The Led Functions

Walk testing should be done to determine the sensor's

actual coverage area. The edge of the coverage pattern is

determined by the first flash of the LED. This may change

slightly depending upon the sensitivity setting. Walk test

the unit from both directions to determine the pattern

boundaries.

1. Remove the sensor body from the mounted mounting

plate, activate the tamper switch, and then remount the

body to activate the 60 second walk test mode.

2. Walk across the coverage pattern to determine the coverage

area, indicated by LED activation. Each activation

extends the walk test mode for an additional 60

seconds.

After 60 seconds without motion the walk test mode and the

LED will no longer activate when motion is detected.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!