Haier HDW100WHT Support Question
Find answers below for this question about Haier HDW100WHT.Need a Haier HDW100WHT manual? We have 1 online manual for this item!
Question posted by ncbarker on September 8th, 2011
Water Not Heating
Current Answers
Answer #1: Posted by tech54774 on July 1st, 2013 12:04 AM
Remove the screws at the lower back of the two side panels. The panels can then be pulled sideways enough to allow you to remove the bottom cross-panel at the back (need to take screws out of that too). If you look inside, you'll see on the left (facing the back of the machine) is a stud with wires going to two terminals on the bottom. It goes up through the bottom of the tray, you can see the top of it on the inside back right in between the two rails of the heater element.
I found when I checked the terminals with a multimeter that they had an open circuit. There was a little button thing on the bottom of the sensor, between the two terminals; when I pushed that it seemed to reset the switch; it went to closed circuit and the water started heating again.
If yours isn't open circuit, (or you don't have a multimeter but pushing the button doesn't fix it), it might still be a heating element problem.
Related Haier HDW100WHT Manual Pages
Similar Questions
Hello, this is the HAIER HDT 18 PA dishwasher model, the water pump was damaged, do you have it? the...
HDW100WHT dishwasher door will close all the way however it will not latch. The plastic latch inside...
I have put my dishwasher on to wash, it starts, sounds like water going through but in 1minute it st...
HDW100WHT is tripping the main circuit, what could be the cause????