Frigidaire GLTF2940FS Support Question
Frigidaire GLTF2940FS Support Question
Find answers below for this question about Frigidaire GLTF2940FS - 3.5 cu. Ft. Front Load Washer.Need a Frigidaire GLTF2940FS manual? We have 3 online manuals for this item!
Question posted by nicolemnelson2008 on July 26th, 2015
The Video Was Very Helpful But Said Nothing Regarding Code E20. What Do This
code mean??
Current Answers
Answer #1: Posted by TommyKervz on July 27th, 2015 1:42 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,843
Member since:
January 10th, 2013 Points: 17,776,843
Please the link below for a possible solution.
Related Frigidaire GLTF2940FS Manual Pages
Use and Care Guide - Page 2
..., property damage or damage to the washer. All safety messages will be killed or seriously injured if you will help prevent potential negative consequences for ease of...washer serial plate located at the top, inside of the door and the Operating Instructions included with your household waste disposal service or the shop where you to reduce the chance of this appliance. These words mean...
Use and Care Guide - Page 3
... not combine laundry products for play on product labels. •Before the washer is equipped with these warnings could ignite or explode. •Under certain conditions, hydrogen gas may be removed. Do not mix chlorine bleach with local codes. Do not tamper with controls. - Do not install or store the washer where it becomes...
Use and Care Guide - Page 4
.... • The washer can cause serious injury or death. These mixtures can be tightly packed.
Washing Procedures
Note: The instructions appearing in the wash load. • Mend rips and tears to help balance the load. • Single heavy items such as toilet cleaners, rust removers, acid or products containing ammonia.
Sort laundry into loads that can...
Use and Care Guide - Page 5
... From time to time you may need to be adjusted for
front-loading washers to the maximum fill line (MAX.) for large loads. LIQUID BLEACH • If desired, measure out the recommended amount ...the
washer drum as it into the compartment labeled "Fabric Softener" and marked with this symbol . • Fill to the right, then pulling the drawer out until it stops. • After adding laundry ...
Use and Care Guide - Page 6
...chlorine bleach with all instructions on the door or crawl inside the washer.
Do not store or place laundry products on an inside the home. Dangerous fumes may develop in items....)
7. For successful stain removal: • Remove stains promptly. • Determine the kind of each load.
This could ignite or explode. • Never use a prewash product, liquid detergent, or a paste...
Use and Care Guide - Page 7
Pretreat stain.
Press with warm iron until wax is dry, it may be impossible to back of an entire load, use rust remover safe for fabric. Pretreat or soak in oxygen bleach and hot water before washing.
Wash using product containing enzymes.
For heavy stains ...
Use and Care Guide - Page 8
... bleach. •Unfastened zippers, hooks,
buckles. •Rips, tears and broken threads. •Overloading the washer. •Degradation of detergent and hottest water safe for preparing and loading the wash load and adding chlorine bleach.
•Reduce load size.
Wash.
•Avoid overfilling detergent and fabric softener compartments of lint and scum, and fabric...
Use and Care Guide - Page 9
TO REFRESH OR CLEAN INSIDE OF THE WASHER: IMPORTANT: Do not load garments or other items in freezing temperatures, follow these parts with a...the washer when cleaning the inside cleaning • Remove items from hoses. 3. Close door. 5. Select the Drain/Spin cycle. Do not add wash load 9 Care and Cleaning
Figure 1 (Lock tab is visible only after storage, run WITHOUT a clothes load using...
Use and Care Guide - Page 10
... water temperature at least 30 psi (260 kPa). To prevent unnecessary noise and damage to help balance the load. • Dispenser drawer is a circuit overload, have not been removed during installation. Stop washer and redistribute wash load. Residue left in washer does not drain or drains slowly. Close drawer.
• Heavily soiled items. Wipe drum...
Operating Instructions - Page 1
.... "PAU" will not operate with the door open. Remove items from the washer when the cycle ends. Select Delay Start to delay the beginning of the cycle is selected. It has important safety and warranty information. Sort laundry into loads that cycle is interrupted during the entire wash cycle and the Door Lock...
Operating Instructions - Page 2
... as clean garments removed from luggage or storage containers, seasonal items from the washer and spin out the load.
Chlorine bleach wilt not be dispened in permanent damage. Warm/Cold, Hot/Cold... to the cycle wilt automatically be indicated when a cycle is selected in the washer.
Delicate This cycle provides 10 minutes of regular reversing tumble action are available with this...
Installation Instructions - Page 1
... and liquid in your building. · Clear the room, building or area of the National Electrical Code, ANSI/NFPA 70. Installation Instructions
Full Size Tumble Action Washers
Before beginning installation, carefully read these instructions near the washer after installation for future reference. Do not store or use any electrical switch; Follow the gas...
Installation Instructions - Page 2
...61 cm) Maximum height: 96 in. (244 cm)
accessible when the washer is properly installed and grounded in accordance with all local codes and ordinances or in the
96 in. (244 cm)
Max.
24 in... required. Properly grounded 3-prong receptacle to whether the appliance is
absence of your water pressure.
The washer MUST be 3/4 inch (1.9 cm) garden hose type so inlet hoses can advise you are in...
Installation Instructions - Page 4
... foot (1.27 cm per 30.5 cm). In an area exposed to protect the floor, lay the washer on it will come in . IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove or closet:
Sides, ...top and bottom of the floor may be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. The ambient temperature should never be necessary. Using a rug, blanket or piece...
Installation Instructions - Page 5
..., then tighten another 2/3 turn with pliers. Connect the inlet hose ends to prevent shipping damage. For pedestal installations, See additional installation instructions included with the washer in it's
final position, place a level on alternate corners and sides and feel for leaks. POWER CORD
2 hose clips
INSTALLATION
Leveling the...
Installation Instructions - Page 6
...to use accessories certified by the manufacturer could result in a location near the washer for future reference.
Cable Tie
REPLACEMENT PARTS If replacements parts are understood and ... the standpipe, inlet hose, laundry tub, etc. Good safe practice and caution MUST be used when elevating the washer for play. They contain valuable and helpful information that may be applied ...
Similar Questions
Strange Error Code
washing machine stopped working and has an error code...dr ?
washing machine stopped working and has an error code...dr ?
(Posted by shawnshafer 6 years ago)
My Front Load Washer Has Stopped Working With A Err57 Code
What does that code mean and how can I fix it?
What does that code mean and how can I fix it?
(Posted by pem01 9 years ago)
What Does E21 Error Code Mean On Fridgidaire Front Load
(Posted by Clevgerar 10 years ago)
What Does Error Code 18h Mean On Affinity Front Load Washer
(Posted by leewongal 10 years ago)
Error Code E20
error code e20 not spiining out water completely from clothes
error code e20 not spiining out water completely from clothes
(Posted by tjon4565 12 years ago)