Frigidaire GLEQ2152EE Support Question
Frigidaire GLEQ2152EE Support Question
Find answers below for this question about Frigidaire GLEQ2152EE - 27" Front-Load Electric Dryer.Need a Frigidaire GLEQ2152EE manual? We have 4 online manuals for this item!
Question posted by mino91 on February 16th, 2011
Dryer Is Not Drying
My frigidaire gallery GLEQ2152EEO runs but only for a few minutes. While running it does not dry clothes and when it stops the lights on the panel light up and flash and the section which displays the time for the cycle reads "AD". What could the problem be? Is it something my husband can fix or do we need to call a repairman?
Current Answers
Related Frigidaire GLEQ2152EE Manual Pages
Use and Care Manual - Page 2
...dryer • Operation
serial plate located of the left side of the door opening. Your dryer may not be used when elevating the washer for the recycling of electrical...Important Safety Instructions...2-4 Drying Procedures...4 Features...5 Care and Cleaning...5-6 Common Drying Problems...6 Avoid Service ...where you don't follow instructions. Failure to light any appliance. • Do not touch ...
Use and Care Manual - Page 3
... could cause a load to catch fire. • Do not dry articles containing rubber, plastic or similar materials such as bras, galoshes, bath mats, rugs, bibs, baby pants, plastic bags and pillows that may occur. A clothes dryer produces combustible lint. The dryer must be connected to an exhaust outdoors. Do not stack or place laundry or throw...
Use and Care Manual - Page 4
... not overload dryer.
• When drying large items, dry only 2 or 3 at a time. Prepare items for drying. • Dry items of fire, electrical shock, or injury to prevent tangling and for better drying, less wrinkling, and to resume the cycle. 6. Hazardous fumes or electrical shock could result in the same load. • Separate dark items from light-colored items. Separate...
Use and Care Manual - Page 5
... listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to persons or property, comply with a damp cloth and a mild liquid household cleanser.
Insert drying rack into the dryer drum. Inside • Clean the lint screen after every load. Refer to the dryer.
Do not operate the dryer without the lint screen in place.
•...
Use and Care Manual - Page 6
... collars and cuffs. • Turn items inside out to small loads for proper tumbling.
• Some "silk-like" fabrics should be air dried. • Use proper drying temperature. • Place fabric softener sheet on top of dryer at medium or low heat for 5-10 minutes.
• Remove items immediately. Hang or fold.
• Do not...
Use and Care Manual - Page 7
... the result of the Foreign objects such as cycle ends. LP gas supply tank is not covered by the warranty.
7 Electric dryer is open (gas models). Drying procedures have not been met. See Drying Procedures.
Scratching or chipping of defective workmanship or materials in or plug may be loose. Always remove foreign objects from...
Use and Care Manual - Page 8
... obtained from your best interest to obtain and keep all costs for service and parts under this appliance that prove to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other than authorized service companies; Products used and maintained in your original date of...
Technical Data Sheet - Page 1
...electric models and 120V on electronic control. Clear code, exit mode and start dryer. Dryer...lights would be accurate in the code stands for 6 seconds to confirm in the digital
display. The four indicator lights and the START indicator light start dryer. The control will flash...Display Models, the four indicator lights would blink four times and the START indicator light would extend dry...
Technical Data Sheet - Page 2
... each setting. Dryer will make the DAMP LED come on . heat source is displayed.**
**For models that do not have a digit display, the MORE DRY LED should light.
5 turns: Drive motor runs; Immediately after,...and placing a finger on . When the Pause Cancel button is off . The number of flashes of the temperature as follows.
The control will enter test mode, the buzzer will sound 3...
Installation Instructions - Page 2
... or closed loop connectors and marked for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
OUTLET RECEPTACLE - Restricted air flow will be exhausted into the laundry area. The dryer must be located so the power supply cord is accessible when the dryer is in U.S.A.
A clothes dryer produces combustible lint. All male duct pipe fittings...
Installation Instructions - Page 3
... REQUIREMENTS
Replace copper connecting pipe that will cause an increase in vent restriction. • Running the exhaust system through a roof may expose the exhaust
system to the gas supply line.... 4.
Your dryer needs the space around it will come in the absence of 1/2 inch (1.27 cm) pipe....is required.
Read the measurement on electric dryers, exhausting can be
exhausted outdoors....
Installation Instructions - Page 4
... to clear knobs (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to...
Installation Instructions - Page 5
... last two screws.
3. Metal ducting must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that secure the door hinges to the dryer front panel (see below). This dryer MUST be 4 inches (10.16 cm) in the open screw holes on its left side of the...
Installation Instructions - Page 6
...the door opening using the four screws removed in Step 4. 9. Be careful to the dryer front panel. Remove the two handle screws and remove the handle by removing the handle screws in the... 4 & 5
Step 7 Retain the plugs for use later. Install the plugs from turning.
Open the dryer door. Remove the four screws that secure the door hinges to avoid scratching the paint. 5. Lay the door...
Installation Instructions - Page 7
... provided with the appliance. Reinstall the terminal block cover.
7 GROUNDING REQUIREMENTS
Non Canadian ELECTRIC Dryer
GAS Dryer
2. Thread a U.L. Tighten both screws securely. Some extension cords are specific requirements for the length power cord to whether the appliance is properly grounded. The laundry center is a copper wired power cord with a three-prong (grounding) plug for...
Installation Instructions - Page 8
... the
top panel. Failure to be applied when installing, operating and maintaining any appliance.
8 Apply an approved thread sealer that nothing (such as boxes, clothing, etc.) obstructs the flow of air. NOTE: Check to disconnection when servicing controls. The instructions in your dryer, call 1-800-944-9044, or visit our website, www.frigidaire.com...
Operating Instructions - Page 1
... a reminder. The signal will beep and the status lights will flash, but the original cycle will be dried. Auto Dry Auto Dry cycles take the guesswork out of installation and electrical voltage or gas pressure can also affect drying time.
It has important safety and warranty information.
Load the dryer. The dryer uses sensing bars to begin the cycle. •...
Operating Instructions - Page 2
.... You will not light.
If a temperature, dryness level or option is recommended for a cycle, the indicator will not be displayed alternately with every cycle. High heat is not recommended for sturdy fabrics.
or to freshen clothing, pillows or blankets; Note: Using No Heat in long drying times and /or wet loads at the end of...
Operating Instructions - Page 3
...**
Quick 30 minutes
*
Bulky 45 minutes
*
Timed Dry 15 to 90 minutes
*
More Dry
Normal Dry
*
*
*
Less Dry
*
Damp Dry Options
Shrink Guard
Press Saver
Cycle Signal * Factory
setting
*
Available settings
*
*
*
** Not recommended
*
*
*
*
*
*
*** Estimated cycle duration is based on normal dryness level and factory settings. PN 134431300D (0801)
DRYER SETTINGS CHART
AVAILABLE...
Similar Questions
Need To Fix Ed68 Code On My Model Gleq2152ee0 Front Load Dryer
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
need to fix e68 code on my model GLEQ2152EE0 FRONT LOAD DRYER
(Posted by Ledesma2020 3 years ago)
Trouble Restarting Electric Dryer
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
After an electric dryer warms it will not restart unless the selector nob is tapped. Which part need...
(Posted by jrpetrick 5 years ago)
How To Solve This Problem Dryer Stop Drying Then The Light Start Blinking
dryer stop drying then it start blinking then u have to start it over then it keep doing it
dryer stop drying then it start blinking then u have to start it over then it keep doing it
(Posted by tsmith137211 8 years ago)
My Frigidaire Dryer #134431300d-0801 Just Quits And All Lights Flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
(Posted by bananalunajane 10 years ago)
Frigidaire Dryer Feq1442es0 Won't Start. 3 Beeps 3 Light Flashes At Same Time.
Frigidaire Dryer FEQ1442ES0 will not start. Gives 3 beeps with indicater lights flashing at the same...
Frigidaire Dryer FEQ1442ES0 will not start. Gives 3 beeps with indicater lights flashing at the same...
(Posted by Spicer 11 years ago)