine...gasoline and 2-cycle oil mixture. Inspect the Auger and engine. WARNING! Press the Primer three or four times. c. Place the Auger on its Bit resting on the ground that follows. 1. Allow Cable...
User Manual - Page 11

... from being damaged by overheating. 15. Clean, then store the tool in the drilled hole, the Auger will screw into the earth, become stuck, and twist violently. ... using the Auger and contact a qualified service technician to dissipate the heat. Accelerate the Engine to full throttle just before starting to loosen bit. Setup Operation Maintenance ITEM 63022 For technical questions...
User Manual - Page 12

... as duty cycle, temperature, air quality, fuel quality, and other factors. or Every 6 mo. ITEM 63022 The engine may fail critically if not serviced properly. of use Yearly or every 300 hr. The maintenance needs of each Auger will need to be serviced by a qualified technician for the engine to cool, and disconnect...
User Manual - Page 13

...! Unscrew and remove the Fuel Cap. 3. Before each use , clean the exterior of the Auger. Operation Maintenance ITEM 63022 For technical questions, please call 1-888-866-5797. It can cause personal injury. Running the Engine with an improper unleaded gasoline/2‑cycle oil mixture. Then replace the Strainer. Cleaning: • Wash the filter in...
User Manual - Page 14

... hour before use to allow all residual fuel vapors to be replaced. Setup Operation Maintenance Page 14 For technical questions, please call 1-888-866-5797. ITEM 63022 Disconnect spark plug wire from the tank and flush them from end of plug. Install the new spark plug or the cleaned spark plug into...
User Manual - Page 15

...Safety Long-Term Storage When the Auger is VOID. 5. Stop after storage, keep in a well-ventilated area away from ignition sources. WARNING! Setup Operation Maintenance ITEM 63022 For technical questions, please call... than 20 days, prepare the Engine for Engine to cool, then clean Engine with gasoline Follow Refer to Checking and Filling Fuel on page 13. NOTICE: Do not clean using...
User Manual - Page 16

...plug. Discontinue using Auger until the tool is repaired by a qualified service technician. Safety Setup Troubleshooting Problem Engine will not start Auger rotates while Engine... precautions whenever diagnosing or servicing the Auger or engine. Do not use gasoline with more than 10% ethanol (E15, E20, E85, etc.). 4. ITEM 63022 Dirty fuel passageways. 7. COMPRESSION RELATED...
User Manual - Page 17

... filter 2. Impure or low quality gasoline/oil mixture. 2. Have a qualified service technician adjust Throttle cable. 3. Do not use gasoline with more than 10% ethanol (E15, E20, E85, etc.). 5. Test/replace fuel tank cap. 3. Have qualified technician check and replace broken shaft key or other shear pins. Operation Maintenance ITEM 63022 For technical questions, please call 1-888...
User Manual - Page 18

.... Setup Operation Maintenance Page 18 For technical questions, please call 1-888-866-5797. ITEM 63022 Your emissions control system may elect to the original purchaser that the defect resulted from ...the cost of purchase. Safety Warranties Limited 90 Day Warranty (Retail) Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability...
User Manual - Page 22

ITEM 63022 Safety Auger Parts List Part Description 1A ...1 1 1 1 1 1 4 Part Description 18A Oil Seal 19A Bearing 20A Transmission Shaft 21A Screw 22A Handle 23A Rubber Holder 24A Aluminum Bracket 25A Screw 26A Pin 27A 6" Auger Bit 28A Safety Pin 29A Hex Wrenches 30A Open End Wrench 31A Spark Plug Socket 32A Standard Screwdriver 33A Oil Mixing Container Qty. 1 1 1 4 1 2 1 6 1...
User Manual - Page 23

Page 23 Safety Setup Auger Diagram 25a 24a 23a 22a 21a 11a 12a 13a 14a 16a 17a 18a 19a 20a 15a 8a 9a 10a 1a 2a 3a 4a 5a 28a 6a 7a 26a 27a 33a 29a 30a 31a 32a Operation Maintenance ITEM 63022 For technical questions, please call 1-888-866-5797.

Similar Questions

Predator Gasoline Auger Throttle Cable
Where can we find a replacement Predator Gasoline Auger Throttle cable?
(Posted by kaufmangary 1 year ago)
I Need The Throttle Cable Number For The Predator 63022 Earth Digger Harbor Frie
Need the throttle cable number to the Predator 63022 earth post whole digger sold by Harbor Friegh
(Posted by Gamest89 3 years ago)
Looking For Throttle Cable For Predator Auger Model # 63022
Could you please send me a part # for a throttle cable on a predator 63022 Auger.
(Posted by MidwestSmallEngine 3 years ago)
Ask a New Question
Use the box below to post a new question about this Harbor Freight Tools product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Harbor Freight Tools Manuals

Find free Harbor Freight Tools 63022 - 2 HP Gasoline Auger Powerhead manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Harbor Freight Tools Reviews

View thousands of Harbor Freight Tools user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Harbor Freight Tools customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Harbor Freight Tools customer service rankings, employee comments and much more from our sister site.

Harbor Freight Tools Recalls

Find comprehensive Harbor Freight Tools recall information updated hourly on RecallOwl.com.