Not Working Filling With Water Fast

I know how to fix this problem, I fixed mine. The design of this unit is flawed in two ways, and you should fix both. Start by removing the back panel - just remove all the phillips head screws (you have to take out the screen filter as some of the screw heads are otherwise hidden). You will see that there is a "drain" system" (little notch cutout above the small water catcher with a tiny drainhole at the bottom) CAREFULLY drill a quarter inch hole about a quarter to half inch below the notch - drill just through the plastic, not into the fins behind. This will allow the water to properly drain. Secondly, on the lower right is the "air intake condenser" - I dont know why but they didnt put a filter on this so mine was caked with black junk after three years of use. Clean it best you can, use a brush to get between the fins and cut a $1 generic A/C filter to size and insert it. Finally, make SURE that the unit tilts backwards just little. I put a double folded towel uner the front casters. Drainage is critical as is the evaporator. Otherwise there is no chance this unit will keep the floor dry for more than about 3 years of ongoing use. Goodluck!!