GE WSXH208HWW Support Question
GE WSXH208HWW Support Question
Find answers below for this question about GE WSXH208HWW - 27" Front-Load Washer.Need a GE WSXH208HWW manual? We have 1 online manual for this item!
Question posted by adaptto on June 27th, 2015
Machine Will Fill And Drain But Stopped Spinning.
why would the machine stop agitating and spinning. It will fill and drain but that's it. Belt is good. Motor spins by hand with the belt off.I cant get the drum to spin by hand with the belt off.also the timer motor in the controller doesn't seem to be running at all.
Current Answers
Answer #1: Posted by Odin on June 27th, 2015 10:41 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related GE WSXH208HWW Manual Pages
Owners Manual - Page 1
... Instructions
Control Panels 5 Control Settings 5 Fabric Care Labels 10 Features 6, 7 Loading and Using the Washer . . . . . .8, 9
Installation Instructions . . . . .11-16
Drain Requirements 14 Electrical Requirements 14 Installing the Washer 15, 16 Location of Your Washer 12 Preparing to Install Your Washer . . . . . .11 Replacement Parts 16 Rough-In Dimensions 12 Unpacking Your...
Owners Manual - Page 2
...be produced in a water heater that may be explosive under these circumstances. The instructions in this washer are not meant to run for several minutes. Since the gas is connected to escape. Consumer... appliance. WARNING! If the hot water has not been used for two weeks or more . Good, safe practices and caution MUST be followed to minimize the risk of fire or explosion, electric ...
Owners Manual - Page 3
...the Installation Instructions before it is used by or near children.
YOUR LAUNDRY AREA
■ Keep the area underneath and around your appliances free of...Instructions Troubleshooting Tips Consumer Support
PROPER INSTALLATION
This washer must be exposed to temperatures below freezing or exposed to the weather.
■ Properly ground washer to conform with all governing codes and ...
Owners Manual - Page 4
... until the machine has completely stopped
before attempting any part of fabrics. with an electrical overload protector. cleaning solvents, kerosene, etc.) which may
ignite or explode. The motor will automatically ... light ON).
Do not add these
substances around your washer or dryer during this time.
■ The laundry process can produce a toxic
intended
gas which may cause...
Owners Manual - Page 5
... out the cycle knob. To stop the washer, push in a hurry.
4
Final Spin Speed (on some models)
The Fast spin speed is for durable items.
The Normal spin speed is for the wash and... using Normal spin speed, clothes will automatically lock during the entire wash cycle.
5 You can locate your loads. For lightly soiled lingerie and special-care fabrics.
Start the washer by pushing ...
Owners Manual - Page 6
... water temperature and adjusts the fill water to remove excess dirt and detergent from soiled loads.
For example, if a COLD wash is selected, some models)
When the Cycle ...detergents. Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
About the washer features. DOOR LOCKED
Door Locked Indicator Light
The indicator light is ON and ...
Owners Manual - Page 7
... operation of the load. After adding laundry products, slowly close the drawer, and the washer will be unlocked....washer will drain into the compartment labeled "FABRIC SOFTENER" and marked with this washer. Slowly close the dispenser drawer. The Detergent Compartment
■ Add measured detergent to the detergent compartment of liquid fabric softener into the washer drum as it stops...
Owners Manual - Page 8
... laundry into loads that can be fully loaded with damp cloth. Moving and Storage: Ask the service technician to Manager, Consumer Relations, Mabe Canada Inc., 1 Factory Lane, Suite 310, Moncton, N.B. In Canada, write to remove water from hoses if weather will be below freezing.
8 Add one or two similar items.
Loading the Washer
Wash drum may...
Owners Manual - Page 9
... Area: Detergent and fabric softener may build up in the drum.
9 Rinse the inserts and the drawer with hot water ...
■ Remove the inserts from the upper and lower parts of accumulated laundry products.
■ To clean the drawer opening, use a small brush ...drawer and run the PREWASH or QUICK WASH cycle without any wash load in the dispenser drawer. Reach back into the
left rear corner...
Owners Manual - Page 10
... fabric care label "symbols" that affect the clothing you will be laundering. WASH LABELS
Machine wash cycle
Normal Permanent Press/ wrinkle resistant
Gentle/ delicate
Hand wash Do not wash
Do not wring
Water temperature
Hot (50°C/120°F)
Warm...
Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
About the washer features.
Owners Manual - Page 11
... and ordinances and the latest edition of the installer.
• Product failure due to improper installation is not covered under the Warranty.
TOOLS REQUIRED FOR WASHER INSTALLATION
❏ 1/4″ nut driver ❏ 3/8″ socket with ratchet ❏ 3/8″ open -end wrench ❏ Channel-lock adjustable pliers ❏ Carpenter's level
PARTS SUPPLIED...
Owners Manual - Page 12
...sheet kit, 14-A037. Mobile Home Installation
Installation must conform to Standard for proper washer operation.
2. ROUGH-IN DIMENSIONS
12 The floor MUST be below 60°F (15... openings required: 2 louvers each 60 square in contact with a maximum slope of 1/2″ per foot (1.27 cm per 30 cm). This kit is available through your GE retailer.
*Custom-sized countertop is desired, you...
Owners Manual - Page 13
... its back side.
3. Cartons covered with rugs, bedspreads, or plastic sheets can cause the washer to the drum and the base. Carefully return the washer to prevent shipping damage. Remove the following from the front of the washer.
8 10
7 12
8 9
11.
Remove and discard the yellow ribbon and label from the back side of...
Owners Manual - Page 14
... faucets MUST be located so the power supply cord is accessible when the washer is properly grounded.
1.
DRAIN REQUIREMENTS
1. In the event of malfunction or breakdown, grounding will reduce the...a licensed electrician if you of electrical shock. Properly grounded 3-prong receptacle to the washer can be plugged into an appropriate, copper-wired receptacle that is properly installed and ...
Owners Manual - Page 15
... vibrate. Carefully connect the other inlet hose to the inside "C" outlet of the washer (if the washer is installed under a counter, the washer should not be able to ensure the washer is damaged, you can adjust the rear legs by hand; then tighten another 2/3 turn with a wrench.
NOTE: Do not use the dispenser drawer or...
Owners Manual - Page 16
... into a grounded outlet. Place the hose in a laundry tub or standpipe and secure it with the hose pointed toward the drain. A snug hose fit can be an air gap around the drain hose. Turn on the power at the faucet, drain line
or washer.
12. Before starting the washer, check to make sure:
❏ Main power...
Owners Manual - Page 17
...
Fill hoses or drain hose is improperly connected
Household drain may be clogged
Control is not set properly
Water supply is improperly connected Water valve screens are stopped up
Water does not enter washer or enters slowly
House water heater is not set properly
Water supply is correctly inserted in the machine. You may be...
Owners Manual - Page 18
... unplugged Water supply is turned off ). • Make sure door is overheated
Washer won't spin
Washer door open Dispenser drawer open the
door and redistribute the load evenly. Stop washer and reduce load.
• See Installation Instructions for directions to stop if it becomes overheated. Possible Causes Incorrect sorting Washing too long Detergent not dissolving
Overloading Incorrect...
Owners Manual - Page 19
...or lightly colored items from dark colors. • Promptly remove wash load from washer.
• Avoid mixing heavy items (like work clothes) with ...belt buckles, zippers, and sharp objects left in contact with light items (like hair bleach or dye, permanent wave solution
What To Do
• Add one to two similar items. • Redistribute load.
• While this is not caused by the washer...
Owners Manual - Page 20
...; Damage after delivery.
■ Replacement of house fuses or resetting of the washer which vary from state to use within the USA. This warranty is not available... Electric Company. CCounstsoumer Seurpvipcoret Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
GE Washer Warranty. (For customers in this Limited Warranty. Please have other than the ...
Similar Questions
Machine Wont Spin Just Fill And Drain.
why would the machine stop agitating and spinning. It will fill and drain but that's it. Belt is goo...
why would the machine stop agitating and spinning. It will fill and drain but that's it. Belt is goo...
(Posted by adaptto 8 years ago)
Ge Front Load Washer Model Wssh300goww
Replaced motor control board and washer still want spin are wash
Replaced motor control board and washer still want spin are wash
(Posted by Applianceman214 8 years ago)
My Machine Is Not Draining,
on the final spin, the water doesn't drain and it isn't spining very fast. is there a filter that we...
on the final spin, the water doesn't drain and it isn't spining very fast. is there a filter that we...
(Posted by gma2718 12 years ago)
My Front Load Washer Doesn't Spin On The Spin Cycle.
(Posted by bss6495 12 years ago)
Ge Wbvh5300kww Front Load Washer
I own a GE front load washer (Model # WBVH5300KWW) for about a year. On a color cycle, water (cold...
I own a GE front load washer (Model # WBVH5300KWW) for about a year. On a color cycle, water (cold...
(Posted by rbblas 13 years ago)