GE DCVH680EJMS Support Question
GE DCVH680EJMS Support Question
Find answers below for this question about GE DCVH680EJMS - 7.0 cu.ft. Electric Dryer.Need a GE DCVH680EJMS manual? We have 3 online manuals for this item!
Question posted by Anonymous-123286 on October 25th, 2013
Ge Dryer Wont Start
my ge dryer model DCVH680 lights up but when i push the start buttion it makes a clicking noise & wont start...please help
Current Answers
Related GE DCVH680EJMS Manual Pages
Use and Care Manual - Page 1
... Venting the Dryer 19 Stacking 20-23
Troubleshooting Tips . . . .24-26
Consumer Support
Warranty 27 Consumer Support 28
Owner's Manual
DBVH520 DCVH640 DCVH680 DHDVH68 GFDN100 GFDN110
Write the model and serial numbers here:
Model
Serial
They are on the label on the front of the dryer behind the door.
364B7130P001 49-90393-2 03/11/10 GE
Use and Care Manual - Page 3
...visiting GEAppliances.com, or by calling 800.GE.CARES (800.432.2737). n Properly ground dryer to the weather.
Exhaust/Ducting:
1
Dryers MuST be exposed to temperatures below freezing...the dryer (on some models).
Operating Instructions
Troubleshooting Tips
Consumer Support
3
n Pull the protector out and down to its lowest position and connect the exhaust duct to avoid electrical ...
Use and Care Manual - Page 4
... Instructions
IMPORTANT SAFETy INFORMATION. n Keep the floor around your dryer. n Keep all warnings on top of electric shock, unplug this appliance from Heat or Do Not Tumble...dryer top. NOTE: Pressing START, STOP or POWER does NOT disconnect the appliance from the remaining particles that may be put in a locked cabinet. YOUR LAUNDRY AREA
n Keep the area underneath and around your dryer...
Use and Care Manual - Page 6
Safety Instructions
About the dryer control panel.
You can locate your model number at the top inside of the door opening. Model DHDVH68
176
Operating Instructions
Model DCVH680
2
3
45
176
Troubleshooting Tips
Model DCVH640
2
3
45
176
Consumer Support
Model DBVH520 6
2
3
45
176
23 45
Use and Care Manual - Page 8
...3 Timed Dry
Use to set your selected dry level, the dryer will help you match the dry setting with the DRYEL™ "dry ...Sensor Cycles
COTTONS MIXED LOAD
EASY CARE (on some models)
ACTIVE WEAR (on some models)
DELICATES DRYEL™
SPEED DRY
For cottons and... Turn dry cycle dial to warm up " the display. Press START.
4 Sensor Dry level
The sensor continuously monitors the amount of DRYEL...
Use and Care Manual - Page 9
...and save them here for three seconds to start a dry cycle. These custom settings can change your favorite combination of this cycle on some models)
Set up . Change DRy TEMP and ... button is activated.
Press it will light up your stored My CyClE combination: Follow steps 1-4 in progress. A beep will sound
and the pad will pause the dryer.
HIGH MEDIUM
LOW EXTRA LOW
NO HEAT...
Use and Care Manual - Page 10
...remind you to delay the start of your dry cycle and any options.
2. n You can delay the start the countdown.
You can reduce the need to iron some models)
This option causes the dryer to beep when clothes have...Minimizes wrinkles by adding approximately 60 minutes of a dry cycle up to 18 hours for models DCVH640, DCVH680, DHDVH68 and up to turn the beeper off so wrinkles don't set in 1 ...
Use and Care Manual - Page 11
...begins, you have started a cycle. The lights will light up the lint filter slightly. At that point, the dryer will "race" in the load.
Drum lamp
Before replacing the light bulb, be sure...slots, then push the filter back down the My CyClE button for 3 seconds.
Reach above dryer opening from being made. Troubleshooting Tips
Consumer Support
Drying Rack (on some models) cycles. ...
Use and Care Manual - Page 12
...scratching work surface for changing the hinges from its electrical outlet .
12
IMPORTANT: Once you Start
1. TOOLS YOU WILL NEED
Adjustable Crescent Wrench
Phillips... INSTRUCTIONS
Before you begin, do not move the cabinet until door-swing reversal is 30-60 minutes. Unplug the dryer from the right side to the left and right.
n Set screws down by their related parts to reverse the...
Use and Care Manual - Page 17
... not overload.
Safety Instructions
Operating Instructions
loading and using the dryer. Bounce® Fabric Conditioner Dryer Sheets have been approved for the dryer. Fabric Care Labels
Below are sorted properly for use in .../ Gentle/ wrinkle resistant delicate
Do not dry
Do not tumble dry (used in all GE Dryers when used with do not dry a sheet with socks or other small items.
Do ...
Use and Care Manual - Page 24
... Instructions
Troubleshooting Tips
PROBlEM Dryer shakes or makes noise Clothes take longer to call for service.
Exhaust system is normal. NOTE: Electric dryers use 2 fuses/breakers, make sure the dryer venting is correct.
• Make sure ducting is clean, free of heavy and light fabrics
• When combining heavy and light fabrics in the load, the dryer will display the dry...
Use and Care Manual - Page 25
... (gas models)
• Refill or replace tank. If you recently changed from is put in dryer after a...electric to a gas (natural or LP) dryer, or vice versa, the drying time could be reselected each time a new load The load was activated
• Press START...lighting, the glow of the drum
Heaters behind the drum
• This is normal. Clothes are still wet and dryer shut off
• Make...
Use and Care Manual - Page 26
...wash or tumble dry it.
Paper, tissue, etc., left in pockets • Empty all GE Dryers when used
Overdrying Synthetics, permanent press and blends can be seen when the clothes are wet appear... fabric softener package.
• Use your dryer to lESS DRy or DAMP.
• Try a fabric softener. Static electricity can stain clean items and the dryer.
• Sometimes stains which cannot be ...
Use and Care Manual - Page 27
... or limitation of circuit breakers. Warrantor: General Electric Company. Proof of charge, all labor and ...GE Service location for service. In Alaska, the warranty excludes the cost of the dryer which vary from state to obtain service
under the warranty. This warranty gives you specific legal rights, and you may be responsible for a trip charge or you may also have serial number and model...
Quick Specs - Page 1
... website at ge.com or call GE Answer Center® service, 800.626.2000.
Listed by a 30-amp circuit breaker or a time-delay fuse, is mounted in inches)
Electric Dryer Rating
27
240V 5600W, 24A, 60Hz
208V 4400W, 22A, 60Hz
Exhaust Options: 4-way via rear, right, left and bottom. Ft. Super Capacity Frontload Electric Dryer
Dimensions and...
Quick Specs - Page 2
...or in . Ft. Bathroom or Bedroom Installation: • The dryer MUST be ...Electric Code and National Fuel Gas Code, ANSI Z223 for stacking dryer over washer is 52".
• Closet doors must be exhausted to overhead cabinets, ceilings, etc. DCVH680EJ
GE® 7.0 Cu. Super Capacity Frontload Electric Dryer
Special Installation Requirements:
Stacked Installation: Kit for gas dryers...
Quick Specs - Page 3
...information on venting kits and accessories, please call 1-800-GE-CARES. ft. Super Capacity Frontload Electric Dryer
Dryer Exhausting Information -
If you exhaust to prevent back drafts...Kit WX08X10077).
rigid metal duct
Exhaust hood type
B
Domestic 2-1/2 dryer models
7.0, 6.0 and 5.8 cu. DCVH680EJ
GE® 7.0 Cu. Determine the number of lint and grease could cause damage.
...
Quick Specs - Page 4
... results • Anti-Bacteria Option - Metallic red • Model DCVH680EJMS - Continually monitors moisture levels to 99% of certain types
of insulation • Adjustable End-Of-Cycle Signal -
Vermillion Red
DCVH680J
Specification Revised 10/10
360455 Super Capacity Frontload Electric Dryer
Features and Benefits • 7.0 Cu. Reminds you when cycle is done, saving time...
Installation Instructions - Page 3
...should slope down .
Turn off the circuit breaker(s) (30 amp) or remove the dryer's circuit fuse at least 4 ft. Remove the power cord cover located at the lower back. 4.
above strain relief... to strain relief.
8. of
duct must be made air and moisture-tight by at the electrical box.
2. The male end of each section of straight duct, including distance between last turn...
Installation Instructions - Page 7
...THROUGH BOTTOM OF CABINET
• Insert the elbow through before starting. • Handle parts carefully to avoid scratching paint. &#... Tapping Screw (#10) ... 6
Nut (#8) - 2
Washer - 2
Tapping Screw (#8) ... 2
Machine Screw (#8) ... 6 Place dryer in
the wrong places. • Provide a non-scratching work surface for changing the hinges from your right to complete the exhaust system...
Similar Questions
Dryer Shuts Off
My dryer will not always complete the dry cycle, sometimes it turns off after ten minutes. Not sure ...
My dryer will not always complete the dry cycle, sometimes it turns off after ten minutes. Not sure ...
(Posted by mdstups 4 years ago)
How To Access Inside Of Dryer?
There is a dead mouse under the drum. How do we access that?
There is a dead mouse under the drum. How do we access that?
(Posted by dianethetenor 5 years ago)
Ge Dryer Model Dpse810eg0wt
LED on front panel flashing. '8' Had unplugged to clean behind. Plugged back in, problem began. Mach...
LED on front panel flashing. '8' Had unplugged to clean behind. Plugged back in, problem began. Mach...
(Posted by pjabiff 9 years ago)
Dry Time On Mixed Load
Hi, I have three of dryers in my apartments and two of the three show a dry time of 57 minutes when...
Hi, I have three of dryers in my apartments and two of the three show a dry time of 57 minutes when...
(Posted by dlandry1 10 years ago)
How Do I Replace The Dryer Belt On My Ge Dryer Model Number Dwsr483eb2ww
(Posted by paceckafecker 11 years ago)