Haier RDE350AW Support Question
Haier RDE350AW Support Question
Find answers below for this question about Haier RDE350AW - 6.5 Cu. Ft. Electric Dryer.Need a Haier RDE350AW manual? We have 1 online manual for this item!
Question posted by michaeldwilder2002 on May 18th, 2011
Barrel Falls Off The Rear Center Point.
Haier - RDE350AW, The drier barrel seperates from the center point in the rear and falls. I'm having trouble finding a parts breakdown for this unit so I dont know the proper terms for the parts.
Current Answers
Related Haier RDE350AW Manual Pages
User Manual - Page 2
... 7 Gas Supply Requirements 9 Location of Your Dryer 10 Manufactured (Mobile) Home Instruction 11 Electrical Installation 12 3-Wire Cord Connections 13 4-Wire Cord Connections 14 Gas Connections 15 Replacement Parts 17 OPERATING INSTRUCTIONS 18-24 Understanding the Control Panel 18 Preparations before Drying 19 Load clothes into Dryer 20 Auto Dry Cycle 21 Timed Dry...
User Manual - Page 3
... will simplify the installation and ensure the dryer is being installed.
2
Installations must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223.1 or in
your safety the information in Canada, CSA C22.1 Canadian Electrical Code Part 1. English
IMPORTANT SAFETY INSTRUCTIONS
Before beginning installation, carefully...
User Manual - Page 4
... play on the rear of fire, electric shock, or injury... to persons when using this appliance where it will be cleaned periodically by qualified service personnel.
3 To reduce the risk of the dryer.
14. Clean lint screen before using your appliance, follow the basic precautions, including the following:
1. Keep the dryer... or replace any part of the fabric ...
User Manual - Page 5
This dryer must be properly installed in the dryer until all terraces of purchase
Staple your receipt to catch fire.
16. Check with cooking oil may not get trapped inside. Use the dryer only for using our Haier product. Always disconnect dryer from electrical supply before attempting any flammable liquids or solids, it should not used with the...
User Manual - Page 6
... by the appliance manufacturer as suitable for washers and dryers, and DO NOT operate a washer and dryer on the same circuit. Use seperately fused circuits for use with 3 open -end wrench...and local
codes. 3.Do not install a clothes dryer with 30 Amp time-delay fuses or circuit breakers.
ELECTRICAL REQUIREMENTS
Electric Dryer: (RDE350AW)
Circuit Individual 30 Amp branch circuit fused with...
User Manual - Page 7
... NEMA 14-30R receptacle)
ELECTRICAL REQUIREMENTS Gas Dryer: (RDG350AW)
Circuit Individual 15 Amp branch circuit fused with clothes dryers.
See Electrical Connections for use with clothes dryers. (When sold in Canada... protection against shock hazard and should be plugged into a properly grounded three-prong receptacle. Note: This dryer is in a manufactured (mobile) home MUST employ a ...
User Manual - Page 8
Restricted air flow will be exhausted into the laundry area. An accumulation of lint in any concealed space of a building. ...or other flammables are specific requirements for proper and safe operation of air.
6. Lint can result in contact with exhaust system. Use an approved vent hood to installing dryer duct.
2. Plugging the system could create a fi...
User Manual - Page 9
...to removal of every 12 months with the UL Outline for proper operation. Running the exhaust system through a roof may cause ...ft. 45 ft. 35 ft. 25 ft. The vent flap should be used .
2. In the United States, the required exhaust duct diameter;
7. The total length of 90º elbows 0 1 2 3
Rigid Metal
90 ft. 60 ft. 45 ft. 35 ft.
English
maintain a minimum of the dryer...
User Manual - Page 10
... plugged tapping, accessible for test gauge connection, MUST be installed in excess of the dryer in accordance with the National Fuel Gas Code, ANSI Z223.1 (latest edition) or in Canada, the current... less than 1/2 psig (3.45 kPa).
9 The tubing MUST be used to connect your dryer to the dryer. 6. Stainless steel or plastic-coated brass MUST be constructed of local codes, installation must ...
User Manual - Page 11
...bottom of ventilation in contact with a solid door. 2. DO NOT install your dryer in a closet with curtains, thick carpet, or anything
that will come in the door is acceptable.
10 ...When installing the dryer in the same closet as the gas dryer. 4. Openings must be equally divided at the top and bottom of the door and...
User Manual - Page 12
... a manufactured home, a provision must be not less than twice the area of the dryer exhaust outlet.
4. Metal ducting must conform to current Manufactured Home Construction & Safety
Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is to the mobile home structure.
3. Installation must be 4 inch (10...
User Manual - Page 13
...-grounding terminal or lead on 240 Volt power supply.
ELECTRIC Dryer (RDE350AW) GROUNDING INSTRUCTIONS
This appliance must be pulled out of electrical shock.
Gas dryers are equipped with the circuit conductors and connected to be plugged into a properly grounded three-prong receptacle. This appliance is not properly grounded. The plug must be purchased, allowing some slack...
User Manual - Page 14
... power cord neutral (center wire) conductor to
These...center terminal on the back of the dryer's upper corner.
2. Tighten the screws securing the cord restraint firmly against the power cord.
8. Power cord, NEMA 10-30 Type SRDT, through the strain relief.
4. Warning: Do not make a sharp bend or crimp wiring/conductor at this time.
3. English
ELECTRICAL CONNECTIONS
ELECTRIC Dryer (RDE350AW...
User Manual - Page 15
... wire from the green ground screw located above the terminal block. Install a UL approved strain relief into the power cord entry hole of the dryer upper corner.
2. English
ELECTRIC Dryer (RDE350AW)
4-Wire Cord Connections (US Models Only)
Green Ground Screw
Green Power Cord Ground Wire
Brass Terminal Terminal Block
Neutral Ground Wire
Black
Tighten...
User Manual - Page 16
...;ammable vapors. Warning: Do not make sure the dryer area is necessary for proper operation. Use a 1/2 inch to 3/8 inch (1.27cm...dryer through a cycle check for the gas line to the brass-colored center terminal on , the safety switch will light, it is clean and free from the dryer...3/8 inch (0.96cm) pipe located on the rear of the dryer. Apply an approved thread sealer that nothing (...
User Manual - Page 17
... inlet. IMPORTANT: To prevent the inlet from twisting, please use a pipe wrench to gas inlet on dryer. Affix Teflon® tape or pipe compound to dryer gas line shutoff valve. English
C) Make sure flexible gas line seal is secure. Use two wrenches for the best possible connection. D) To check gas inlet ...
User Manual - Page 18
...the dryer is unpacked. Check unit for US and Canada can cause improper and dangerous operation.
Children should not be applied when installing, operating, and maintaining any appliance. WARNING
Discard or destroy the carton and plastic bags after installing, call a certified electrician to children. English
REPLACEMENT PARTS
Replacement parts and accessories for proper operation...
User Manual - Page 19
... the risk of fire, electric shock, or injury to set drying temperatures. Temp Button: (1)
•Used to persons, read all of the dry cycle the dryer will tumble periodically for 1 hour after...At the end of the IMPORTANT SAFETY INSTRUCTIONS before using this appliance. Here the dryer tub will automatically go in . There are four available drying temperatures to start after...
User Manual - Page 20
...QSPOFUP
losing lint and those prone to adhering lint shall be connected to gas or tap water pipelines. Note: Applies to the dryer. Clothes prone to falling lint should have their zippers zipped up, buttons and hooks done up and belts tied so as to avoid entanglement and ensure easy removal...
User Manual - Page 27
...center. For the name and telephone number of the problem. Before calling please have other rights, which vary, from incorrect electrical...unit from the original retail purchase date Haier shall provide a part at no cost, as indicated below, to a defect in materials or workman ship, Haier...Warranty Service Contact your appliance( found on the rear of the owner.
Replacement or repair of ...
Similar Questions
Heating Element On Haier Dryer 2.6 Cu.ft
My dryer does not blow warm enough. When I put it at the higher setting it does not blow any hotterD...
My dryer does not blow warm enough. When I put it at the higher setting it does not blow any hotterD...
(Posted by mkgil 3 years ago)
How Do I Change The Belt
(Posted by wwwdgarrett1575 9 years ago)
How To Reset The Haier Portable 2.6 Cu Ft Dryer
(Posted by lafuz 9 years ago)
Haier Dryer Parts Control Rde350aw Images How To Install Up The Outlet Plug To
the dryer
the dryer
(Posted by rajessh 10 years ago)
Where Can I Buy Parts. I Need A Relay Switch.
Relay switch I believe is problem. It just clicks.
Relay switch I believe is problem. It just clicks.
(Posted by Lesaward2962 10 years ago)