2001 GMC Sonoma Support Question
2001 GMC Sonoma Support Question
Find answers below for this question about 2001 GMC Sonoma.Need a 2001 GMC Sonoma manual? We have 1 online manual for this item!
Question posted by giopoth on November 13th, 2013
How To Remove Headlight Assembly On 2001 Gmc Sonoma
The person who posted this question about this GMC automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 2
Every 2001 Sonoma under warranty is backed with the following services:
1-800-GMC-8782
( For vehicles purchased in Canada, call 1-800-268-6800 )
that provides in an emergency:
Courtesy Transportation Trip Routing
Free lockout assistance Free dead-battery assistance Free out-of-fuel assistance Free flat-tire change Emergency towing
Owner's Manual - Page 3
Part Number X2108 A First Edition
© Copyright General Motors Corporation 2000 All Rights Reserved
i 2001 GMC Sonoma Owner's Manual
Litho in U.S.A.
Owner's Manual - Page 8
GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Emblem and the name SONOMA are registered trademarks of Canada Limited" for GMC whenever it appears in your vehicle, so it will be there if you ever need it when you sell the vehicle, please leave this manual. ...
Owner's Manual - Page 62
... push down on the child restraint. Securing a Child Restraint in the Center Front Seat Position (Regular Cab & Extended Cab Models) and in these positions.
To remove the child restraint, just unbuckle the vehicle's safety belt and let it helpful to work properly.
1-49 To tighten the belt, feed the shoulder belt...
Owner's Manual - Page 67
...directions to push down on the child restraint as you were using a forward-facing child restraint, you remove the rear-facing child restraint from the vehicle unless the person who isn't in a risk group. ...a person who will move freely again and be sure it go back all the way. To remove the child restraint, just unbuckle the vehicle's safety belt and let it is in a risk...
Owner's Manual - Page 79
... outside. You will see a red area on the armrest. To unlock the doors, press the raised area next to lock all the doors at once.
Remove the ignition key and press LOCK to the key symbol.
2-8
Power Door Locks (If Equipped)
You can also use the keyless entry system, if you...
Owner's Manual - Page 80
... the doors when the vehicle speed is greater than 15 mph (24 km/h) for
two seconds, and then unlock the door(s) once the key is removed from the ignition. You are not pressed while in the programming mode, the auto lock/unlock setting will not be able to do this, you...
Owner's Manual - Page 84
... ring hole. The door locks should cycle to a signal it has been sent previously. Remove the bottom by this system. To resynchronize your transmitter, stand close to your dealer for ... the coin. 2. This prevents anyone from recording and playing back the signal from the transmitter. Remove and replace the battery with a three volt CR2032 or equivalent battery, positive (+) side up. ...
Owner's Manual - Page 85
... must close the driver's door.
2-14 Follow these steps if you want to open the driver's front door. Remove both retaining cables. Then, push forward so the larger part of the door panel to remove the tailgate: 1. Pull the end over the bolt.
Third Door (Extended Cab) (If Equipped)
Tailgate
You can...
Owner's Manual - Page 86
... vehicle and open the driver's door, you'll hear a chime reminding you at the left side and then move the tailgate to the left to remove your transmission.
If you can make it . so don't do this. Reverse the procedure to reinstall. Key in some cities. Always do it impossible to...
Owner's Manual - Page 90
... be able to OFF. This could drain your battery and prevent you . CAUTION:
ACCESSORY (A): This position lets you need to turn the key only to remove your ignition, steering wheel and transmission. You will lock the steering column and result in the ACCESSORY position for long periods of ability to five...
Owner's Manual - Page 304
Install the two retaining clips.
2. Put the headlamp assembly back into the bulb assembly and reinstall it from the headlamp assembly. 6. Remove the black retainer clips by turning it clockwise until it is tight. 7. Plug in the headlamp assembly by lifting up. 3. Open the hood.
5. Headlamps
One-Piece Composite Headlamp System 1. Put the new bulb into...
Owner's Manual - Page 305
... retainer clips by turning it clockwise until it is tight. 7. Turn the bulb assembly counterclockwise to remove it in the electrical connector. 8. Put the new bulb into the vehicle. Put the headlamp lens assembly back into the bulb assembly and reinstall it from the headlamp assembly. 2. Unplug the electrical connector 4. Two-Piece Composite Headlamp System 1.
Owner's Manual - Page 306
... the two retaining clips.
3. Two-Piece Front Turn Signal Lamp Assembly
1. Locate the locking tabs on the assembly. Pull the bulb straight out to remove it snaps into the vehicle.
The assembly will swing out.
3. Put the headlamp assembly back into place. 5. Remove the headlamp assembly as shown under "One-Piece Composite Headlamp System" earlier in this...
Owner's Manual - Page 307
... it snaps into the lamp assembly and turn it clockwise until it into the vehicle. Install the two retaining clips.
1. Pull the bulb straight out to remove it from the socket. 5. To reinstall the assembly, snap the outboard end of the lamp assembly back into place. 8. Then swing the assembly in and snap it is...
Owner's Manual - Page 308
... feed wire is provided along the driver's side rear frame. Push the tab in the cap or camper. 3. Reinstall the assembly.
Install a new bulb. 5. Pull the bulb out. 6. Push the new bulb into the assembly and turn the socket. 5. Remove the bulb. Put the socket into the socket. 7. Close the tailgate.
6-43 Taillamps
1. 3.
Owner's Manual - Page 309
... Wiper Blade Replacement
Windshield wiper blades should be inspected at one end that are locked by bottom claws of the blade assembly. NOTICE:
Use care when removing or installing a blade assembly. Arm Hook
2.
A. Arm Assembly C. Blade Pivot E. Remove the insert from the blade assembly. The insert has two notches at least twice a year for more information.
Owner's Manual - Page 401
....
8-7 Canadian Roadside Assistance
Vehicles purchased in Canada have any reasonable trip interruption expenses (up to retail and retail lease customers operating 2001 GMC light duty trucks for the following information when your
GMC truck
D Mileage of vehicle and description of problem
Roadside Assistance is received:
D Vehicle Identification Number (VIN) D Name and home address...
Owner's Manual - Page 406
... service information needed to Helm, Incorporated (address below.)
CURRENT PUBLICATIONS FOR 2001 GMC
SERVICE MANUALS Service Manuals have the diagnosis and repair information on the World...Service Publications are written directly for current and past model GM vehicles. 2001 GMC SERVICE PUBLICATIONS ORDERING INFORMATION
The following publications covering the operation and servicing of...
Owner's Manual - Page 407
...make checks payable in U.S. Box 07130 S Detroit, MI 48207 For purchases outside U.S.A.
AREA CODE
GM-GMC-ORD99
*(Prices are to Canadian Customers: All listed prices are quoted in U.S. Canadian residents are subject to... MATERIAL
Michigan Purchasers add 6% sales tax U.S. VEHICLE MODEL NAME YEAR 2001 2001 2001 2001 QTY. Allow ample time for credit without incurring obligation.
