GE GTUP270EMWW Support Question
Find answers below for this question about GE GTUP270EMWW.Need a GE GTUP270EMWW manual? We have 3 online manuals for this item!
Question posted by Darryl43661 on January 19th, 2018
I Am Replacing The Wh45x24614 Tub Assy
The old one had screw tabs on the tub cover and the new one doesn't. GE said the part has changed and I need to use the XXX suspension kit with it. do you know what that part number would be? Because no one can tell me.
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related GE GTUP270EMWW Manual Pages
Quick Specs - Page 2
...Use only for complete instructions when using...GE® 27" Unitized Spacemaker® Washer...cannot be used, then...using flexible metal (foil type) ducting. Bathroom or Bedroom Installation: • The dryer MUST be located at ge.com26 Feet
or cal2l GE...GE Profile™ or 36 Feet GE...duct may be used ONLY in the... used (Kit ...number of open area equally distributed.
of 90° turns...
Quick Specs - Page 3
...cycle selection • Cycle status lights - Allow fast, easy cycle
selection • Model GTUP270EMWW - Washer will automatically
measure the load size and add just the right amount of water • ... (Gas)
GTUP270EM
Specification Revised 2/11
360328 GTUP270EM/270GM
GE® 27" Unitized Spacemaker® Washer and Dryer
Features and Benefits • 3.3 cu. Cycles are automatically
mixed ...
Use and Care Manual - Page 3
...exhausted to the outside.
2 Use only rigid metal 4" diameter ductwork inside the
dryer cabinet.
YOUR LAUNDRY AREA
n Keep the area ... same time if desired. Use only UL approved rigid metal or flexible metal 4" diameter ductwork for the washer and dryer to avoid electrical...can receive one by visiting GEAppliances.com or by calling 800.GE.CARES (800.432.2737).
For complete details, follow the...
Use and Care Manual - Page 5
...
5 GE recommends changing the hoses every 5 years.
Check the condition of this appliance or attempt any servicing unless specifically recommended in this appliance to avoid damage to the cord while pulling.
n Turn off water faucets to relieve pressure on , tripped over or subjected to damage. n Do not attempt to repair or replace any...
Use and Care Manual - Page 6
If the lid does not unlock after the basket stop the washer and reset the cycle to the new selection. Rinses and spins non-soiled items where a rinse only is turned to release. The lid lock prevents.... The chart below will help you match the wash cycle setting with light to begin the new cycle selection. For draining the tub and spinning water out of the washing process.
Use and Care Manual - Page 7
...opened while the washer is in the spin cycle or coasting to a stop the cycle, turn the Cycle Selector to a new cycle, the ..., the cycle will continue with very cold water year round, use the PerfecTemp plus COLD to help dissolve powdered detergents and to begin... load placed in the washer basket. The water fill will be added to reach a temperature needed to continue filling when AUTO LOAD SENSING...
Use and Care Manual - Page 8
...or into the agitator if the dispenser is securely attached to use a stiff brush;
Do not stop the washer during the cycle.
Dispenser cup will cause the dispenser to ...240 ml) bleach
4 If necessary, loosen buildup with your fingers. This will pop free from the cover by grasping the top and pushing down on package.
Pour into FABRIC SOFTENER dispenser.
8
n D o not...
Use and Care Manual - Page 9
... off any spills.
If you want to clean the basket, use harsh or gritty cleaners.)
Fill Hoses: GE recommends changing the hoses every 5 years. Try not to hit surface with...
GE.CARES (800.432.2737). Water level should just cover the clothes. Wipe with liquid detergent; For more information, visit GEAppliances.com or call 800. Loading and using the washer.
Do not store the washer ...
Use and Care Manual - Page 11
...from using dryer-added fabric softener sheets. A waxy buildup may form on the lint filter from the dryer. Dry thoroughly and replace. Have... the hose attachment and reconnect the duct. On some laundry pretreatment soil and stain remover products.
Run your dryer caused... by these steps:
1. Make sure that there is not covered by some models
Clean lint from the wall socket.
2. Dryer...
Use and Care Manual - Page 13
...washer may be less than 8 ft (2.5 m) above floor.
Using too much detergent
Measure your detergent carefully. You may not need to clean the screens in and secured to remove soapy water more efficiently.
Use... back of drain outlet should be replaced every 5 years. put in its...
New laundry detergents have soft water, a smaller load or a lightly soiled load. Top of the washer....
Use and Care Manual - Page 14
... matches the load you call for service... Unplug washer, wait 2 minutes, plug back in the washer basket . Call for using dispenser.
Clothes are air or line dried
If you load clothes.
Use warmer water temperature. Washer Operation
Washer won't operate
Movement inside machine when shut off
Possible Causes
Washer is unplugged
Water supply is turned off , the...
Use and Care Manual - Page 15
... move freely with water covering all of the clothes.
The washer should then begin spinning ...like work clothes) with undiluted bleach. Load your laundry.
This occurs multiple times during spin cycle
"... mixes in warm or cold water. The sound changes when the valves are washing (especially for easy... pump starts drawing in water that doesn't use gears. Rinse items that may have enough...
Use and Care Manual - Page 16
...service is blown/circuit
Check the house fuse/circuit breaker box and replace both breakers.
Improper use 2 fuses/breakers. Use proper washing procedures before each load. Lint on clothes
Drying dirty ...items with the manufacturer's instructions. left in pockets
Empty all GE Dryers when used in accordance with clean ones
Use your dryer to dry only clean items. Dirty items can stain...
Use and Care Manual - Page 17
... sorting
Separate heavy items from lightweight items (generally, a wellsorted washer load is clean, free of moisture.
Do not put more...Separate large, heavy fabrics into smaller ones. Since most dryers use 2 fuses/breakers, make sure the dryer venting is full
Clean... ducting/venting. Select a LESS DRY or DAMP DRY setting. Replace fuses or reset circuit breakers. Check to the load you are...
Use and Care Manual - Page 19
... a trip charge or you may also have serial number and model number available when calling for home use the product. If the product is abused, misused, or used commercially. For The Period Of:
One Year From the date of the original purchase
We Will Replace:
Any part of merchantability or fitness for other...
Installation Instructions - Page 2
...or set to deliver water at the top of the washer. ing electrical requirements.
Follow national electrical codes and ...
SHUTOFF VALVES - CAUTION: For personal safety, do not use an
extension cord or adapter plug with the voltage and ... 6 Level your appliance (see section 1). This appliance should be set tub. Step 8 Connect the External Exhaust (see section 12.
2 Concrete flooring...
Installation Instructions - Page 4
...use of washer to remove shipping bar. Move washer close to provide adequate clearance for installation and service.
1 PREPARING FOR INSTALLATION OF NEW APPLIANCE
DISCONNECTING GAS
TURN GAS SHUT-OFF VALVE TO THE OFF POSITION.
DISCONNECT AND DISCARD OLD FLEXIBLE GAS CONNECTOR AND OLD...appliance must be isolated from tub. Installation Instructions
Minimum Clearance Other Than Alcove or ...
Installation Instructions - Page 6
...-PRONG RECEPTACLE. The MAXIMUM ALLOWABLE duct length and number of bends of the exhaust system depends upon the type of duct, number of turns, the type of local codes, in... and replace with 120V, 60Hz, and connected to incorrect installation are not covered by a 15- If electrical supply provided does not meet the above specifications, it is YOUR RESPONSIBILITY.
Using exhaust ...
Installation Instructions - Page 10
...cold flowing, of the machine. If appliance is required, order drain hose extension kit, GE part number WH49X301. Thread hot water hose onto connection labeled H at the rate of water ....
• SIPHON BREAK KIT - Use Siphon Break Kit WH49X228 and follow instructions in the kit.
11 CONNECTING TO PLUMBING FACILITIES
c
H
If not installed, install rubber washer in kit). Hand tighten, plus an...
Installation Instructions - Page 12
... PRIOR TO DISCONNECTION WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION AFTER SERVICING/INSTALLATION. For replacement parts and other information, refer to protection under the terms of your right to Owner's Manual for servicing phone numbers. www.GEAppliances.com (US)
For Questions on Installation, Call: 1-800-GECARES (US)
12
Similar Questions
My Washer Needs A New Gasket And Motor. How Much Will It Cost To Replace Both
(Posted by obbyLevine 1 year ago)
Relace Tub Seal
Do I need to remove control panel, main top, and tub cover when replacing tub seal on GTW S8655DOMC ...
Do I need to remove control panel, main top, and tub cover when replacing tub seal on GTW S8655DOMC ...
(Posted by glothian 4 years ago)