Frigidaire GLET1031FS Support Question
Frigidaire GLET1031FS Support Question
Find answers below for this question about Frigidaire GLET1031FS - 3 cu. Ft. Laundry Center.Need a Frigidaire GLET1031FS manual? We have 5 online manuals for this item!
Question posted by mitz2bears on April 21st, 2016
Washer Stopped After Water Was Siphoned Out.
would a small pc of cloth cause the washer to not do anything at all. I tried to see if any other setting would work- like putting water in - but absolutly nothing works
Current Answers
Answer #1: Posted by Odin on April 21st, 2016 7:02 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,710
Member since:
April 10th, 2010 Points: 41,236,710
See http://bit.ly/1qZt38H and follow the last link (second column), or another link that reflects your situation.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire GLET1031FS Manual Pages
Complete Owner's Guide (English) - Page 3
...interior of the laundry center. Fire hazard, overheating and damage to catch fire.
• Do not put oily or greasy rags or clothing on top of... fumes which can cause serious injury, fire or death.
Do not store these areas could result in a hot water system that could ignite...has not been used for such a period, before using the washer, turn on or near the dryer. Prevent Fire
• Do...
Complete Owner's Guide (English) - Page 4
....
4 Protect Children • Do not allow the tub to coast to a complete stop if it becomes overheated The washer will automatically restart after a cool down period of children is necessary when
the laundry center is moved to a new location, have it will stop before reaching into the drum. • A thermal limiter switch automatically turns off...
Complete Owner's Guide (English) - Page 5
... load size and soil level, and water hardness.
5. Sort laundry into loads that can be damaged. Follow detergent manufacturer's directions.
Sort items by recommended water temperatures, wash time, and agitate/ ...heavy soil. Add it to wash water after a few minutes of fire, electrical shock, or injury to the wash tub before operating this washer.
1. Empty pockets. Place delicate ...
Complete Owner's Guide (English) - Page 6
... first. Replace dispenser by fabric care label. The washer will remain locked for 2-3 minutes after the tub stops spinning. • To open the locked lid. Remove items when the cycle is completed.
Select cycle and settings according to release. Do not overload the washer. • Do not put thumb into position. NOTE: To separate cap...
Complete Owner's Guide (English) - Page 7
... those listed below. • Read and comply with a paste of stain, then follow recommended treatment in hottest water safe for fabric. Replace towels under stain frequently. Wash using bleach safe for fabric. Washing may set stains. • Check care label instructions for treatments to remove. Badly mildewed fabrics may be removed. Mud...
Complete Owner's Guide (English) - Page 8
...caused by soil level and color. •Use correct amount of detergent, hottest
water and bleach safe for fabric •Use correct amount of detergent and hottest water safe for fabric. Then start washer.
•Add fabric softener to wash water... tears and broken threads. •Overloading the washer. •Degradation of detergent, water
•Undissolved detergent has left in a plastic...
Complete Owner's Guide (English) - Page 9
...set dryer controls (some stains. Prepare items for easy removal.
2. If an item sheds lint, turn cycle selector to 1/2 full. Load the dryer. • The average load will always stop before drying. • Place small items in a mesh bag. Hold for your specific
model. • Always read and follow fabric care labels and laundry...for stains which can cause wrinkling, shrinkage, ...
Complete Owner's Guide (English) - Page 10
...Fluff (no heat) temperature setting for items being dried. If lint screen is not in washer or dryer to reduce
electricity...attached to fabric.)
Shrinking
•Pilling is opened to small loads for 5-10 minutes.
•Remove items immediately... permanent press fabrics. Lint
• Overloading. • Overdrying causes static
•Reduce load size and rewash using the drying rack...
Complete Owner's Guide (English) - Page 11
... the Washer • Remove items from tape or labels with a mixture of lint build-up . Remove this build-up in the hoses. • Clean the cabinet with mild soap and water. Rinse thoroughly with a damp cloth. Or, touch residue with the sticky side of the tape or label. • Before moving the laundry center, place...
Complete Owner's Guide (English) - Page 12
... setting. OCCURRENCE
POSSIBLE CAUSE
SOLUTION
WASHER -
If noise continues after storage, run empty washer through
a complete cycle using detergent. Belt buckles and metal fasteners are normal in or connection may be needed.
rubber odor.
Laundry center is a circuit overload, have not been See INSTALLATION INSTRUCTIONS for removing
removed during installation. Stop washer...
Complete Owner's Guide (English) - Page 13
...Safety lid lock must be unable to cold water faucet. Shake or brush excess dirt and sand from laundry center. See Washing Procedures.
Straighten hoses. Water temperature should not be at nearby faucet with candy or meat thermometer. Contact plumber if necessary. SOLUTION
Move indicator clockwise slightly.
Washer won't spin.
Straighten drain hose.
Heavily soiled...
Installation Instructions (All Languages) - Page 3
... center's water inlet. NOTE: For installations requiring a longer drain hose, have a qualified technician install a longer hose, PIN 134049201, available from the neutral, (2) use with local codes and (3) connect neutral terminal or lead to branch circuit neutral in the floor, install a siphon break kit, available from plug. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not under...
Installation Instructions (All Languages) - Page 4
...52 cm) of water column, measured with ..., clogging the duct work and creating a fire...ft. (17.07 m)
42 ft. (12.8 m)
1
46 ft. (14.02 m)
36 ft. (10.97 m)
2
34 ft. (10.36 m)
28 ft. (8.53 m)
3
32 ft. (9.75 m)
18 ft...clothes dryer must be exhausted into the laundry area.
All male duct pipe fittings MUST be expelled into a chimney, a wall, a ceiling, or any area of the home can cause...
Installation Instructions (All Languages) - Page 5
... inch (10.16 cm) diameter duct and a 90° elbow. LOCATION OF YOUR LAUNDRY CENTER
DO NOT INSTALL YOUR LAUNDRY CENTER: 1.In an area exposed to dripping water or outside wall. Floor MUST be installed directly through the outside weather conditions. 2.In an...(0 CM)
1 IN. (2.54 CM)
0 IN. (0 CM)
60 SQ. CM)
DRYER
Closet Door
60 SQ. IN. (387.1 SQ. C M)
WASHER
60 SQ. IN. (387.1 SQ. CM)
5
Installation Instructions (All Languages) - Page 6
... CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR)
DRAIN OUTLET (REAR)
GAS SUPPLY PIPE (REAR)
5 ¼ IN. (13.33 CM)
43 IN. (109.22 CM)
41 ¼ IN (104.77 CM...
Installation Instructions (All Languages) - Page 7
... foam dryer support pads. (d) inlet hoses. (e ) enclosure package.
5. NOTE: If the laundry center is to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR...structure.
3.Refer to prevent water syphoning. Using a ratchet with no obstructions. Remove: (a) foam tub blocking pad. (b) tape from the center of the washer, remove the wire shipping ...
Installation Instructions (All Languages) - Page 10
... CROSS THREAD OR OVERTIGHTEN THESE CONNECTIONS.
4.
Gently set aside.
7. NOTE: Keep the leg extension at both connections.
5. Remove the panel and set the laundry center back down to ensure the laundry center is the HOT water faucet and carefully connect the bottom inlet hose to the corrosive action of the washer. Remove the shipping cap from the hot...
Installation Instructions (All Languages) - Page 11
...work.
If this laundry center are not meant to ensure the power is unpacked. Run the washer and dryer though a cycle. NOTE: A wiring diagram is clear and free from combustible materials, gasoline, and other literature included with rugs, bedspreads, or plastic sheets can cause... replacement parts are understood and practiced as boxes, clothing, etc.) obstructs the flow of air. Children...
Operating Instructions (Operating Instructions) - Page 3
... the washer.
10.
P/N 137227300 (0905) LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS
WASH/RINSE TEMPERATURE
COLD
WARM WARM
*
COLD
•
COLD COLD
HOT COLD
WARM COLD
LOAD SLIOZEAD(WSAIZTER LEVEL)
SMALL (LOW...washer will not fill with water, agitate or spin when the lid is open, and will only start washer. Whites Cycle
This cycle provides up to the desired setting. Add laundry...
Operating Instructions (Operating Instructions) - Page 4
.... Undersize loads waste energy.
• When small wash loads cannot be enough water in the tub for items to select the wash water temperature suitable for the fiber content and soil ...the tub.
Cycle Settings
For best results, follow washing instructions on fabric care labels.
Use cold water for lightly soiled items and rinsing.
• Operate the washer in cold water. Prewash provides ...
Similar Questions
What Is The Capacity Of Washer In Cu.ft
(Posted by Anonymous-150685 9 years ago)
What Is The Cu Ft Size Of My Washer
i am tying o find out the cu ft size of my washer dryer
i am tying o find out the cu ft size of my washer dryer
(Posted by kookiaz2 9 years ago)
Washer/dryer No Longer Function
after becoming unbalanced the washer and dryer stopped working Suggestions?
after becoming unbalanced the washer and dryer stopped working Suggestions?
(Posted by kim59131 9 years ago)
Water Drains At Final Spin On To Floor With Burnt Rubber Odor
(Posted by Jla625 11 years ago)