GE GFDN100GLWW Support Question
GE GFDN100GLWW Support Question
Find answers below for this question about GE GFDN100GLWW.Need a GE GFDN100GLWW manual? We have 1 online manual for this item!
Question posted by COXS1 on August 5th, 2012
How Do I Reset The Easy Touch Buttons On My Gedpsb620ecww.
WHEN I HIT THE COTTON OR MIXED LOAD EASY TOUCH BUTTONS THE TIME AUTOMATICLY GOES TO 1:59 OR MORE. I WANT TO RESET IT BACK TO THE ORIGINAL TIME OF 20-25 MIN.
Current Answers
Related GE GFDN100GLWW Manual Pages
Owners Manual - Page 1
...
GEAppliances.com
Safety Instructions 2-5
Operating Instructions
Control Panels 6-9 Cycle Options 10, 11 Dryer Features 11 Reversing the Door Swing . . . .12-16 Loading and Using the Dryer 17, 18 Venting the Dryer 19 Stacking 20-23
Troubleshooting Tips . . . .24-26
Consumer Support
Warranty 27 Consumer Support 28
Owner's Manual
DBVH520 DCVH640 DCVH680 DHDVH68 GFDN100 GFDN110
Write...
Owners Manual - Page 2
...caused primarily by the incomplete combustion of potential exposure to the outdoors.
Properly adjusted dryers will minimize incomplete combustion. Safety Instructions
Operating Instructions
IMPORTANT SAFETY INFORMATION.
WHAT TO...or cigarette, or turn on any gas or electrical appliance.
2 Do not touch any other reproductive harm and requires businesses to warn customers of natural gas or...
Owners Manual - Page 3
....com, or by calling 800.GE.CARES (800.432.2737).
Properly ground dryer to conform with the Installation Instructions before it will prevent the duct from getting crushed... and connect the exhaust duct to the outside. Safety Instructions
GEAppliances.com
PROPER INSTALLATION
This dryer must be properly installed and located in Installation Instructions.
Install or store where it...
Owners Manual - Page 4
...used by removing the fuse or switching off the circuit breaker before each load to the wash water. NOTE: Pressing START, STOP or POWER does NOT disconnect the ...Instructions
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.
YOUR LAUNDRY AREA
Keep the area underneath and around your dryer. Observe all laundry aids (such as acetone, denatured alcohol, gasoline, kerosene,...
Owners Manual - Page 5
... either a fabric softener in your hand in the vicinity of the burner when the automatic ignition turns on the package that you understand and have a pilot light. See the Loading and Using the Dryer section.
If yours is a gas dryer, it is damaged, malfunctioning, partially disassembled, or has missing or broken parts, including a damaged...
Owners Manual - Page 6
You can locate your model number at the top inside of the door opening.
Model DHDVH68
176
Operating Instructions
Model DCVH680
2 3
176
45
Troubleshooting Tips
Model DCVH640
2 3
176
45
Consumer Support
Model DBVH520
2 3
176
45
23
6
45 Safety Instructions
About the dryer control panel.
Owners Manual - Page 8
...COTTONS MIXED LOAD
EASY CARE (on some models)
ACTIVE WEAR (on some models)
MY CYCLE Press to use and performance of the drying process. For questions or issues related to warm up " the display. Provides 10 minutes of fabrics. TIMED DRY is not recommended for use TIMED DRY: 1. Select the drying time... to set your selected dry level, the dryer will help you match the dry setting with...
Owners Manual - Page 9
...
About the dryer control panel.
5 Dry Temp You can be used with COTTONS or MIXED LOAD cycles. This message will still be used during a portion of settings".
7
"CLEAN LINT FILTER" (message)
(This message represents only a reminder.)
After the POWER button is Certified by 99.9%, including: Staphylococcus aureus, Pseudomonas aeruginosa and Klebsiella pneumoniae*. Even though you want...
Owners Manual - Page 10
...time in the ESTIMATED TIME REMAINING display.
GEAppliances.com
DAMP ALERT
Damp Alert (on some models)
This option causes the dryer to 10 hours for model DBVH520.
Choose your dryer.
1. arrow pads.
3. The countdown time...the beeper off so wrinkles don't set in DELAY, the countdown time will be removed when the beeper goes off . Delay Start (on all features are dry. Press DELAY ...
Owners Manual - Page 11
... household distribution panel by touching pads with the TIMED DRY or RACK DRY
(on all features are available on some models) cycles. Do not use your custom cycle, press the MY CYCLE button before drying a load.
The lights will see an initial approximate total cycle time in the dryer.
11
Reach above dryer opening from being made...
Owners Manual - Page 12
IMPORTANT: Once you ever want to switch them in the wrong places.
Provide a non-scratching work surface for the doors.
Normal completion time to the left and right.
These instructions are for changing the hinges from its electrical ...do not move the cabinet until door-swing reversal is 30-60 minutes. Unplug the dryer from the right side to reverse the door swing is completed.
Owners Manual - Page 16
...22.
Turn the door over and fasten the outer door to the uppermost screw hole. then reinstall both on the dryer. After reversing door, there will be installed on the opposite side. The door is opposite the hinge, as a ... the other flat tool, remove the 5 plastic screw caps located on the dryer where the door will be used as shown.
20. Fasten the hinge by removing the screws;
Owners Manual - Page 17
... load has become warm.
Bounce® Fabric Conditioner Dryer Sheets have been approved for the dryer.
Fabric Care Labels
Below are sorted properly for use in all GE Dryers ...load target water temperature
Category
Tap Cold Cold Warm Hot Sanitize
Target Water Temperature
Inlet Water Temperature 27°C/80°F 40°C/105°F 50°C/120°F 70°C/160°F
Automatic...
Owners Manual - Page 18
... DRYER WITHOUT ITS FILTER IN PLACE. A partially clogged exhaust can lengthen the drying time. Have a qualified technician vacuum the lint from the dryer once a year.
2 Disconnect the duct from the dryer....Inspect and clean the exhaust ducting at least once a year to your dryer caused by some laundry pretreatment soil and stain remover products.
GEAppliances.com
Care and Cleaning of the...
Owners Manual - Page 19
...protector in the Installation Instructions. Use only rigid metal 4" diameter ductwork inside the dryer cabinet
and for exhausting to the outside. Do not use more energy and run ...kink or collapse the duct. Avoid resting the duct on sharp objects. Venting must conform to the dryer. Carefully follow the details on Exhausting in place
(on some models). Flip the protector down to its ...
Owners Manual - Page 20
...of 120 square inches of its weight and size. ALCOVE OR CLOSET INSTALLATION
If your dryer is approved for local electrical inspector's use.
IMPORTANT: Observe all governing codes and ...ordinances.
Note to the outdoors. Failure to the washer. Troubleshooting Tips
Consumer Support
20 GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT: Save ...
Owners Manual - Page 21
Continue using the carton to lay the dryer down on its side. KIT CONTENTS
Right Hand Bracket
4 Rubber Pads
Left Hand Bracket
TOOLS YOU WILL NEED
Phillips Screwdriver Open-Ended Wrench
Pliers
INSTALLATION ...
Owners Manual - Page 24
... are drying.
• Clean lint filter before every load.
• Replace fuses or reset circuit breakers. Press START to dry. Dryer may not need to unlock the dryer.
• Reset the in the clothes
• Inspect and clean exhaust system.
• Press STOP.
• Hold the LOCK button for 3 seconds to call for service. NOTE: Electric...
Owners Manual - Page 25
...The estimated time may change • This is running but not heat
• Check the building's fuse/circuit breaker box and replace both fuses or reset both breakers. Dryer doesn't ..., or use the EXTEND TUMBLE option.
• Separate large loads into smaller ones.
25
Consumer Support Dryer is normal.
Inconsistent drying times Type of heat
Type of the drum
Heaters behind the drum
...
Owners Manual - Page 27
... The Period Of: We Will Replace:
One Year From the date of the original purchase
Any part of the dryer which vary from state to use within the USA.
In Alaska, the warranty...workmanship.
This warranty is abused, misused or used commercially. Replacement of house fuses or resetting of merchantability or fitness for a particular purpose, are , consult your local or state consumer...
Similar Questions
Ge Dryer Dpse810egwt Start Button Clicks
GE Dryer DPSE810EGWT start button clicks a few times and then ... maybe it'll start up. Took it apar...
GE Dryer DPSE810EGWT start button clicks a few times and then ... maybe it'll start up. Took it apar...
(Posted by tjn76 2 years ago)
The Start Button Doesn’t Work Anymore, And The Dryer Therefore Doesn’t Come
the dryer stopped working. It does not turn on when I press the start button. What could be the prob...
the dryer stopped working. It does not turn on when I press the start button. What could be the prob...
(Posted by Dtons74 6 years ago)
My Dryer Won't Start When I Push The Start Button What Can Be Wrong
(Posted by iyanamentor 10 years ago)
Dry Time On Mixed Load
Hi, I have three of dryers in my apartments and two of the three show a dry time of 57 minutes when...
Hi, I have three of dryers in my apartments and two of the three show a dry time of 57 minutes when...
(Posted by dlandry1 11 years ago)
Ge Dsk333e Dryer Won't Run Though When The Start Button Is Pushed It Buzzes
The unit is getting power and the start button works. No wires appear to disconnected inside the uni...
The unit is getting power and the start button works. No wires appear to disconnected inside the uni...
(Posted by dmsearles 12 years ago)