Haier XQJ50-31B Support Question
Haier XQJ50-31B Support Question
Find answers below for this question about Haier XQJ50-31B.Need a Haier XQJ50-31B manual? We have 1 online manual for this item!
Question posted by karenjebril on October 28th, 2012
My Washer Was Stopped Up ,i Took It Apart And Need More Information To Put It Ba
The person who posted this question about this Haier product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Haier XQJ50-31B Manual Pages
User Manual - Page 1
i-sbe-k
Clothes Washer
El
User Manual-
Special No: 0030503068
Model XQJ50-3114 frequency
230 -240V -50Hz
Rated washing/spinning capacity 5.0 kg (weight of standard dry cloth)
Water level/Water quantity (about) Large/501Medium/44L Small/351
...
User Manual - Page 2
...or softeners recommended for use in the presence of fire, electric shock, or injury to a
complete stop before using your appliance by providing an escape wire for its intended purpose as to the wash....not use of the plug can result in a risk of this appliance for a prolonged period, clean washer before using it is used to remove clothes while the tub is spinning. 16. Do not operate...
User Manual - Page 4
...-sets should use pliers to see if any leaks. Install the drain hose to their respective washer inlet located at least 35 inches minimum and 47 inches maximum. If you need to hold hose in the Washer to the hot and cold water faucet.
3. If there is properly installed, contact a qualified installer. Note...
User Manual - Page 5
...thread shaft of the castor to block the noise and give you quiet performance of the washer during the operation. Repeat the same for each corner. Inner Tub
4. Get a ... one by one anti. Once all 4 leveling legs are installed and the panel is set properly, return the washer to install the castors properly:
1. Front Leveling Legs
(not shown)
6
7. You will release the lock. ...
User Manual - Page 6
... corrected with the leveling legs located on the bottom corners of packing, tape or printed materials before using the washer. 2
O
O
O 9
O
4
O
O
3
0
1. After properly placing your washer in its final position, you can level your washer. Slide out and remove bottom styrofoam that is at room temperature. high
low
Steps for Installation
Installation Pre-Requirement...
User Manual - Page 7
... panel 2. Drain hose clamp 6. D •_,5 '
vt.., ut • - 1
tsa.k
...,. English
INSTALLATION INSTRUCTIONS
Tools and Materials Required
You will need to have the following tools to help you in the installation of your Washer: • Scissors • Phillips Screwdriver • Standard Screwdriver • Pliers • Wrench • Tape Measure • Gloves • Level...
User Manual - Page 8
...at
the proper time during the rinse cycle.
(fabric softener
Steps to not leveling the washer properly on your clothes: this is due to delay the start of the cycle. (...Dispenser
It is making noise: • Washer may need to be reinstalled. (Check washer installation section) • Washer load may need to sharp objects such as the load may need to 24 hours. Check water temperature....
User Manual - Page 9
... softener into dispenser.
7
Washer is making noise: • Washer may need to be reinstalled. (Check washer installation section) • Washer load may need to not leveling the washer properly on the floor and...being filled with clothes: • Clothes are using the softener. • Clothes may need to avoid soap residue on clothes. • Spots or stains on your convenience, there...
User Manual - Page 10
... the tub being overloaded. Close the washer door properly to increase the incoming water flow. The washer door is very slow. This code is displayed when the machine stops running during the
delay start mode.
This will
prevent residue from building up on the container.
It may need to drain. Note: Use only liquid...
User Manual - Page 11
... is normal in . You must also clean this button to close the door properly. • The washer pauses in some cycles. You may have to start automatically. • Check if the option selections are.... • Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • Check if the washer is overloaded: load may need to be re-balanced and clothes
may have...
User Manual - Page 12
...the machine will see Wash -o-Rinse -D. With normal wash speed, the agitator moves faster. If moving washer, disconnect drain hose. • Turn the leveling legs clockwise all hoses. If you want to another....lf you do not want to select your convenience, you just got delivery of Your Washer • This appliance must be approximately 25 minutes in an area where room temperature is...
User Manual - Page 13
...ammonia, chlorine bleach, concentrated detergent, solvents or metal scouring pads. DO NOT USE YOUR WASHER WITHOUT THE LINT FILTER IN PLACE. • The Detergent Dispenser Compartment and fabric softener ...your delicate items from clothes to prevent scratching interior parts. • Lint filter needs to be cleaned before cleaning.
Some of these chemicals may dissolve, damage and/or...
User Manual - Page 14
... into the wash tub. At the same time, the heavily soiled laundries should be on at this position. Close the washer door properly. 7.
The spin time varies for each cycle. Turn ...water allowing clothes to step # 5. C. Note: We suggest that the large heavily soiled laundries should be some restrictions when choosing selected options.
4. The cycle is completed when the agitator ...
User Manual - Page 15
...AWING
I:I I:l
TYNER ON
4 Z:b On* VW
• To choose the number of the water will stop. • The tub will stop . If you open .
• If the unit is lit up at the end of Cycle Signal...For your options and closing the washer door properly, you need to press the "Start/Pause" button to start of the
"Temp Select" button is in the wash mode it will stop the activity during the wash ...
Similar Questions
No Spin Haier Hltw600axw
It works and less than a year old and less than 50 times used. It will not spin. Everything else wor...
It works and less than a year old and less than 50 times used. It will not spin. Everything else wor...
(Posted by Magicman1999j 6 years ago)
Washer And Hose Needed For My Machine
just bought the haier hlp28E-R washer and I'm trying to wash clothes but the water is not going insi...
just bought the haier hlp28E-R washer and I'm trying to wash clothes but the water is not going insi...
(Posted by dellmullins 8 years ago)
Haier Hwm150 0623s Stop In Washing Cycle
it start washing ok,after few minutes it stop then it star again and again stop
it start washing ok,after few minutes it stop then it star again and again stop
(Posted by rafaeltorres003 9 years ago)
Haier Hms1000tve W/m Cycle Does Not Complete And Stops At 0:01 Minute.
After a time the door can be opened but it is not easy to set a new wash cycle. 0:01 keeps being dis...
After a time the door can be opened but it is not easy to set a new wash cycle. 0:01 keeps being dis...
(Posted by marionjalley 9 years ago)
Need Replacement Parts For Summit Spw1200p Washer
Where can I find online replacement parts for Summit SPW1200P Washer, specifically the Agitator?
Where can I find online replacement parts for Summit SPW1200P Washer, specifically the Agitator?
(Posted by dimsky59 12 years ago)