Home » GE » Laundry Washers » GE WSSH300GWW

GE WSSH300GWW Support Question

Find answers below for this question about GE WSSH300GWW - 3.5 cu. Ft. Front-Load Washer.
Need a GE WSSH300GWW manual? We have 1 online manual for this item!

GE Overview Questions Manuals Reviews Videos Research

Question posted by Anonymous-141256 on August 6th, 2014

Strat Button Blinks And When You Push Start Control Lock Blink

The person who posted this question about this GE product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on August 6th, 2014 12:39 PM

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,783

100
points

Download user guide on the link and read from page 17
http://www.helpowl.com/manuals/GE/WSSH300GWW/25452

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related GE WSSH300GWW Manual Pages

Owners Manual - Page 1

....com Safety Instructions 2-4 Operating Instructions Control Panels 5 Control Settings 5 Fabric Care Labels 10 Features 6, 7 Loading and Using the Washer . . . . . .8, 9 Installation Instructions . . . . .11-16 Drain Requirements 14 Electrical Requirements 14 Installing the Washer 15, 16 Location of Your Washer 12 Preparing to Install Your Washer . . . . . .11 Replacement Parts 16 Rough...

Owners Manual - Page 2

The instructions in this washer are not meant to run for several minutes. WATER HEATER SAFETY Under certain conditions, hydrogen gas may occur. For your safety, the information in a water ...

Owners Manual - Page 3

...combustible materials such as lint, paper, rags and chemicals. An open . YOUR LAUNDRY AREA I Properly ground washer to conform with the Installation Instructions before it is used . I Install or ... Instructions Installation Instructions Troubleshooting Tips Consumer Support PROPER INSTALLATION This washer must be exposed to temperatures below freezing or exposed to the weather. Follow...

Owners Manual - Page 4

... equipped with controls. Check the condition of fabrics. SAVE THESE INSTRUCTIONS Consumer Support 4 I Never attempt to operate this Owner's Manual, or in damage to carry out. I Before discarding a washer, or removing it becomes overheated. NOTE: Pressing the PAUSE button does NOT disconnect the appliance from hiding inside. WHEN NOT IN USE I The laundry process...

Owners Manual - Page 5

... cycles. When using the MEDIUM spin speed, clothes will help you need in a hurry. I The washer will automatically lock during wash and rinse. ACTIVE WEAR For active sports, exercise and some casual wear clothes. Press the START button to mimic the handwashing action. I The door will not operate with your model number at the...

Owners Manual - Page 6

... is ON and the door is locked when the START button is desired to remove excess dirt and detergent from soiled loads. The light turns OFF at the end of the cycle. Control Lock To prevent accidentally starting or stopping the washer, press OPTIONS and SELECT at the same time until the Control Lock indicator is ON, it will sound...

Owners Manual - Page 7

...START to continue cycle. Fill to the minimum fill line (MIN.) for small loads. Closing the drawer too quickly could stain clothes. I Low sudsing detergent is recommended for this washer...washer as it stops. The DOOR LOCK indicator light will turn off and the door will drain into the washer...added. After adding laundry products, slowly close the dispenser drawer. I Detergent...

Owners Manual - Page 8

... START button. Moving and Storage: Ask the service technician to hit surface with sharp objects. Long Vacations: Be sure water supply is no longer any spills. Consumer Support 8 Sorting Wash Loads Sort laundry into loads that can be exposed to ensure a water tight seal. Large items should be fully loaded with damp cloth. When moving the washer...

Owners Manual - Page 9

...corner of accumulated laundry products. Replace the dispenser drawer and run the QUICK WASH cycle without any wash load in the dispenser drawer. Rinse the inserts and the drawer with hot water to lock it stops. ...out I Return the bleach and fabric softener inserts to the proper compartments. Lock tab is required. Replace the insert, pressing the "X" to remove traces of the drawer cavity...

Owners Manual - Page 10

...) Only non-chlorine bleach (when needed) Do not bleach In the shade Consumer Support 10 Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions About the washer features. Fabric Care Labels Below are fabric care label "symbols" that affect the clothing you will be laundering.

Owners Manual - Page 11

...in an area where it will be exposed to water/weather. Installation Instructions Spacemaker Washer Model WSSH300 If you have any questions, call 800.GE.CARES (800.432....❏ Channel-lock adjustable pliers ❏ Carpenter's level PARTS SUPPLIED ❏ Cable Tie ❏ Water Hoses (2) ❏ Rubber Washers (4) 11 Be sure to Consumer - TOOLS REQUIRED FOR WASHER INSTALLATION ❏...

Owners Manual - Page 12

...slope of 1974 (PL93-383). Installation Instructions LOCATION OF YOUR WASHER Do Not Install the Washer: 1. In an area exposed to Standard for proper washer operation. 2. On carpet. The floor MUST be below ...; (17.1 cm) Water Inlets 331⁄2″ (85.1 cm) REAR 12 To make sure the washer does not vibrate or move, you MUST use Stacking Kit WE25X10020. In an area where it will come ...

Owners Manual - Page 13

... them in a garbage container or make materials inaccessible to protect the floor, lay the washer on its back. 3. Cartons covered with rugs, bedspreads, or plastic sheets can become... suffocation. Using a rug, blanket or piece of the final location. 6. Carefully return the washer to prevent shipping damage. Save all materials in the holes vacated by the packaging spacers. Power...

Owners Manual - Page 14

...water department can result in a risk of 1 1/4″ (3.18 cm) minimum. 3. The washer MUST be connected. Individual, properly polarized and grounded 15-amp branch circuit fused with ground, 120... 42 inches (107 cm) of local codes, with a licensed electrician if you of your washer's water inlet. If the drain is properly grounded. 1. DRAIN REQUIREMENTS 1. A standpipe diameter...

Owners Manual - Page 15

... the HOT and COLD water faucets tightly by hand, then tighten another 2/3 turn with pliers. Turn the lock nuts on the front of the washer and snug with pliers. Remove the inlet hoses and rubber washers from the hot and cold faucets to flush the water lines and remove particles that might clog...

Owners Manual - Page 16

... a U shape, a siphoning action could occur. Cable Tie Cable Tie Cable Tie 9. Before starting the washer, check to be an air gap around the drain hose. Check for future reference. It contains... an outlet. 16 Installation Instructions INSTALLING THE WASHER (cont.) 7. Read the rest of the drain hose with the cable tie provided in a laundry tub or standpipe and secure it with the...

Owners Manual - Page 17

... faucets and make sure washer is not sitting on it. • Top of drain hose is incorrect Household drain may be less than 8 ft. (2.5 m) above floor. • Check household plumbing. they should ... drain outlet should be clogged Control is not set properly Water supply is improperly connected Water valve screens are stopped up Water does not enter washer or enters slowly House water ...

Owners Manual - Page 18

... clothes Possible Causes Washer is uneven Washer load is unbalanced High pitch jet engine sound Squealing sound or hot rubber odor Shipping bolts and foam block have separate outlet. • Check controls and make sure the START or DELAY START button has been pressed. • Close door and press the START button. • Close drawer. • Washer motor will automatically...

Owners Manual - Page 19

... using dispenser. • Sort whites or lightly colored items from dark colors. • Promptly remove wash load from washer. • Avoid mixing heavy items (like work clothes) with light items (like pins, objects in pockets and sharp buttons. • Turn knits (which snag easily) inside out. • Use correct amount of bleach dispenser...

Owners Manual - Page 20

...Control Lock is on the washer. • Be sure cold water faucet is clogged Oversudsing • Tighten inlet hose connections at faucets and washer...laundry. • Fully open door. restart the cycle. 4, Door is open Washer will unlock. Raise height of bend in drain hose to washer...'s recommendation for water temperature, water hardness, load size and soil level. 15, Hot water...