Home » GE » Laundry Dryers » GE DPGT650EHMG

GE DPGT650EHMG Support Question

Find answers below for this question about GE DPGT650EHMG - 27" Electric Dryer.
Need a GE DPGT650EHMG manual? We have 1 online manual for this item!

GE Overview Questions Manuals Reviews Videos Research

Question posted by susanjameson on January 22nd, 2014

How Do I Remove The Lamp In Order To Replace It?

Cannot seem to turn or pull on bad lamp to remove it.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on January 22nd, 2014 3:57 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,417

1,100
points

Go to this page for the bulb change instructions.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related GE DPGT650EHMG Manual Pages

Owners Manual - Page 1

....com Safety Instructions 2-5 Operating Instructions Controls 6-8 Cycle Options 9-10 Dryer Features 11 Loading and Using the Dryer 12, 13 Installation Instructions Before You Begin 14-16 Connecting a Gas Dryer 17-20 Connecting an Electric Dryer 21-23 Exhausting the Dryer 24-28 Final Setup 29, 30 Reversing the Door Swing . . . . . .31, 32 Troubleshooting Tips 33 Consumer...

Owners Manual - Page 2

... 4 Immediately call your gas supplier, call the fire department. Properly adjusted dryers will minimize incomplete combustion. Operating Instructions Safety Instructions IMPORTANT SAFETY INFORMATION. READ ALL ... substances can cause minor exposure to light a match, or cigarette, or turn on any gas or electrical appliance. 2 Do not touch any phone in this or any other appliance...

Owners Manual - Page 3

...■ Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. ■ Remove the colored protective film from getting crushed (on some models). PUNCTURED DUCTWORK CAN CAUSE...the control panel and the door. ■ Remove all sharp packing items and dispose of the dryer (on some models). ■ Pull the protector out and down to its lowest ...

Owners Manual - Page 4

... household cleaners, some spot removers, turpentines, waxes, wax removers and products containing petroleum distillates. ■ The laundry process can under certain circumstances produce fire by or near the dryer until the drum has completely stopped. ■ Clean the lint filter before attempting any maintenance or cleaning (except the removal and cleaning of electric shock, unplug this...

Owners Manual - Page 5

...the cord while pulling. SAVE THESE INSTRUCTIONS Installation Instructions Troubleshooting Tips Consumer Support 5 WHEN NOT USING YOUR DRYER ■ Grasp ...dryer should be stepped on, tripped over or subjected to damage. ■ Before discarding a dryer, or removing it from service, remove the dryer door to prevent children from hiding inside. ■ Do not tamper with an automatic electric...

Owners Manual - Page 6

Operating Instructions Safety Instructions About the dryer control panel. Control Panel Throughout this manual, features and appearance may vary from your model. 1 6 453 27 Installation Instructions Consumer Support Troubleshooting Tips 6

Owners Manual - Page 7

... or mixed type of fabrics. ULTRA DELICATES For delicate fabrics. For leaving items partially damp. DEWRINKLE For removing wrinkles from the power supply. 2 Cycles The cycle controls the length and tumble speed of moisture in ...wear. This is active, press to set your selected dry level, the dryer will help you want is selected. 2. To use , create or modify custom dry cycles. 3 Time Dry...

Owners Manual - Page 9

...up to 3 hours. Installation Instructions Troubleshooting Tips Consumer Support 9 NOTE: Not all dryer models. The clothes should be removed when the beeper goes off . Press SIGNAL to select low or high volume, or to... drum without heat for 10 seconds every 5 minutes for up to turn the beeper off so wrinkles don't set in 1-minute increments, down to sound every 2 minutes (maximum ...

Owners Manual - Page 11

... top left of the door frame. 1 Remove the screw holding the drum lamp shield in the dryer. The drum lamp is also strongly recommended when drying sneakers. • Do not use this drying rack when there are other clothes in place. 2 Slide the shield up and remove. 3 Remove the bulb and replace with the TIME DRY cycle.

Owners Manual - Page 13

...duct should be damaged by pulling straight up. A waxy buildup may then be cleaned once a year by your fingers across the filter. If the dryer drum should be washed ...cloth. Run your warranty. To remove this buildup, wash the lint screen in a GE dryer. Remove by some laundry pretreatment soil and stain remover products. Dry thoroughly and replace. The Exterior: Wipe or dust...

Owners Manual - Page 14

... be exhausted to the outdoors. • Before the old dryer is above 50°F for local electrical inspector's use. • IMPORTANT - Keep these substances can cause minor exposure to four of the dryer control system. • Remove and discard existing plastic or metal foil duct and replace with the Consumer. • Note to the outdoors...

Owners Manual - Page 15

...service. DRYER DIMENSIONS Front View 437⁄ 8″ (111.4 cm) Side View 27″...DRYER IMPORTANT: Gas dryers are : • 0 inch clearance both sides • 1 inch front • 3 inches rear Consideration must be given to remove all of the foam pieces around the legs. Installation Instructions UNPACKING YOUR DRYER Tilt the dryer sideways and remove the foam shipping pads by pulling...

Owners Manual - Page 16

... 52″. • Closet doors must be installed in the same closet with the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70 (for electric dryers) or NATIONAL FUEL GAS CODE, ANSI Z223 (for installation in the absence of open area equally distributed. • No other surfaces is: 0″ either side 3&#...

Owners Manual - Page 17

... breaker(s) or remove the dryer's circuit fuse(s) at the electrical box. or straight-blade screwdriver (may be needed for tightening connections Turn the dryer's gas shutoff valve in the supply line to the OFF position. Shutoff Valve Disconnect and discard old flexible gas connector and ducting material. 17 Installation Instructions CONNECTING A GAS DRYER (skip for electric dryers) TOOLS...

Owners Manual - Page 20

... directly into a properly grounded three-prong receptacle. Open Gas Valve ELECTRICAL CONNECTION INFORMATION FOR GAS DRYERS WARNING - To reduce the risk of the dryer, and to an alternate established ground. Do not cut or remove the grounding terminal from this appliance. • The dryer must not contain ammonia, which meets local codes, may be supplied...

Owners Manual - Page 21

...-head screwdriver (for terminal connections) FOR YOUR SAFETY: WARNING Before making the electrical connection, turn off the circuit breaker(s) or remove the dryer's circuit fuse(s) at the electrical box. Be sure the dryer cord is unplugged from the wall. To reduce the risk of fire, electrical shock and personal injury: • Do not use an extension cord...

Owners Manual - Page 22

... 4-wire Connection: Connect the two hot lines to the equipment grounding terminal on new construction. A Remove the terminal block access cover located at connections. 22 Strain Relief CONNECTING DRYER POWER CORD NOTE: Since January 1, 1996, the National Electrical Code requires that new constructions utilize a 4-wire connection to an individual branch circuit, protected by...

Owners Manual - Page 28

... of the cabinet, order exhaust kit 14-A003, available from the wall exhaust opening. DRYER EXHAUST TO SIDE OR BOTTOM OF CABINET If you install your dryer before installing your GE supplier. Installation Instructions EXHAUSTING THE DRYER (cont.) BEFORE YOU BEGIN • Remove and discard existing plastic or metal foil duct and replace with duct tape...

Owners Manual - Page 33

...8226; Make sure the cycle was not pressed after use two fuses or breakers. • Unplug dryer, wait 2 minutes, plug back in and press POWER. • Press START. • ...Installation Instructions Troubleshooting Tips Consumer Support 33 NOTE: Electric dryers use . The noise will not come on the drum support rollers. Replace fuses or reset breaker. Troubleshooting Tips Save time ...

Owners Manual - Page 34

...Proof of the original purchase date is abused, misused or used commercially. ■ Replacement of the light bulb after delivery. ■ Product not accessible to provide required service...of the dryer which fails due to a defect in materials or workmanship. In Alaska, the warranty excludes the cost of incidental or consequential damages. Warrantor: General Electric Company. Please...